Question about Cars & Trucks

1 Answer

I have a 2001 oldsmobile aurora 3.5 that is overheating when i drive it for 20 mi i changed the termostat, water pump , jug cap ,bleeded the radiator cleaned the condensor and still overheats when is 90 degres im out of ideas :(

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Greenhorn:

    A rookie expert who has answered 20 questions on their first day.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Contributor
  • 27 Answers

Are the cooling fans coming on?

Posted on Jul 09, 2013

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 3 Answers

SOURCE: 1990 Subaru Liberty Overheats

Hi,

I had the same problem with my 1993 Liberty LX. Remove the thermostat (located inside bottom radiator hose engine connection - take the connection off and thermostat is inside). Reassemble (minus thermostat), reconnect bottom hose. Slowly (very, very slowly) refill the radiator and remove the bleed plug ( located beside the top hose connection to the radiator - a black square plug with a phillips head cross in the middle). When the radiator is full and clear water (no air bubbles) is coming out of the bleed point, replace the bleed plug and then the radiator cap.

Run the engine for five minutes (approx) or until normal engine temperature is reached. Allow the engine to cool down and recheck the water level - fill if necessary ensuring that the bleed plug is open and clear water is coming out of that point. Replace Bleed plug and then radiator cap. Run engine for five minutes (approx) and then test dive. If the engine overheats keep filling the radiator until there are no air bubbles coming from out of the bleed point.

This fixed my overheating problem. Good luck and safe motoring.

Posted on Sep 21, 2008

  • 1089 Answers

SOURCE: 95 honda civic lx overheating

COULD BE COOLANT SENSOR,HEAD GASKET,CHECK THE TIMING,THE PROPER MIXTURE OF COOLANT,WATER PUMP.DID YOU HAVE IT CHECKED OUT?ANY LEAKS?HEAT WORK WITH FAN?

Posted on Jan 08, 2009

  • 10 Answers

SOURCE: How do I replace the water pump in a 96 Oldsmobile Aurora?

the water pump is driven by a small belt at the back of the front cylinder head.  the pump needs to be removed with a special socket. From what i recall the pump has tabs on it that lock into the housing & i think its reverse thread / turn right to remove the pump instead of left 

Posted on Feb 01, 2009

  • 1 Answer

SOURCE: ford ranger truck overheating

I have had this happen with my ranger. Changed everything I could to try to fix the over heating. It turned out that I had a small leak in my head gasket and it was allowing exsaust gas to go into the cooling system witch was over pressurizing it. Also the air from the exsaust will heat up much faster than liquid making your thermostat to read hot and will not be able to blow hot air in the cab because there is no liquid going to the heater core. This happened to me when my blet came off and I tryed to make it home. If you had it over heat for a long peirod of time it may have ripped the head gasket.

Posted on Feb 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a 1998 oldsmobile aurora that is overheating. no leaks, runs fine then temp goes up and coolant boils up to the resevoir cap and comes out around the cap. replaced thermostat. fan comes on


Try changing radiator cap if there is no water in the oil it is not a head gasket could be system just needs a flush. It could also be the water pump is not pumping well try the cap first.

May 30, 2014 | 1999 Oldsmobile Aurora

1 Answer

How to change water pump on 2001 olds aurora 3.5


does anyone have experience changing a water pump on a 2001 ...

https://answers.yahoo.com/question/index?qid...
Aug 13, 2008 - aurora.................good luck. if u got the "short star" (3.5 dohc v6) good luck. if u got the 4.0........even better luck. happy trails. TonWon · 8 years ...

Aurora 4.0 Exhaust Leak and Water Pump Whine - YouTube

? 0:46
https://www.youtube.com/watch?v=5mjg_Ps1Ctg
Dec 13, 2012 - Uploaded by Brendan Doyle
Aurora 4.0 Exhaust Leak and Water Pump Whine. Brendan Doyle ... How to Install a Waterpump on a Cadillac Northstar engine. ...How to access spark plugs on a 2001 Oldsmobile Aurora 3.5L Engine - Duration: 3:19. Dennis ...

Oldsmobile Workshop Manuals > Aurora V6-214 3.5L VIN H ...

workshop-manuals.com/oldsmobile/aurora/...3.5l.../water_pump/.../page...
Oldsmobile Workshop Manuals > Engine, Cooling and Exhaust > Cooling System ...Aurora V6-214 3.5L VIN H SFI (2001) ... Install the new water pump gasket.

How to change water pump on 2001 olds aurora 3.5 - Fixya

www.fixya.com/.../t16902718-change_water_pump_2001_olds_aurora_...
Mar 4, 2013 - 4.0? It's not that hard to replace but you need a special socket to changeit ... The starter motor sits in the "valley" between the two bank of cylinders ...

Mar 04, 2013 | 2001 Oldsmobile Aurora

1 Answer

2001 Oldsmobile Silhouette...Overheating, changed the thermostat, no signs of leaking, and the oil looks fine. At idle it takes 20 minutes to max the temperature gauge (red) and while driving it take


Usually the problem with no heat and overheating is low coolant, thermostat, or a faulty water pump impeller.
The radiator may not be full of liquid coolant, or the pump may not be moving the coolant thru the block.

Feb 19, 2013 | 2001 Oldsmobile Silhouette

2 Answers

I have a 1999 oldsmobile intrigue with a 3.5 engine and it is overheating what might be the problem?


It's usually the thermostat, I woud pressure test the cap. It may need to be flushed. Are the fans working? Is there a 50/50 mix of anti-freeze

Sep 11, 2011 | 1999 Oldsmobile Intrigue

1 Answer

Overheating


OVERHEATING CAN BE CAUSE BY MANY THINGS LIKE FAULTY THERMOSTAT AND FAULTY RADIATOR PRESSURE CAP,TOO MUCH WATER IN COOLANT SYSTEM NEED 50 / 50 WATER AND ANTIFREEZE.LOOK FOR WATER PUMP WEEP HOLE LEAK, IF COOLANT LEAKING OUT WEEP HOLE WATER PUMP BAD NEED REPLACING.CHECK FOR LOW COOLANT LEVEL, YOUR RADIATOR OVERFLOW JUG SHOULD HAVE COOLANT AT THE FULL COLD MARK IF NOT KEEP ADDING COOLANT INTO COOLANT OVERFLOW JUG UNTIL COOLANT STOP DROPPING AND FULL COLD MARK, IF OVERFLOW COOLANT JUG WAS EMPTY RADIATOR IS LOW ON COOLANT.WHICH CAUSE AIR IN COOLANT SYSTEM KEEPING THE ENGINE COOLANT TEMPERATURE SENSOR FROM BEING SUBMERGE IN HOT COOLANT WHICH TURN ON THE COOLANT FANS.WHEN ENGINE COOLANT TEMPERATURE GET CERTAIN SET TEMPERATURE LIKE 190 DEGREES THE PCM AND COOLANT SENSOR WILL TURN ON COOLANT FANS, IF VECHICLE OVERHEATING COOLANT FANS NOT WORKING EITHER YOU HAVE FAULTY ENGINE COOLANT TEMPERATURE SENSOR CHECK COOLANT FANS FUSE AND RELAYS. YOU CAN CODE SCAN CAR TO SEE IF YOU HAVE FAULTY PCM, FAULTY ENGINE COOLANT TEMPERATURE SENSOR OR FAULTY COOLANT FAN RELAY.IF COOLANT FAN AND ENGINE COOLANT TEMPERATURE SENSOR OKAY,YOU HAVE CORRECT COOLANT LEVEL IN COOLANT SYSTEM, THERMOSTAT AND RADIATOR PRESSURE CAP BEEN REPLACED, YOU COULD HAVE BLOWN HEAD GASKET CHECK ENGINE OIL LOOKS LIKE MILK SHAKE HEAD GASKET BLOWED ALSO WHEN HEAD GASKET BLOWED YOU CAN DRIVE CAR SHORT DISTANCE START OVERHEATING AND YOU LOOSE ENGINE POWER SUSPECT BLOWED HEAD GASKET.

Aug 04, 2011 | 1999 Oldsmobile Alero

1 Answer

1999 alero changed thermstat and the car will intermitantly overheat there seems to be no pattern.


BLEED AIR OUT COOLANT SYSTEM.WAIT UNTIL ENGINE COOL DOWN.REMOVE COOLANT OVER FLOW PRESSURE CAP.IF YOU HAVE 3.1 OR 3.4 ENGINE OPEN AIR BLEED SCREW ON WATER PUMP BYPASS HOSE.OPEN BLEED SCREW.WATCH COOLANT IN OVER FLOW AS YOU OPEN BLEED SCREW COOLANT WILL DROP IN OVER FLOW JUG. AS IT DROPS CLOSE BLEED SCREW ADD MORE COOLANT IN OVER FLOW JUG DO THIS UNTIL COOLANT LEVEL STAY AT COLD FULL MARK.WHEN DONE TIGHTEN BLEED SCREW DONT OVER TIGHTEN IT OR IT WILL STRIP OUT BREAK.CRANK CAR UP UNTIL THERMOSTAT OPEN THAT WHEN TOP RADIATOR HOSE GET HOT.WATCH COOLANT GAUGE,IF ENGINE TEMPERATURE RISES TURN OFF ENGINE WAIT UNTIL COOL.REMOVE RADIATOR PRESSURE CAP USING A RAG TO KEEP FROM GETTING HANDS SCALED.ADD MORE COOLANT IF NEEDED WHEN ENGINE COOLANT STOP DROPPING IN OVER FLOW JUG AND ENGINE DONT OVER HEAT AIR IS OUT OF COOLANT SYSTEM.

Sep 13, 2010 | 1999 Oldsmobile Alero

1 Answer

01 AURORA overheating after driving for 45mins to 1 hr. have


remove expansion tank cap (if fitted) take off the highest hose clip in the system and fill from there if you have an air lock in the system it will be obvious...after connecting back up, fill tank with neat anti freeze.(if tank is higher than hose, fill tank as air is expelled from the pipe.)

Jul 22, 2010 | 2001 Oldsmobile Aurora

1 Answer

Causes for overheating in a 1997 oldsmobile aurora


Do the fan(s) come on when hot? Blow out the radiator core with compressed air (from the engine side) to clear it of bugs and other debris. Make sure the radiator is full to the top (when cold) and check the radiator cap seal rubber and the over-flow tank and tubing for leakage. It's possible that the water pump impeller is slipping on it's shaft and not pumping water properly. Remove the thermostat temporarily and remove the radiator cap. Remove some of the water so that the level is somewhat below the cap bottom, then start the engine and watch for rapidly moving water. That will show that the pump is moving water well. Allow the engine to heat up and keep track of the water movement. Shut the engine off at low end of 'normal' on the temp gauge and replace the cap so that it doesn't blow out boiling water into your face. Replace the thermostat and top up the water when cold again.

Sep 06, 2009 | 1997 Oldsmobile Aurora

1 Answer

My 97 aurora overheats. Coolant level is fine, and the fans are working. is there a bleed valve for adding coolant or am i missing somthing else?


run the engine with the filler cap off to bleed the system, if that fails water pump or head gasket needs to be looked at.

May 14, 2009 | 1997 Oldsmobile Aurora

1 Answer

Overheating 2001 pontiac aztek


remove coolant.remove thermostat remove bottom radiator hose to water pump.put a empty container under the radiator.take a water hose put it where thermostat goes flush out the rust in block.watch the water as it come out the water pump .if stream water is small keep flushing until you get a study sream of clear water. also flush out radiator. lower water pressure dont flush radiator it with high water pressure you could burst it. make clean the over flow jug .make sure it not stopped up.put in a new thermostat and radiator pressure cap. fill radiator with half antifreeze and half water.bleed the coolant system.

Apr 05, 2009 | 2001 Pontiac Aztek

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

81 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...