Question about Cars & Trucks

Open Question

Fuso 8m21 injection pump starting problem - Cars & Trucks

Posted by Anonymous on

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 524 Answers

SOURCE: MY FUSO HAS ELECTRONIC FUEL INJECTION SYSTEM.

hi...
electric fuel injection-As you have the elecronic injection the sensor which senses the amount of acelaration given by you may be failed. so it doesnt activates the fuel injection signal so that no required fuel goes into the cylinder when you accelarate.

Posted on Jul 10, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

06' FE180 Fuso won't start without ether after it starts it runs fine and is drive able but once shut off won't restart


It is not a good idea to use ether on a diesel engine. With that in mind you have an issue with the oil pressure in the lubrication system or an injector seal that is bad.

Jan 07, 2017 | Cars & Trucks

1 Answer

Transmission cooling fan needed


you can get transmission cooling fans from any good auto spares / transmission repair shops
it is a fan be it fuso or generic and just moves air
it may be better if you just re-position the cooling radiator in the air flow in front of the radiator
go google and type in---fuso spares on line--- and there are sites that will have what you want

Nov 24, 2015 | Cars & Trucks

1 Answer

99 Fuso FE won't start but cranks over. Previous owner made it idle by over riding something in rear of fuel pump solenoid ??


it appears that the stop solenoid is defective and the owner was manipulating that switch to allow it to run
I would start by investigating that area or even replacing that stop solenoid

Nov 24, 2015 | Cars & Trucks

1 Answer

How to adjust the fuso 4d34 fuel inline pump timing


this requires a person with diesel pump experience. best have it done by an accredited diesel pump shop as if you get it wrong there will be engine damage

Nov 19, 2014 | Cars & Trucks

1 Answer

What happens to the fuso truck 6d40 when injector pump distributor has a problem?


normally it will be hard to start or will not start ---there may be missing in the engine ---there may be loss of power --the rpm's may fluctuate widely --- it may blow lots of black smoke --- the motor may be over heating more---

Jan 02, 2014 | Cars & Trucks

1 Answer

Transit pump code p0216 how can i fix this


P0216 DTC - Injection Timing Control Circuit Malfunction and this means the diesel fuel injection pump has a timing failure. This could be that the injection pump timing needs adjusted OR the failure is internal to the injection pump and therefore non-adjustable.

NOTE: If your vehicle is a Dodge Ram with Cummins engine then be aware that fuel delivery problems frequently cause this code. Prolonged fuel delivery problems can cause injection pump failure!

Symptoms of a P0216 DTC may include:
Low power
Crank, but no start
Hard start
Displays an intermittent stumble or miss
Engine may start and then stall
Engine may appear to drive fine but surge at idle


The most frequent cause of this code is a bad injection pump due to poor fuel delivery. Fuel delivery problems could be:
A plugged diesel fuel filter
An in-tank blockage
Air in the fuel due to a cracked in-tank fuel ine above the fuel level
Bad transfer (lift) pump
Injection pump out of time


Possible Solutions: First, simply check if your injection pump timing is adjustable. If so, check the timing and adjust if necessary.

If you think that you may have a fuel delivery problem, then check the lift pump operation. On Dodge Ram with the Cummins engine, the lift pump should produce about 45 oz of diesel in 25 seconds of operation. This can be performed by disconnecting the fuel hose from the injection pump and pumping the fuel into an approved container. Bump the engine over but do not start it. Then the lift pump will operate for 25 seconds. If the fuel is aerated, then check/repair fuel line and recheck.

With the fuel hose connected the fuel pressure should be 10psi. If the fuel delivery tests fail, replace the diesel fuel filter and recheck.

If it still fails then verify there are no restrictions in the fuel tank

Then replace the lift (transfer) pump. IT SHOULD BE NOTED that if this code surfaced after a routine fuel filter replacement or if you have any of the above symptoms after routine fuel filter replacement, then suspect the fuel transfer pump. This occurs because even a weak transfer pump can still provide enough fuel for the engine to run. But when the fuel system\'s prime is lost due to fuel filter replacement, it may not restart again without fixing the fuel delivery problem.

If you found your injection pump to be bad, the lift pump should be checked for operation to protect the new injection pump. This is because weak or low output from lift pump are common cause of injection pump failure. There are some aftermarket kits that can be purchased to warn the operator when the fuel pressure/volume drops to level that could damage the injection pump.

Hope this helps (remember to rating this free answer and leave a testimonial comments).

Oct 11, 2011 | Cars & Trucks

1 Answer

MY FUSO HAS ELECTRONIC FUEL INJECTION SYSTEM. AFTER STARTING, IT DOESNT PICK ACCELERATION. WHAT COULD BE THE PROBLEM


hi...
electric fuel injection-As you have the elecronic injection the sensor which senses the amount of acelaration given by you may be failed. so it doesnt activates the fuel injection signal so that no required fuel goes into the cylinder when you accelarate.

Jul 10, 2010 | 2000 Mitsubishi Montero

2 Answers

2001 grand cherokee laredo 3.1 diesel would not start


it could be that one of the injectors is bleeding off pressure not allowing enough fuel pressure to start. the 5.9 and 6.7 cummins need at least 2000 psi to start

Jan 07, 2009 | 1995 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...