2005 Chrysler Pacifica Logo
Posted on Mar 20, 2009

Where are the spark plugs on an 05 3.5 liter chrysler pacifica?

Where are the plugs on an 05 pacifica with a3.5 liter engine?

  • 2 more comments 
  • Anonymous Mar 21, 2009

    also lookin for the plugs on 2005 pacifica 3.5

  • Anonymous Mar 25, 2009

    Where are the spark plugs

  • Anonymous Apr 21, 2009

    I have the same problem, does anyone have specific disassembly instructions?

  • Anonymous Mar 20, 2014

    3.5 ENGINE. HEAD BOLT TORQUE SEQUENCE

×

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

Governor:

An expert whose answer got voted for 20 times.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

  • Contributor 2 Answers
  • Posted on Apr 09, 2009
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

Governor:

An expert whose answer got voted for 20 times.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Joined: Apr 09, 2009
Answers
2
Questions
1
Helped
5798
Points
35

Each of the plugs has it's own coil so they are under the swaure coil, you won't see traditional spark plug wires, look for sets of two wires headed for ~ 2.5 inch square block, three plugs can be seen in front of the large plastic air plenum, the uther three are underneath the plenum. Takes a real handy DIY person to do this as there are plenty of things to remove before the plenum comes off. Take good notes on how you remove things, I missed a lever that is part of the idle system and throught I messed things up bac\d, but when I located the correct place to attach the lever it was fine. Also be careful and not break a connector to the individual coils. I did, but was able to glue it together...

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How do I change the spark plugs on a 2007 Chrysler Pacifica?

the upper plenum will need to be removed on the 4.0 liter. Once the plenum is out of the way the coils can be removed and the plugs replaced.

on the 3.8 liter remove the plug wires from the plugs one at a time and replace that spark plug. Place the wire back on the plug as soon as it is installed and move on to the next.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

0helpful
1answer

I have a 2006 Chrysler Pacifica stuck in second gear will not

Not sure of your mileag but I had a LHS same engine, and when i had a spark plug go bad the computer limited the number of cylinders from firing. Engine would not allow full power so limits shifting.
did tune up replaced all spark plugs.
happened on LHS on 60,000 miles.
0helpful
1answer

Where are the spark plugs on an 2006 Chrysler Pacifica 3.5 liter

The spark plugs are located on the "back side" of the engine. To get to them (i.e., for plug replacement) is quite the ordeal -- requiring removal of a bunch of stuff.

I had the dealer do my plug replacement and it was a little spendy -- mostly b/c of all the labor involved.
0helpful
1answer

Installed timimg belt on a 05 Chrysler Pacifica 3.5L V6. Marks are aligned correctly with engine on TDC. But car starts like timing is off. Has no power. No codes present. Running out of ideas. Can so

I have had this problem on one car where the inside of the gear has detached from shaft , another where the distributor had mal alighned its weights
0helpful
1answer

Where are the spark plugs located on a 2007 chrysler pacifica?

Usually just above the pistons in the engine located under the hood.
1helpful
1answer

I'm trying to change my sparks plugs on a 2004 chysler pacifica. I wanted to how many spark plugs does my car have.

Your Pacifica 2004 has a 3.5L engine 6 cylinder, you will need six spark plug's, the spark plug gap is .050", make sure you gap the spark plug's before you install them, hope this was very helpful.
0helpful
1answer

How do you set the timing on the spark plugs for a 2005 chrysler pacifica

the 05 pacifica has veryable valve timing. no adjustment. hope this helps CJ
2helpful
1answer

How do you change Spark plugs for an 05 Chrysler Pacifica and where is it located?

is it a DOHC V6 if so ur in luck their is probably a plastic cover on the engine remove that to gain access to the valve cover on the front bank. The spark plugs should be right in the center of the valve cover you'll need to get a 6" or so extension to reach down into the cylinder head to remove them the same steps for the spark plugs on the back bank (closest to the fire wall).
0helpful
1answer
2helpful
1answer

Changing my spark plugs

you can do this at home without a lift because your spark plugs are on the top of your motor, but it is a pain. i have an 05. you need to go and get yourself a manual from autozone or advance auto for a 2004 and up charger. it has the 3.5l v6 in there as well and breaks it down on what you ahve to do to change them.
Not finding what you are looking for?

2,350 views

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...