I have a 1999 Nissan Quest with the ABS brake system. The yellow ABS light comes on and off intermittently. I start it up the one day and it is off. I start it the next time and the light on. I start it again and the light is off. Is there a way to pull codes out of the ABS control module without a scanner. If so, where is the connector and what pins do you bypass?
SOURCE: ABS Pulsating during a stop
I HAD ALMOST THE SAME PROBLEM .THIS CAR HAVE WAT SHOULD BE A RECALL WITH THE ABS SENSORS AT THE WHEEL .WHICH RUST BUIILDS ON THE SPINDLE AND THE BREAK THE SENSORS ..I END UP REPLACING THE BACK SENSORS AND THE SPINDLES .PLUS I WAITED SO LONG THAT THE ABS PUMP ALSO NEEDED REPLACEMENT ..GOT EXPENCIVE EVEN WITH DEALER EMPLOYEE DISCOUNT .I SPENT 1500 DOLLARS
SOURCE: 1999 nissan quest brake pad replacement
Remove wheel & tire,
remove 2 torx bolts that go from the inside to the outside of the vehicle. They are on the inner side of the brake caliper.
lift the caliper out of the rotor.
remove the brake pads.
To install, you must first squeeze the caliper piston back inot its bore. Do this slowly to prevent damage to the piston. You are forcing excess brake fluid back into the master cylinder reservoir. Slow constant pressure will get the job done. Use a large c clamp or a wooden hammer handel if that's all you have.
Fit the new brake pads in the calipers and slide the assembly back over the rotor.
install the 2 torx bolts, size 40? head I think.
You are done.
If rotors are scored bad, replace them too.
SOURCE: 2001 brake pad replacement 2001 nissan quest
The hard part is pressing the caliper piston abck into the caliper so you can get the new, thicker pads over the rotor. A large C Clamp works best.
SECTION 206-03: Front Disc Brake
2001 Villager Workshop Manual
REMOVAL AND INSTALLATION
Pads —Front Disc Brake
Removal
Installation
Caution. The outer pads are left and right. put left on driver side.
NOTE: It is necessary to fully retract the front disc brake caliper piston in the bore before installing the front disc brake pads.
Install the front disc brake pads.
SOURCE: nissan quest 1999 engine light codes P0325 &
P0325 is for the knock sensor.
P1105 is for the manifold absolute pressure sensor (MAP).
In either case diagnostic tests need to be performed to rule out faulty sensors or if something else is causing the sensors to give the computer inaccurate information.
SOURCE: my 1995 nissan pickup abs
hitting the breaks to hard just unhook the battery and reset the computer
533 views
Usually answered in minutes!
×