SOURCE: Turn Signal Side Marker Bulb Replacement
I hve the same issue. I have replaced all the bulbs on the fron and back of the left side of the car and still the left front blinker does not blink.
SOURCE: how to replace front turn signal bulb
its easy. when the sinal flashes fast its just telling you a light is out. there might be 2 ways to fix this. open the truck look for the housing for the lights. now you may have to just turn the harnest where the wires are. or you just nee a phillps screw driver and unscrew the plastic cover off.
SOURCE: replace turn signal bulbs on 2001 corvette
Rears are simply remove the two screws on the lens and remove the tail light from the Vette, twist the connector to get to the bulb. Reverse instructions to install. For the fronts jack up the front, remove the small closeout panel under each side, push the brake cooling duct to one side and twist the bulb socket out of the light to get to the bulb. Reverse instructions to install.
[email protected]
SOURCE: Left turn signal blinks fast in rear and regular in front
the bulb is blown out. you need to change it. also if the bulb is not blown out or if the blinker still blink fast after you change the bulb then you have a ground problem. just remove that blinker light and check the ground wire on it. if you need to replace it and find a good groun on the car. you should be fine. this is all it is .
SOURCE: need replace turn signal bulb
YOU HAVE TO THE FRONT HEADLIGHT HOUSING TO REPLACE THE TURN SIGNAL BULB.
Testimonial: "thanks"
203 views
Usually answered in minutes!
×