I'm replacing my rear rotors on a 2005 grand Cherokee Laredo. I just want to know if the 05 grand Cherokee Laredo has loose fitting rear rotors or will I have to pull it as an assembly, consequently having to replace seals and possibly bearings?

The 2005 Jeep Grand Cherokee Laredo 3.7L typically has two oxygen (O2) sensors. One is located upstream (before the catalytic converter), often referred to as the pre-cat or upstream sensor, and the other is located downstream (after the catalytic converter), known as the post-cat or downstream sensor. In many cases, the upstream and downstream sensors are not the same and serve different purposes in monitoring and optimizing the air-fuel mixture and emissions.

Question edited for clarity.
Question moved from Television and Video category!

80 foot pounds for flange bolts

https://www.google.com/search?q=2011+Grand+Cherokee+Laredo+rear+drive+shaft+torque

..

No! Years between 1999-2004 are interchangeable!

Do you only buy one shoe if it is worn? replace all of them, unless you want to cheep changing them one at a time.

I would only use synthetic oil if there is a sticker on the engine compartment or the manual says that it is recommended.

I would use conventional oil unless otherwise specified.

Just have it changed every 3,000 mi. along with the filter and lube.

Try PB Blaster it is very good stuff. You can get it at most auto stores now, Kragen has it. If that doesnt work ,which it should.Then try pooring deisel on it.

Details complete in the Service Manual Jeep-WK-Grand-Cherokee-Section-05-Brakes

I hope help you with this and have a nice day (remember rated this help) Good luck.

You will need to remove the differential rear cover,drain fluid, remove wheel, brake drum, (rotor) . Unbolt center diff. pin, carefully remove (don't loose shims) push axle in remove lock keeper, then slide out axle, replace seal, put some grease on it, slide axle in reverse all to install.

1. Remove or disconnect the following:
   
   Rear wheel Brake caliper and rotor, if equipped Brake drum, if equipped Axle retainer nuts Axle shaft, seal and bearing assembly
   
2. Split the bearing retainer with a chisel and remove the retainer ring.
3. Press the bearing off the axle shaft.
4. Remove the axle seal and retaining plate.

Fig. Rear axle seal and bearing components-2002-05 exc. 2005 Grand Cherokee Hope this helps, please dont forget to rate my solution.



Lefty64

call jeep and give them last 9 digits of your vin and ask for three things -Differential Type,Gear ratio, and Track lock- They will give you
1) Dana 35 or 44
2) Gear Ratio 3.31 or 3.73
3) Track Lock - yes/no