Question about 2012 Chevrolet Impala LS Sedan 3.6L V6 FFV 6-speed Automatic

Open Question

2012 chevy impala makes a loud noise when I put it in reverse

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 462 Answers

SOURCE: My 2007 Chevy Impala SS

LOOK CLOSELY AT THE CRANKSHAFT BALANCER, IT MAY BE SLIPPING ON THE HUB.

Posted on May 24, 2009

Ad
  • 708 Answers

SOURCE: 2003 chevy impala makes clicking noise/smoking thru exhaust

the clicking noise could be eiter a valve or piston. the smoke out of the exhaust means different things depending on the color and how much smoke. Check your air filter and make sure oil is not backing up into it. Also, it may be a good ideal to go ahead and change the oil even though you arent at 3000 miles, unless you just changed it. Change the PCV valve also, if itis clogged it will give you problems. Has the check engine light come on?

Posted on Nov 11, 2009

Molson02536
  • 3854 Answers

SOURCE: chevy tahoe 1999 heater making noise when I put it

The bushings on the motor is worn or the lubrication has run dry, you can try lubricating the blower bushings or replace the blower motor. you can pick up a new blower motor at Auto Zone and they will have the step by step instructions you for you get the job done.

To Remove:

  1. Remove the instrument panel sound insulator panel (if equipped).
  2. Disconnect the electrical connector from the blower motor.
  3. Remove the blower motor insulating cover screws.
  4. Remove the blower motor insulating cover.
  5. Pull the retaining tab down and rotate blower motor counterclockwise to remove.
To Install:

  1. Position the blower motor and turn assembly clockwise until tab locks in place.
  2. Install the blower motor insulating cover.
  3. Connect the electrical connector to the blower motor.
  4. Install the instrument panel sound insulator panel (if equipped).
Good Luck

Posted on Dec 09, 2009

  • 4340 Answers

SOURCE: 2002 chevy impala makes a loud squealing noise

Check your drive belt tension.

Posted on Aug 18, 2010

Minzuko
  • 100 Answers

SOURCE: A loud humming noise coming from the rear of my

There is bulletin for a humming noise like yours that has to do with the Torque Converter. #01-07-30-010C 5/12/2008 Call GM and ask about it.

Posted on Oct 13, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Transmission make loud sound when put it in revers


PLEASE HELP! SOS! car starts but doesnt move! - Club3G Forum ...

www.club3g.com > ... > Performance & Tech Forums > Problem Reports

Nov 16, 2010 - 61 posts - ‎14 authors
now yes, i will take the transmission is fubar into consideration but theres an .....however... idk about my cv joint, my car ONLY would make a loud ping noise when i move from a stop or brake ..... almost always when i put it into reverse. such as an engine mount sound, ... Vehicle: 2004 Eclipse Spyder GT. Loud knocking sound after oil change..
14 posts
Sep 20, 2010
Horrible noise upon start when cold
21 posts
Dec 24, 2009
Sporty knocking.. Oh noez!!one!!1!
16 posts
Mar 22, 2006
More results from www.club3g.com

Loud thump when I shift into drive or reverse - CarGurus

www.cargurus.com > Questions > Chevrolet > Cavalier

CarGurusDec 19, 2012 - And while driving loud thump when car motor shifts th... ... Bad throttle position sensor can trip both lights and make the transmission shift at high rpms and shift hard even under light acceleration. .... the transmission will shift hard when firstput into reverse or drive ... 2004 Chevrolet Cavalier LS For Sale.Missing: mitsubishi ‎eclipse

Mitsubishi Transmissions & Drivetrains Repair Questions ...


Dec 06, 2015 | 2004 Mitsubishi Eclipse

1 Answer

When i make right turns i hear a scraping noise in car


could be one of to things brake pads or a wheel bearing most likely it's a wheel bearing if you can't here the brakes make any other noise when stopping

Apr 25, 2014 | 2012 Chevrolet Chevrolet Impala LT

1 Answer

My 2002 Chevy Tahoe is making a loud noise when I pick up speed and its making a loud noise when i put it in reverse


CK THE U JOINTS ON THE DRIVE SHSFT. YOU HAVE TO REMOVE THE SHAFT AND SEE IF THE JOINTS MOVE SMOOTHLY. IF NOT REPLACE THEM. ALSO CK THE CENTER SUPPORT BEARING IF IT HAS ONE. ALSO CK THE TRANS MOUNTAND THE FLUID LEVEL IN THE REAR END. HOPE THIS HELPS BILL

Dec 18, 2012 | 2001 Chevrolet Tahoe

1 Answer

- stumbles when stopped and accelerating at low speeds


ENGINE HESITATES WHILE ACCELERATION
LOSS OF ACCELERATION

It can be fuel pressure issue or it's the problem with accelerator pedal or its clogged filters causing there.
There are many other possibilities. I suggest you to go through the list of help links mentioned below, these will help you to confirm where the actual fault lies: -------
Jerks and Hesitates During Acceleration?
http://technoanswers.blogspot.in/2012/07/2004-dodge-town-country-jerks-and.html
-----------
Loss of acceleration?
http://technoanswers.blogspot.in/2012/02/loss-of-acceleration.html
---------
Headlights flickering and car hesitates to start?
http://howtobyme.blogspot.in/2012/02/headlights-flickering-and-car-hesitates.html
--------
How exactly the Vehicles Accelerator Cable works?
http://repairhelpcenter.blogspot.com/2011/11/how-exactly-vehicles-accelerator-cable.html
-------------
How exactly Vehicles Accelerator Pump Diaphragm Works?
http://repairhelpcenter.blogspot.com/2011/11/how-exactly-vehicles-accelerator-pump.html
--------
2000 Toyota Avalon: Engine Lean Codes and Knock Sound on Acceleration?
http://whatisbyme.blogspot.in/2012/05/2000-toyota-avalon-engine-lean-codes.html
---------
2004 Toyota Avensis: Acceleration And Deceleration makes noise on Front End?
http://whatisbyme.blogspot.in/2012/05/2004-toyota-avensis-acceleration-and.html
---------
Wheel hop under hard acceleration?
http://technoanswers.blogspot.in/2012/04/wheel-hop-under-hard-acceleration.html
--------
2009 Chevy impala accelerator pedal sensor?
http://technoanswers.blogspot.in/2012/02/2009-chevy-impala-accelerator-pedal.html
---------
Nissan Pathfinder stalls and bucks on Acceleration?
http://technoanswers.blogspot.in/2012/02/nissan-pathfinder-stalls-and-bucks-on.html
--------
Acceleration lag problem?
http://repairhelpcenter.blogspot.com/2012/01/acceleration-lag-problem.html
-------------
These details will help.
Thanks.

Dec 07, 2012 | Cars & Trucks

1 Answer

2003 impala LS making loud ticking noise on cold starts, subsides when warm


yes chevys 3.4 and 3.5 have common lifter noise, have you checked the oil level. I would a better oil ,and I put lucas oil treat in my customers cars after oil changes

Nov 11, 2012 | 2003 Chevrolet Impala

1 Answer

Tapping sound after changing all new lifters


What motor is it? Some of the V-6's will always make the noise no matter what you do! Gotta love GM for this!

Jun 08, 2009 | 2003 Chevrolet Impala

Not finding what you are looking for?
2012 Chevrolet Impala LS Sedan 3.6L V6 FFV 6-speed Automatic Logo

Related Topics:

87 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...