I want to replace the spark plug wires on my 1995 Buick Riviera with Super Charger. Is there a diagram with instructions that shows how to replace the spark plug wires? I can readily access the three spark plugs on the side of the engine that faces the front of the car. However, ready access to the spark plugs on the side of the engine facing the firewall is blocked. How do you reach that side of the engine? What special tools might be required? What peripheral equipment must I remove in order to gain access to replacing the plug wires on the back side of the engine?
I look forward to hearing your reply.
Regards,
Bill Belle Isle
[email protected]
417-353-6495
You need to drain some coolant. Loosen and disconnect water lines by the firewall- the ones in the way of your wire change. u need to get a diagram of the firing order of the engine so that those wires are correctly connected to the coil packs.
1,030 views
Usually answered in minutes!
Rivierapat: Thanks for the helpful advice.
BBelleIsle
ruedye2009:
Thanks for your advice. It is most appreciated.
Take one wire off at a time and replace with same length new wire. The drivers side on back of motor is the hardest in my opinion for lack of room. Always work on a cold car not warmed up to prevent burns from exhaust manifold.
wires put on wrong
×