Have no idea where to put these. I have a honda civic 2010 4dr. Fog light installation.
I have no experience to intall it, my boyfriend is car repair technician, so i can tell you some tips about it,
1,fog light mounted bumper in the hood
2,the fog light should be below the headlights
you should notice you local laws, if install the fog light is awful.
more information about car diagnostic, you can view my boyfriends E-shop:greebid.com
SOURCE: wipers stop in the midle
TSB (Technical Service Bulletin) #07071 -- WINDSHIELD WIPERS INTERMITTENTLY DO NOT PARK OR TURN OFF. Contact your dealer about this problem, it only affects 2006 models of your car. The fix is a new wiper motor I believe.
SOURCE: New Fog Lights Won't Work
check fuse 19 in the fuse blocks under the hood...there is also a relay for the fog lights
SOURCE: my 2000 honda civic engine light on code p1456
Hey I had the same code and I have a 2000 honda civic lx. My cousin
works at honda and drives a '96 honda civic and he has had that code
before on his car as well.
First thing he came up with was that the catalytic converter was
cracked. We checked mines, and lo and behold, that's what it was.
Look under your hood, and there should be a catalytic converter with a
sensor sticking out of it. It is connected to the exhaust manifold and
the sensor sticks out of the heat shield. Around the sensor, look for a
crack. If there's a crack, that's your problem.
SOURCE: how to change fog lights bulbs on my 2005 honda
To Install:
SOURCE: replace fog light bulb for 2006 Honda Odyssey
Touring Model
Use a wrench to remove the mounting bolt from the underbody through the hole in the splash shield.
Remove the fog light assembly from the bumper by pulling its inner edge first, then the whole assembly out of the bumper.
Remove the electrical connector from the bulb by pushing on the tab and pulling the connector down.
Remove the bulb from the fog light assembly by turning it one quarter turn counterclockwise.
Push the electrical connector onto the new bulb.
Turn on the fog lights to test the new bulb.
Reinstall the fog light assembly into the bumper. Tighten the mounting bolt.
Insert the new bulb into the assembly and turn it one-quarter turn clockwise to lock it in place.
Hope this helps you.
155 views
Usually answered in minutes!
×