Wheels are ripped off back axle

Tires...rear suspension...rear alignment - in that order. I had a car with a really bad rear alignment that hop sideways every time you went over a bump in the road.

Look here V, reasonable mechanical knowledge is required to repair the engine.
2000 Daewoo Nubira engine diagram Google Search

I believe moog or someone makes a shim that goes between the
axle housing and the wheel bearing to adjust the alignment.
However,if the rear camber is out(the wheels tip in at the top)
The coil spring will also cause this,if the back end is lower than
the front ,bet on the springs.
Easy way to tell,,just jack the vehicle up by the rear bumper in the
center of the back.
only a few inches ,if the wheels "stand " back up the coil springs are at fault.
The Firestone guys are correct I think but that is only a "band-aid"
on the real problem.

i have 2000 deawoo nubira which has the power light blinking and sometimes the hold light on the dash too .
it has resulted in hard and noisy gear changing and shifting .
i change the tcm but to no avail .
help please

here you go

first swap to a front tyre to eliminate that issue


new bearing shouldn't be rumbling
to get the bearing square on and home
did you use a press to fit the bearing to the rear axle
or tube method ?

and did the seal kit have this nifty plastic seal fitter so axle didn;t rip the seal surface

here are all the codes avail for this car, on ewill work.
TRY THE CODES BELOW, most common codes used in models during the 1998-2001 model years.
4316
2152
4513
4362
1156
2145
3451
6361
5624
5241
3346
1165
3241
4524
5436

have the sway bar looked at in the back. if it is loose or broken it will sway. it is the bar connecting the two rear wheels. there are upgrade kits that offer a heavier bar. Also check rear tire pressure. the tires will roll out if too low a pressure is aboard.

usualy you will only have two tires spin at a time even in 4 lo or 4high. those tires are going to be diaginal from each other tipicly. now since your vehcle is equiped with quad drive it may employ a limited slip rear differential to help it along. however this only afects the rear axle. now you can test it by jacking your vehicle up and setting it on jack stands. one for each wheel onder the axle tube on a good solid (concreat or black top) flat surface. then have some one you know and trust to get in the car and put it into drive . now you can actualy see what wheels are spinning or not.now is were the limited slip comes in if you have one rear wheel spinning and the other is sitting still the limited slip will engage and start the other wheel spinning . now this may bang until the other wheel catches up (note that the faster the wheel is spinning the harder it is on your truck)now be very carfull stay away from the wheels tires and all other spinning parts it is a machine it can hurt you badly. but give it a try and it will answer your question. be safe hope this helps

change cylinder head gakate and check cylinder head that not bend from heat.