Question about 1999 Chevrolet Venture

Open Question

Find iod fuse in a chevy venture

Hi i put the key in the hatch and it killed the van the van starts for sec and then dies

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Thermostat in a 2003 chevy venture van

the bottom boult is hard but can be done need to use a 10 or 12 stubby wrench and take a pry bar and lighty pry heat shild away to get bottom bolt dont need to take it out all the way just loosen and slide down

Posted on Aug 17, 2008

Ad
  • 1 Answer

SOURCE: Thermostat in a 2003 chevy venture van

no you dont need a special tool you have to take the throttle body off it makes it sooooooo much more simple.

Posted on Jan 27, 2009

billie17
  • 84 Answers

SOURCE: need to add 13-4a freon to my 2000 venture chevy van. Where is the pressure hose located?

passengers side under the hood.....by the firewall.....

Posted on May 12, 2009

Col Dempsey
  • 9 Answers

SOURCE: My 1998 Chevy 2500 vortec 4.3 v6 van starts and dies instantly

sounds like your engine immobiliser fuel cut off is activating.try taking battery teminals off,re-connect and re activate your immobiliser fob the usual way,**** it will re-set itself,& or your fob battery may need changing,it,s anti-theft cut off that is your problem.good luck.

Posted on Jul 28, 2009

  • 2 Answers

SOURCE: on my 1996 chevy blazer the hatch won't unlock

It should be number 2 in the fuse box but if you can still hear the motor when you push the button than you need to try and pull the top where the lock that holds the glass hatch pull the plastic far enough to get you hand in on the right side of the latch and you will find a lever that you should be able to push to your left I believe and that will release the glass hatch and than open the tail gate take off the plastic inside cover and unscrew the metal plate off of the inside of the tail gate and you will be looking for a blue plastic piece that supposed to be connected to the release motor and the latch if thats broken than you need to go to the auto wreckers find a blazer or jimmy from '95-'97 maybe all the way up to 2000 I believe and basicly do the same remove the blue clip from that one put it on yours and it should work and if the clip on your is broken dont try to glue it, it wont work I tryed everything to try and fix it on mine but you have to get another one once you find another clip it doesnt really take long but yea anyways I hope that helps you out let me know heres my email THUNDERSTRUCK_244@hotmail.com

Posted on Apr 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 chevy venture won't crank with key


The pk3 system has a sensor ring around the lock cylinder these go bad a relearn will not fix this because no security code is being sent to the pass key module.

Mar 23, 2014 | 2000 Chevrolet Venture

1 Answer

When i try to start my 98 chevy venture minivan it turns over for about 20 sec then dies unless i pump the gas when i turn it over. what are all the possibilities of what could be causing this to happ


Turning over is engine cranking, not running. I'm not sure I understood your post?
Use a gage and check proper fuel pressure, 3.4L engine, 41--47 psi.
Any applicable trouble codes? To check codes yourself, at the least you need an obd2 code reader.
I'd want to check if system is running rich or lean?

Apr 09, 2017 | 1998 Chevrolet Venture

1 Answer

How do you replace an ignition switch on a 2002 chevy venture van? I have a 2002 chevy venture van and have had a problem with the starter staying engaged. I replaced the started and it fixed it...


So what it only does it in park or neutral ! The vehicle starting circuit is only suppose to let it start in park or neutal . Park neutral safety switch won't allow B+ voltage to S terminal on the starter solenoid unless the vehicle is in park or neutral . It's probably the starter relay contacts stuck closed . You really should learn how it works before guessing as to the problem . Plus learn automotive electrical testing ! The ignition switch when turned to the start position send's a voltage signal to the PCM - engine computer .The PCM will energize the starter relay to crank the engine . PCM / ABS 10amp fuse in the I/P fuse box supply's B+ voltage to the park / neutral safety switch . When in park or neutral the B+ voltage goes through the control side of the relay to the PCM which will supply a ground to energize the starter relay .

Jun 17, 2017 | 2002 Chevrolet Venture Passanger

1 Answer

2001 chevy venture van and i cannot turn the key


While turning the key rotate the steering wheel left and right. If there is too much tension on the parking lock the key cannot be turned.

Feb 07, 2010 | 2001 Chevrolet Venture

3 Answers

2000 chevy venture doesnt start


check to make sure the security light is not on if it is the van will have spark but no injecter pulse the best way to solve this issue is to have the original igniton key and put it in the igniton in the run position and leave it on for 10 minutes then the light will flash then try to start the van

Jul 15, 2009 | 2001 Chevrolet Venture

1 Answer

Engine died while driving possible security system problem


is the security light flashing?it should go out when you turn key to run position after a few seconds..if it's staying on,check wiring near skim module(security system)small module under steering column covers..have seen broken wires near module..if not,try removing IOD fuse in underhood fuse block..this will reset skim module

May 14, 2009 | 2003 Dodge Grand Caravan AWD

1 Answer

Radio, Key auto door lock/opener, interior lights not working.


Most likely is a fuse. There is a fuse box at the end of the right side of the dash. Open front passenger door and there is a cover that says fuses on the end of dash. There is also a fuse box located under the hood at the right front of engine compartment. It should have a cover with a round knob in the middle of it .Unscrew the knob to remove cover.

Feb 18, 2009 | 2003 Chevrolet Venture Passanger

2 Answers

Lights dimming and brightening on 2000 Chevy Venture


2000 chevy venture run good but my lights flickers and have to jump. After I jump the van and put my meeter on the battery its reading 14.volts at idle. I can drive around to store cut the van off come out it starts fine leave it overnite and it don't started.

Nov 21, 2008 | 1999 Chevrolet Venture

Not finding what you are looking for?
1999 Chevrolet Venture Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...