Question about Tata Indigo

1 Answer

Idle RPM What should be the Idle RPM of the car without ac N with ac. Please reply.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

  • Contributor
  • 1 Answer

We very car is different.mine is 1500. You should be able to call advance auto parts or any other and they can tell you over the phone for your year make and model

Posted on May 10, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi my car dies when clutch is pressd or when i change gears while AC on


Have you tried raising the idle speed another 100 rpms ?

Nov 15, 2013 | 2008 Ford Ikon 1.6

2 Answers

Does high idle consumes more gas??


obviously does, more RPM needs more gas

Mar 14, 2013 | Cars & Trucks

1 Answer

This rough idle business; With the AC on at a stop, the idle is about 600 to 700 rpm and vibrates the cabin. Can the dealer change a computer setting to correct this?


Problem on focus too . Without A/C on it idle's smooth . With A/C on the PCM - engine computer should raise the idle rpm. 850 . The only way to raise the idle would be to have PCM flashed programmed with up dated software . Adjusting the idle anyother way would cause check engine light problem , Wouldn't be able to get it to go out. Your best bet ,take it to the ford dealer and have the PCM reflashed .

Sep 14, 2017 | Ford Escape Cars & Trucks

1 Answer

Rpm is high and when i open the ac the car go off when i brake


your rpm is to high adjust your normal idle to .85 when a/c adjust the actuator to reach rpm .95 approximately but be sure not over to 1.

Sep 01, 2012 | 1998 Mitsubishi Galant

1 Answer

CAR RUNS GREAT, STARTED DIEING WHEN A/C WAS TURNED ON, NOW A FEW DAYS LATER IT DIES EVEN WITHOUT A/C ON, RUNS BUT WILL NOT IDLE


CHECK IDLE SPEED SHOULD BE 650 - 850 RPM. IF IDLE TOO LOW AC WILL PUT DRAG SLOW DOWN ENGINE CAUSING ENGINE TO STALL IF IDLE SPEED IS TOO LOW.

Sep 09, 2011 | 2000 Mitsubishi Eclipse

1 Answer

My 1992 lexus ls 400 keeps stalling and idleis very low


Look for a small electric motor near the accelerator cable and near the top of the valve cover.

It's call IDLE AIR CONTROL (IAC) motor.

It's job is to increase the idle when load is added.
Example: turning on headlight,turning on AC.

Testing it is simple.

Warm up you car for 10 minutes.

Locate the IAC motor

turn on loads.....AC,headlights,etc


The motor should move the idle up


If the motor does not increase the RPM then it can be stick.

Try to give it few gentle taps to free up the gears.

It can be clean if your are up to it.


This electrical motor is very expensive. Please handle it with care.

====

The other trouble spot are

old accelerator cable

TPS Throttle position sensor

====

I will do a simple tune up and gas treatment before starting to replace any parts.


Please post reply on the comment window.


Oct 27, 2009 | 1992 Lexus Ls 400

1 Answer

Fast Idle above 2000 rpm during warmup & electrical issue


If it's not vacuum leaks, it will be you idle control sensor.

May 08, 2009 | 1993 Honda Civic 4 Door

1 Answer

Envoy 2004 idle speed


Hi
your problem seems very easy :) hope this one work with your envoy. Just buy AC DELCO carburetor tune-up conditioner.

How you use it: engine running , AC off please

1. detached the big black airflow hose which is attached in the mannifold of the engine block.

2. ask your friend to step on the gas pedal and set the rpm steady in 2000 rpm only.

3. then spray vigorously in 8 seconds the inside circle opening of mannifold while your friend steady step on gas pedal with steady 2000 RPM only.

4. after you spray, let your freind continue on gas pedal with 2000 rpm for 15 more seconds.

5. attached back the airflow big black hose to the manifold and you are ready to roll with your AC on.

if this one doesnt work, please scan your envoy by scanner called TECH II. and find out.

Jul 09, 2008 | 2004 GMC Envoy

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

48 people viewed this question

Ask a Question

Usually answered in minutes!

Top Tata Experts

yadayada
yadayada

Level 3 Expert

80339 Answers

colonius

Level 1 Expert

35 Answers

gbob59

Level 3 Expert

2992 Answers

Are you a Tata Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...