Question about Cars & Trucks

Open Question

Kreisler light sensor lighter

I need to know what size battery will fit. I've been told a 357 is what it needed, but it is to thick. Is that the wrong size or is my lighter damaged?

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 140 Answers

SOURCE: Need to know the physical size of a battery for a 1996 Cherokee.

Your Jeep Grand Cherokee uses a group 34 type battery. The sizes vary from manufacturer to manufacturer but, the standard size is 10 1/4 " x 6 13/16" x 7 7/8" or 260mm x 173mm x 200mm. Anything close should fit fine. Good luck. Please ask for help any time. Please rate me so I know how I'm doing. Thanks

Posted on Dec 30, 2008

  • 534 Answers

SOURCE: Peressure bleed a cluch pt 2003

Try a manual bleed first, as it may achieve the same result without the hassle of pressure bleeding.
Fill the master cylinder resevoir, keep it topped up while cracking open the slave delivery line- wait for a steady dribble of fluid to come through - a couple of gentle pumps of the master cylinder will help the process.
Then move to the slave cylinder bleed nipple - crack it open and repeat the process above.
Once you get a bit of pedal pressure back, it's fairly straightforward to complete the bleed process.

Posted on Oct 06, 2009

  • 662 Answers

SOURCE: Hi. I think I may

Your 2005 Pontiac Sunfire battery group number is 75.

Check the Part Numbers of these batteries for your car - they all begin with "75."

Three batteries that fit your car are found at:

The "Group Number" refers to the dimensions of the battery - at battery that's too big wouldn't fit into
the battery compartment of the car.

Posted on Jul 29, 2011

  • 134 Answers

SOURCE: what size fuse is needed

Should be a 20 amp. I would look in your owners manual. TJ

Posted on Aug 05, 2011

  • 436 Answers


airbag fuses are located under the hood. I have lots of experience with this system on these trucks. most of the time the problems is a bad crash sensor in the front end of the truck.. There are two, one on the passenger side of the front rail, and the other is on the drivers side of the front rail. It will help narrow down the proble if you just have it scanned. most mechanics can read the airbag code for you. Just have to call and ask. I do not recommend you call dealer for this code reading, they will charge you lots. lots of private garages will do it much cheaper. good luck.

Posted on Oct 17, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Firewall wiring

whats size cable are you using. there are a few grommets eg were the other wires go. but will need to know the size wire you are fitting as some will not take the thick power line wire.

Oct 08, 2013 | Vauxhall Cars & Trucks

1 Answer


If one tail light works, it's not the fuse box. It's either a ground wire off on that side , or a wire chafed along the curcuit. Your fuse for parking lights is for all four. If you have three, it's definately not the fuse box. You did not say what type of vehicle you have or I could have told you the best places to look for a ground wire. And I'd like to know if signal, brake, and reverse lights on that same side work at all. Let me know what your car is and we'll go from there. Please rate this solution thanks

Jan 07, 2013 | Dodge Ram 1500 Cars & Trucks

2 Answers

ABS and Traction lights are on, Service Sytstem stability on dash displays

The computer is tired or you need a sensor or two are not acceptable answers. Its possible he damaged something by lifting the car.
I would take it somewhere that can scan the computer for trouble codes and see what has failed. The computer stores codes when the warning lights are on. Once you know what the codes are you can figure out if it is something he may have done.

Dec 07, 2012 | Cadillac STS Cars & Trucks

1 Answer

How to reset DTC code after oxgen sensor replaced?

Year make and model also engine size. I'm not a fan of universal O2 sensors perhaps you should've put a direct fit on. To clear the codes depending on the year if the car removing the and make removing the battery negative, the ECM fuse or using a scanner should work.

Jun 19, 2012 | Toyota Highlander Cars & Trucks

1 Answer

Subaru Fuse

use your car manual and locate the fuse box then use the diagram on the fuse box to show you which fuse is for the lighter and remove it and fit a new one and you should be good to go

May 22, 2012 | 2002 Subaru Legacy

1 Answer

2000 GMC Sonoma surges and dies

First the intake manifold should never leak start here. If the intake manifold leaks the air mix can not stabilize causing rich then lean condition.making your 02 sensors act up. The car will always search or purge in RPM range for its ECM required range. Fix the Leak first. get back to me.

Apr 03, 2012 | 2000 GMC Sonoma Extended Cab

1 Answer

Changing the cigarette lighter

Well for that you could look at a junkyard or automotive supply dealer, you'd be looking for a 12volt accessory socket\lighter socket.

Wiring it would be pretty simple, you uninstall the one in your dash and install the new one.

You'll need basic tools for this and a soldering iron, solder, shrink wrap tubing and a lighter. A wire stripper wouldn't be a bad idea either.

Feb 06, 2012 | Peugeot Cars & Trucks

1 Answer

Hi. I think I may need a new battery for my 2005 Pontiac Sunfire. What size battery does it take? I've been checking online, but I need to know the "group size."

Your 2005 Pontiac Sunfire battery group number is 75.

Check the Part Numbers of these batteries for your car - they all begin with "75."

Three batteries that fit your car are found at:

The "Group Number" refers to the dimensions of the battery - at battery that's too big wouldn't fit into
the battery compartment of the car.

Jul 29, 2011 | 1997 Pontiac Sunfire

2 Answers


Hi, your crank sensor is about $60 at autozone, but there could be other reasons for the car not to start. If you'd like to do some troubleshooting, please see my tip at . These are generic instructions. If you get stuck or need specific instructions for your car, please get back to me with your engine size.

Apr 21, 2011 | Hyundai Motor 2004 Sonata

2 Answers

The cigarette lighter wires are disconnected in my 1985 Toyota 2wd pickup. How can I tell which wires I need if there is small of wires hanging down behind the console?

Just get a test light and see which , if any of the wires hanging down have power to them. Run one with power to the lighter. Then you need a ground wire. The origional ones should have plugs on the end that fit the prong on the lighter.

Oct 27, 2009 | 1985 Toyota Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides