SOURCE: 2001 Saturn L200 start and stall
Have you done any component testing? U1000 is a data issue, cant read pulses per minute. This is usually due to a defective crank sensor but you should do component testing first so you don't replace parts on random. Other reasons for this failure can be faulty ignition switch cam positioning sensor, Blown fuse, bad ground, or ECM.
SOURCE: lack of power
You should try doing a tune up change spark plugs, wires, pcv,and fuel filter.it's reasonable to assume that the rings and
valves (inside the engine) have become worn. Worn rings
and valves will cause the engine to have low compression
and low compression = weak power.
You may be curious as to why the engine's lack of power is
most evident when driving up a hill. Well, when a vehicle is
going up a hill, the engine is under more stress than when
driving on a flat road. Therefore, any wear in the rings/valves
will tend to be revealed - in the form of compression - when
the engine is under stress.
you will need to have a mechanic verify that the rings and/or
valves are indeed worn. Incidentally, this generally involves
what's known as a "wet compression test".
If the mechanic tells you he positively confirmed a worn ring
and/or worn valve condition, don't immediately authorize him
to do the work. Why? Because, this type of work is very
expensive and therefore you'll want to get several opinions
before jumping into anything. By the way, even though this
vehicle's high mileage strongly points to the above diagnosis,
it's possible the cause of this problem is something else.
For example, one of the electronic sensors that controls the
engine may have gone bad. hope this help have a nice day.
SOURCE: I have a Mitsubishi L200 2.5TD pick up and my
Take it to Autozone and ask them to pull the codes that are making the light stay on. They do it for free!! They will tell you what component is bad and sell it to you on the spot!! Pretty cool huh??
SOURCE: my mitsubishi l200 is leaning to one side. What
my mitsubishi pajero sport is leaning bad on the left hand side.what could be the problem???
SOURCE: Hi my electrical engineer disconect my battery's
Hi,
Following may be problem.Please check
1.Check the charge in the battery.
2.The terminals are properly and correctly connected.
Thanx
268 views
Usually answered in minutes!
×