Question about Cars & Trucks

Open Question

Replace sub-woofer and rear speakers on toyota sienna 2004

Posted by Anonymous on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: How do I replace the Rear Brake light bulb of 2001 Toyota Sienna?

I have a 2001 Sienna and have had to replace most of my tail light bulbs.

The bulbs that are mounted in the fender (wrap arounds) have acess panels in the van's interior that easily pop out and expose the back of the light assembly.

However, the bulbs that are found in the lift gate are a different matter. You have to remove the whole interior panel to the lift gate to expose the light assemblies. Go to your auto parts store and get a tool to help pop out the plastic retainers from the lift gates metal frame. Don't force the retainers out. Go slowly and gently so that you don't damage the interior panel. If you are really gentle you might even get to reuse the retainers.

Good luck!

Posted on Jul 01, 2009

Ad
  • 1986 Answers

SOURCE: Replacing RH Side view mirror on a 2006 Toyota Sienna

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door

Posted on Sep 29, 2009

  • 1 Answer

SOURCE: Replacing RH Side view mirror on a 2006 Toyota Sienna

I had to replace my passenger side mirror on my 2004 Sienna a while back. I took some pictures as I did it. Maybe this can help.http://time4nothing.blogspot.com/2008/03/fixing-04-sienna-passenger-side-mirror.html

Posted on Oct 04, 2009

  • 73 Answers

SOURCE: replace rear speaker grills on 2004 Toyota Camry

To remove that whole lid you need to remove the rear seat. the bottom half just pulls up and out and the back side pieces have two bolts down low, one on each side, then you can remove the rear seat back and that lid should be held in place with either bolts or push pins. The lid should come out and give you access to replace the speaker grills.

Posted on Mar 17, 2010

Testimonial: "Thank you very much. I'll give it a shot and let you know how it went."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The rear bumper cover came off how can I reinstall it


2000 Toyota Sienna rear Bumper cover replacement (1998 ...

? 3:40
https://www.youtube.com/watch?v=AY1BBdg3q74
Sep 20, 2013 - Uploaded by SergSpace
2000 Toyota Sienna rear Bumper cover replacement (1998-2003) .... Automotive Bumper Repair Specialist- How to repairyour plastic bumper cover ... Toyota Sienna Rear Shock Installation 2003, 2004, 2005, 2006 - Duration: ... 2015 Toyota Sienna XLE - Duration: 28:13. by MikesCarInfo 35,234 views.

Fixing My Mom's Prius: Loose Rear Bumper Cover - YouTube




Nov 29, 2015 | 2005 Toyota Sienna LE

1 Answer

How to remove 2006 toyota sienna rear bumper


I have written a detailed step-by-step tutorial on how to remove and replace the bumper of a 2004-2007 Toyota Sienna on my blog: John Fixes Stuff How to Remove the Front Bumper on 2004 2007 Toyota Sienna

Mar 19, 2013 | 2006 Toyota Sienna

1 Answer

How to remove 2004 sienna radiator


I have written step-by-step instructions on how to replace the radiator in a 2004-2007 Toyota Sienna, including removing the bumper: John Fixes Stuff How to Replace the Radiator on 2004 2007 Toyota Sienna

Apr 03, 2012 | 2004 Toyota Sienna

1 Answer

How to remove 2007 toyota sienna front bumper


I have written a step-by-step tutorial on how to remove (and replace) the bumper of a 2004-2007 Toyota Sienna on my blog: John Fixes Stuff How to Remove the Front Bumper on 2004 2007 Toyota Sienna

Feb 01, 2012 | 2007 Toyota Sienna

1 Answer

How to remove front bumper and grill from a 2005 Toyota Sienna


I have written up all the steps on how to remove the bumper of a 2004-2007 Toyota Sienna on my step-by-step tutorial on how to replace the radiator: John Fixes Stuff How to Replace the Radiator on 2004 2007 Toyota Sienna

Dec 19, 2011 | 2006 Toyota Sienna

1 Answer

My sub woofer stopped working, please tell me where it is located so i can check the speaker and also check if power is going to it thank you very much joe


The JBL premium sound system has a large woofer in the bottom of each door, a small mid-range speaker next to the woofer, & tweeters next to the front door windows in the corner, & two full-range speakers near the rear seats. The woofer (not sub-woofer) handles all the low end. You can test the woofer by turning the BASS to max and TREBLE to minimum (make sure balance and fader are centered) and put your ear next to each woofer.
The woofer is usually the 1st speaker to have problems after 10 years or so. The outer edge of the woofer starts to degrade. You will usually hear a rattling sound out of the woofer when this happens.
NOTE: If no sound at all out of the woofer (tweeters are OK), you might take your car into a car stereo shop. They can put a speaker on the wires connected to the speaker and make sure your problem is not the radio.
PROBLEM: You can still hear sound out of the woofers but it is distorted
SOLUTION 1: Go to a car audio shop and have them install new woofers. These may cost $30+ each but the dealer cost is over $200 for each woofer (crazy).
SOLUTION 2: More involved but very cost effective. If you or a friend is handy, you can go to www.speakerworks.com and order a new set of speaker outer rings (on the site they are called speaker SURROUND) that will replace the damaged outer rings on the woofers (replace on both woofers). They really work great and your speakers should last for many more years.
Hope this helps.

Feb 07, 2011 | 2001 Toyota Sequoia

1 Answer

Rear spark plug replacement on sienna 04


a rachet a extenion and a swivel go from under the van make sure you check the gap

May 04, 2010 | 2004 Toyota Sienna

1 Answer

Rear door on 2001 sienna won't open


The door handle might be broken, you need a new part. I got mine online for $40. keywords: 2001 2002 2003 2004 2005 2006 2007 Toyota Sequoia Metal Lift Gate Exterior Door Handle for Rear Outside Van Tailgate Handle. You need to remove the back door panel to replace this.

Mar 06, 2010 | 2001 Toyota Sienna

2 Answers

How do I remove and replace the rear speaker in my 2002 Lexus ES 300?


Hello, I have a 2000 ES300 and while the body style is different believe the newer model still has the rear deck mounted sub-woofer that you are referring to. The process of removing this speaker would start off the same as if you were going to replace the third brake light also located in this housing. Using a flathead screwdriver work your way around prying/popping up all four corners of the speaker grill covering the speaker that have the retainer clips. Once you disengage the clips work/maneuver the grill up and towards you gently and it should slide out. The bulb for the third brae light will be attached to this speaker grill, disconnect the snap wire from the bulb and you should have a clear visual of the speaker and the four bolthead screws securing it. Remove these screws and your almost home free. The next part might be slightly more difficult. If the speaker s simply connected by a clipped on wiring harness, just detach.On my 2000 ES300 i have the pioneer system(Not Nakimichi) and the 2 wires (one black, and one red) are soldered directly to the speaker. You can take a soldering iron(maybe a battery or gas powered one unless you have an inverter) and remelt the solder to remove the wires or you can elect to simply cut the wires. If you choose to cut them make sure you cut them as close as possible to the soldered joints so you have plenty of wire left to install the replacement speaker.Then install replacement either soldering or using crimp clamps and reassemble. ( Note if you simply want to add a aftermarket amplified sub-woofer you don't need to remove the sub-woofer out of the housing. You can tap into the wire leads and run it directly to the amplifier. Just cut one of the wires leading to the stock sub-woofer so it doesn't also come on and potentially blow while the radio is on. This will also prevent any bass humming when the radio is shut off but the aftermarket amplifier is still on because once one of the wires to the stock sub-woofer is disconnected or cut it breaks the circuit. Hope this helps.

Jun 13, 2009 | 2000 Lexus ES 300

1 Answer

2004 Sienna Rear Air


I too have a 2004 Sienna with a Rear Air problem. Took it to the dealer on 5 different times. They replace all kind of parts under warranty. Never fixed the problem. Now that warranty has ran out they want me to pay to figure out the problem. Please report to NHTSA.gov for an investigation

Apr 28, 2009 | 2004 Toyota Sienna

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

202 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...