How do i replace a check engine light bulb in 1999 kia sportage

Marvin

• 85242 Answers
• Posted on Aug 19, 2008

SOURCE: check gngine light

Ok I think you meant code P0171, this means the fuel trim is always lean, you need to check for a engine vacum leak, maybe a cut or damaged PCV hose or any other hose that is in the vaccum system, I have read other Kia owners (Kia Forums, you should join one) reports of this same code, most found it not to be the O2 sensor but a vacuum leak.

SOURCE: 1996 Nissan Maxima GXE Fail Smog Check Due To ECM System Failure

Working on one right now and hooked it up with a Snap On Solus scanner - It gives P0135 for 0/2 sensor bank 1 sensor 1. Check the 0/'2 sensor function and replace as necessary

Greg Bernett

• 2993 Answers
• Posted on Jul 26, 2009

SOURCE: 1999 kia sportage timing marks

Crankshaft match marks


Align marks on timing belt pulley and pump body.

Camshaft pulley alignment marks

1. Align marks on camshaft pulleys with alignment marks on seal plate.
2. Install timing belt. NOTE: No looseness should exist on the tension side and at the camshaft pulleys.
   
3. Loosen tensioner lock bolt.
4. Turn crankshaft 2 revolutions in direction of rotation and check that timing marks are still in alignment.
5. Tighten timing belt tension lock bolt to 27-38 ft lb (32-52 Nm).
6. Apply a force of 22 lbs to timing belt between camshaft sprockets.
7. Belt deflection should measure 0.30-0.33 in (7.5-8.5 mm)
8. NOTE: Replace tensioner spring if timing belt deflection is excessive.

1. Install lower timing belt cover.
2. Install upper timing belt cover.
3. Install power steering drive belt and adjust belt tension.
4. Install fan pulley.
5. Install generator drive belt and adjust belt tension.
6. Install A/C drive belt and adjust belt tension.
7. Install splash guard.
8. Install fan and fan shroud.
9. Install 4 fan bolts. Tighten to 24 ft lb (33 Nm).
10. Install fan shroud mounting bolts.
11. Install fresh air duct.
12. Connect hose to resonance chamber.
13. Connect battery negative cable.

SOURCE: Check Engine light code 1506

this code indicates under-speed error has ocurred.
sets when PCM detects idle speed is 100 RPM lowerthan expected for 14 sec while break pedal depressedand steering wheel is straight ahead.

possible causes: IAC valve failure,intake leak,throttle body failure,opens or shorts in wiring between IAC and PCM.

SOURCE: problem is a check engine light on with codes

those codes mean you have a problem with your evap there is a small leak in your evaporative system(fuel vapours)have the system checked