Cars & Trucks Logo

Related Topics:

Anonymous Posted on Mar 22, 2017

Changed gas 2001 bmw x5

I have a 2001 bmw x5 3.0, I was getting a bunch of codes, but to make story short. I finally got them all off, but still had a problem starting, so the last thing i was going to change was the fule filter which was done also. I changed gas from local station that I use prem. gas. then I thought if I use a better gas it would help then when to Shell and put their super prem. I came home right away pared it til next morning, and when i when to start it, it felt like it was just bogging down and i couldn't drive it without stopping and shutting down, Good thing i was close to home, anyway, that's when I put the fuel filter in and still having same results of it bogging down right away. Sorry so long, but thought i better say some of the story

1 Answer

xkikbxr

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Vice President:

An expert whose answer got voted for 100 times.

  • Cars & Trucks Master 788 Answers
  • Posted on Mar 22, 2017
xkikbxr
Cars & Trucks Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Vice President:

An expert whose answer got voted for 100 times.

Joined: Aug 13, 2010
Answers
788
Questions
0
Helped
228604
Points
2051

Does it bog down and die, sputter like it's running out of gas? It could be either your fuel pressure regulator or maybe you have a weak fuel pump.

5 Related Answers

autodr

autodr

  • 260 Answers
  • Posted on Nov 16, 2008

SOURCE: 1998 GMC Jimmy, bogged down, stalled and won't sart back up

does it have spark? you did verify fuel pump working properly? could it have a clogged converter? is the engine lite on?

Ad
emissionwiz

Marvin

  • 85242 Answers
  • Posted on Feb 09, 2009

SOURCE: Truck won't start right away when its hot.

U MAY HAVE A DEFECTIVE ENGINE COOLANT TEMP (ECT) SENSOR, U NEED A SCAN TOOL TO TEST THIS PART, THIS IS NOT THE SENDER FOR THE TEMP GUAGE THIS IS THE SENSOR THAT TELLS THE FUEL INJECTION COMPUTER HOW COLD OR HOT THE ENGINE IS, IF IT READS LOW THE SYSTEM WILL GET TO MUCH FUEL AND CAUSE A HARD START, DO U NOTICE ANY BLACK SMOKE WHEN IT FINALLY STARTS?

Anonymous

  • 54 Answers
  • Posted on Apr 24, 2009

SOURCE: 1991 Dodge Dakota v-8 would not start...

Not good...you did more than I would have done...sounds like its time to take it to a qualified repairman and have him diagnose the problem(s).

dieseldriver

  • 142 Answers
  • Posted on Sep 27, 2009

SOURCE: How to replace 2001 Chevy Taho fuel filter

the fuel filter is located down under the middle of the frame rail, on the drivers side,remove the lines from the filter, look out b/c some fuel will come out after diconecting the line. replace with the new filter make sure you get the "FLOW" "should be marked on the filter" pointing to the front of the car

A

Anonymous

  • Posted on Jun 19, 2013

SOURCE: changed gas, now wont start

Now you need to start fresh & have the car properly
diagnosed & the issue resolved at a repair shop.
You had a lot of codes & clearing them verse diagnosing
why they are there, is not a fix for anything.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Long story short codes read o2 sensor and oil sending light replaced both but the check engine light still on despite trying to clear codes with obd scanner

Suggest you take your vehicle to a qualified repair shop . Code's read O2 sensor an oil sending unit ?????? The code's , if you bothered to read service repair info. would have a bunch of diagnostic step's to do before it would say replace the sensor's . O2 sensors can set 4 or 5 different code's short to ground , short to power , open , hi or lo voltage etc...For a rookie following the diagnostic flow chart steps should be the most important procedure . Everybody an his brother with a code read think's he can fix his or her own vehicle . The sensor wasn't the problem , wiring , or PCM/ECM etc...
0helpful
1answer

BMW 2002 X5 Battery Drain

I am having the same problem with my 2002 X5. There is a motor or fan running behind the AC control panel on the dash and if I pull fuse 48 it stops and the battery doesn't drain. Still looking for the cause and solution so that I don't have to keep pulling and installin fuse 48. BMW garage suggested that it was the Final Stage Blower Resistor. I replaced this and no change. I hope someone has an answer that will help us both.
Jul 09, 2013 • 2005 BMW X5
0helpful
1answer

Changed gas, now wont start

Now you need to start fresh & have the car properly
diagnosed & the issue resolved at a repair shop.
You had a lot of codes & clearing them verse diagnosing
why they are there, is not a fix for anything.
1helpful
1answer

Bmw z3 2001 1.9 m43 engine, severe misfire at idle and through the rev range, stays the same, starting ok hot or cold, car in zimbabwe poor fuel quality but running ok before, gets infrequent use, replaced...

Make sure you dont run out of fuel, make sure 1/4 tank of gas is always there and the reason is that the fuel pump should be submerged in the gas all the time, if not then it will heat up and die.
It would also be good practic to change the fuel filter once a year, if there is no external filter then ad one in line filter for your safety.
As for the mis at idle it could be due to bent valve, burnt valve seat, vacume leak, head gasket minor leak, bad coil, shorted plug, bad gas. If the engine light is on which it should have because of the missing then I would like to know the codes.
3helpful
1answer

Rough Idling with severl codes

SOUND STOP UP FUEL FILTER.WHEN FUEL TANK GET LOW WHEN YOU PUT IN MORE GAS THE SEDIMENT IN BOTTOM OF FUEL TANK GET DISTURB GOES TO FUEL FILTER CLOG IT UP CAUSING LEAN CYLINDERS MISFIRE.
0helpful
1answer

I have a 540i 2001 bmw. while i was driving it yesterday it simply just shut off and would not start back up. Vehicle would crank, however would not start. It sounds like and acts like it's not getting...

The first thing you need to do is check the engine control module for fault codes through the OBD2 diagnostic port (requires an OBD2 code reader or scanner).
0helpful
1answer

What are some things that would make the check engine light come on in a 2001 mr2 spyder?

There could be so many things causing it. There is a sensor being tripped somewhere when you have a check engine light on. Could be simple like a loose gas cap, or could be an O2 Sensor, it could be one or more cylinders mis-firing (which is what mine was last week and changing the spark plugs did the trick for me). It could be a BUNCH of different things. I would take it to an auto parts store and ask them to run the code for you if you're "curious" but if you want it correclty diagnosed, take it to a dealer or good shop and have them run a full diagnostic on it. It's probably gonna run $75 to $100, but it's worth it. The auto chains sometimes run a code and give you a bunch of suggestions about parts to buy to fix it. They're most likely guessing and trying to get you to buy a bunch of parts. Hope this helps.
1helpful
1answer

Hi, my dad bought a BMW Z3 2002 and we can not access the code number for the radio. He bought the car in NYC and lives in Montreal, QC, Canada. We called the dealership, they gave us a code, but it does...

Greetings from Maryland. I have had issue with codes before myself, and it appears that ONLY dealers can provide proper coding, usually for free. Once they unlock and engage the radio for you they will give you a copy of the code for your use later. The odds are the NYC dealer provided a bad digit.
Apr 03, 2010 • 2001 BMW Z3
0helpful
1answer

Fuse#28 (5A, air-conditioner, blower, heater) keeps blowing on my 2001 BMW 325i. It kills the whole A/C, heater, blower console. I replaced my fuse twice but it's blown again after a few days. These...

maybe you have caused a short somewhere when replacing the overflow bottle... what i would do is run a 5 amp higher fuse NO MORE THEN 5 and if this blows then you have a bigger problem
1helpful
1answer

2001 Jimmy, kills when accelerating

sounds like you may hae an o2 sensor going bad. are there any check engine lights on?
Not finding what you are looking for?

65 views

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...