SOURCE: How to change a water pump on a 1999 Buick Century 3100?
the water pump on the 3.1 isnt to hard to change ...
SOURCE: 2000 buick lesabre - water pump replacement
first disconnect the battery then check how the serpentine belt is lined up so u can take it off and put back on. Then the pump should be on the side of the motor with 9or12 bolts there could be more! after taking out take razorblad and skrap the old gasket clean wipe of then put new gasket and pump back on dont over tighten the screws cuase the pump my be aluminum.
SOURCE: need to replace the water pump on a 93 buick regal
1-Remove serpentine fan belt
2-Remove pulley from front of water pump (10mm socket or wrench)
3-remove 6 bolts from water pump assembly (8mm socket or wrench)
4- replace water pump
5- reverse order to reassemble
SOURCE: 93 buick park ave Ultra. replacing water pump
Yes. Put a jack under the motor and remove 3 bolts from side of engine and the long center pivot bolt in mount and the 2 bolts that go top down into the frame and loosen the 2 bolts below mount. Jack up the motor until you can separate the mount, leaving the engine side in and removing the frame side. The engine side can be moved out of the way without completely removing.
Testimonial: "answered the question completely and thoroughly!"
SOURCE: install water pump on 3.1 buick engine
Visit the autozone.com website and register the car information. It doesn't cost anything and you will have access to an online repair manual for the car. The steps for replacing the water pump should be available there. It's a handy resource. Hope this helped and best wishes.
110 views
Usually answered in minutes!
×