I hit a deer and it busted my headlight assembly, I have a new one but was wondering what I need to do to install it, the whole assemble including the mount.
Should be as follows, First remove the plastic cover that goes from one side to the other. It has like 10 pop clips in it. Easiest way to get these out is to take a pair of end nippers and pull the center out then pull out the piece left there. This will make sure they are reusable. After thats out then there are two bolts, I think they are 12mm if I remimber right, They hold the headlight asembly in. After they are out then just give the assembly a good pop and release the metal clip that holds the bottom side of the assembly and the whole thing pops right out. Then twist and remove the bulb and your set to put the new one in in reverse order of course.
191 views
Usually answered in minutes!
Basically when I hit the deer the plastic cover or housing that holds the bulb broke completely off the the mount so I ordered the whole assemble and the mount. I'm not sure how to remove the mount, or should I say I'm afraid that I am going to brake something else removing it. I'm familiar with pulling the turning signal part out of the clip and changing the bulb, so I do know how to get to it. I saw a picture of the mount part somewhere and now can't find it again.
Go to collisionrepairadvice.com to get your answers quickly, Gives step by step procedures
hit a deer & replaced front end with all new parts. how to adjust head lights.
×