Gauges on the Dash went out

Dash lights and gauges should be located in the fuse box under the instrument panel.

limited information generic answer have vehicle scanned for trouble code ---have battery and alternator tested ---check connections--wires-belt

Yes there is it is in the main Fuse panel and should be marked instrument cluster or dash panel, dash lights,

Sounds like a wiring problem. The speedo is powered on the same circuit as the gauges, and the instrument lights are on the circuit with the tail lights but with a different fuse. So you are actually talking about 3 different circuits.

You really should not list your email and phone number online.

Someone will need to get a wiring diagram for the dash and check the circuits with a meter or a test light. By your husband making the instruments work by moving the fuses, it could be a problem with one of the contacts in the fuse box.

most likely needs a cluster.You can have yours rebuilt at Auto truck electronics for about 199.00

You need to check your main fuses under the hood first and then check them under the driver side dash board.

Checked Every fuse in the fuse box (no small task).This includes #4 - Power point Instrument Panel, #14 - Day time running lamps (auto lamps doesn't work nor does auto lock), #27 - ignition switch run feed, #35 - Instrument Cluster, #41 - Instrument Cluster, #42 - Delayed Accessory, #45 - Ignition switch run/start feed, #102 - Door locks body security module, #103 - Ignition switch, #110 - Ignition switch, & #116 - Ignition switch. But I also check all other ones as well, they all register OK. AC panel & radio work. Turn signals work. Mileage does not work, trip computer does. So, basically, everything works except auto head-lights, auto locks, and the dash cluster (no MPH, RPM, mileage display, Fuel, Temp, Tran Temp, and Oil Pressure).

check the ipc bfc acc fuse make sure fuses are not loose.

Could be lose connection on the back of the instrument cluster ,which means you would need to pull it out of the vehicle . Check pin fit to instrument cluster . for the B+ voltage suppy an ground connection's .
You said autozone - Tried to have auto zone diagnose from inside the car, came up with no codes. That's in the PCM - engine computer . There scan tool will not communicate with the instrument cluster ,which is also a computer in it's self. Need a factory scan tool to check instrument cluster.
Speedometer and/or Odometer Inaccurate
Step
Action
Value(s)
Yes
No
Important: A short to ground will cause an open fuse(s). Before performing this diagnostic procedure, inspect the fuse(s) for an open.
1
Did you perform the Instrument Cluster System Check?
--
Go to Step 2
Go to Instrument Cluster System Check
2
Turn the ignition switch to the ON position.
With the scan tool select Instrument Panel Cluster, Special Functions, Instrument Panel Cluster (IPC) gauges.
Perform the Speed Gauge Sweep Test.
Does the speedometer complete a full sweep when commanded?
--
Go to Powertrain On Board Diagnostic (OBD) System Check in Engine Controls
Go to Step 3
3
Replace the instrument cluster. Refer to Instrument Cluster Replacement .
Did you complete the repair?
--
Go to Instrument Cluster System Check
--
With a scan tool select the instrument panel cluster, data display, gear status.
Monitor the gear range status.
Move the gear lever through each gear.
Does the scan tool display the correct gear selected?
Your best bet , take it to a qualified repair shop .