Question about Cars & Trucks

1 Answer

I have 2000 ram 3500 cummins 24 valve turbo diesel 5.9. In the mornings if cranks up fine but if I cut it off and try to crank it back up shortly after it does not crank. Any suggestions?????

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 36 Answers

Intermittent problems are hard to pin down, check glow plugs or worn ignition at the key, or a ground at the starter

Posted on May 10, 2013

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

renselff
  • 75 Answers

SOURCE: Cummins diesel in 2001 Dodge is cutting out and mild surge. code#s are P0500,P0370 P1693

you have codes related to the pcm, transfer pump and a vehicle speed sensor. these could be related or all individual issues. related issued could be wiring, untill you start doing testing it will be hard to tell.
start cheap and test the speed sensor first, then you can clear the codes and continue on any codes come back.


Disconnect the PCM harness connector(s).
Disconnect the Vehicle Speed Sensor harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance of the 5 Volt Supply circuit between the VSS harness
connector and the PCM harness connector.
Is the resistance above 5.0 ohms?

Posted on Jun 10, 2012

pippall
  • 1486 Answers

SOURCE: 2001 dodge 5.9 diesel Cranks for 20 to 30 sec to start in morning

You have fuel runback.Replace the injector leak off pipes then try.If this does not work then have a non return valve fitted to your fuel supply pipe close as possible to the punp.Hope that was helpfull good luck.

Posted on Aug 01, 2009

BCAS1298
  • 3092 Answers

SOURCE: I have the following fault codes reading

P0216 - injector timing control circuit

P0234 - turbo / supercharger over boost condition

P0523 - engine oil pressure sensor / switch circuit high inout.

Posted on Jan 22, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where can I get a wiring diagram for a 1997 Dodge RAM 3500 diesel pickup?


1997 3500 Wiring Diagram - Dodge Diesel - Diesel Truck Resource Forums

www.dieseltruckresource.com/...dodge-ram.../1997-3500-wiring-diagra...
Jan 24, 2011 - Hey guys, I'm working on a 97 3500 that's had the bed removed and replaced with a flatbed. There is the biggest mess under that truck wiring wise and. ... 2007 Ram 3500 A/C compressor wont engage, need wiring diagram ...

Dodge Wiring Diagrams / Schematics - YouTube

? 1:13
https://www.youtube.com/watch?v=UI6_vhCHFYU
Nov 19, 2013 - Uploaded by Robert Nauert
Dodge Wiring Diagrams / Schematics ... Nitro, Power Wagon, Ram 1500, Ram 2500, Ram 3500, Ram 4500 ...

1997 Dodge Cummins - Full color wiring diagrams - 12 Valve ...

forum.mopar1973man.com/.../1638-1997-dodge-cummins-full-color-wi...

Jan 01, 2016 | Dodge Cars & Trucks

1 Answer

Where is the computer located on a dodge ram 3500 24 valve cummins diesel


E C M located on left side of engine behind fuel filter

Nov 18, 2010 | 2000 Dodge Ram 3500

1 Answer

Diagram for fan belt routing on a cummins 24 valve turbo diesel 5.9 w/ air conditioning


web resourceful.com for complete auto manuals online. hope i helped!!

Aug 16, 2010 | 2004 Dodge Ram 3500 Truck

1 Answer

I have the following fault codes reading


P0216 - injector timing control circuit

P0234 - turbo / supercharger over boost condition

P0523 - engine oil pressure sensor / switch circuit high inout.

Jan 22, 2010 | 1998 Dodge Ram 3500 2WD

2 Answers

2001 dodge 5.9 diesel Cranks for 20 to 30 sec to start in morning


You have fuel runback.Replace the injector leak off pipes then try.If this does not work then have a non return valve fitted to your fuel supply pipe close as possible to the punp.Hope that was helpfull good luck.

Aug 01, 2009 | 2001 Dodge Ram 2500 Truck

3 Answers

Charging problem on 1996 Dodge Ram 3500 Cummins Turbo Diesel


I had the same problem on a 94 dodge with the cummins. It seems the crank sensor that reads from a notch on the harmonic balancer was the problem Without this sensor reading that the engine is running the alternator wont charge. Possibly the same problem with yours

Mar 25, 2009 | 1996 Dodge Ram 3500 Club Cab

2 Answers

Truck just shuts off


I own the same 3500 GMC 6.5 diesel truck with the same problem. We replaced the brain under the upper turbo hood and it fixed it pronto. No more shutoffs

Dec 07, 2008 | 2000 GMC Sierra 3500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

110 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...