Question about Cars & Trucks

Open Question

John deere 5325

Have 5325, was running fine, unloaded it off the trailer started running rough, then died. Won't start, just cranks over.

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 16 Answers

SOURCE: cranks fine but runs rough and dies.

you need a new choke

Posted on Dec 17, 2008

  • 58 Answers

SOURCE: running rough and wants to die

Have the fuel pressure at the fuel rail checked. If you just want to throw parts at it: Fuel filter by the tank first. Fuel pressure regulator next. Order of ascending expense and likely hood. Does the fuel pump hum louder lately? The fuel pump may be on it's way out. It's not getting enough fuel to do anything but idle. Why that is takes some investigation. Somebody like Auto Zone may check your fuel pressure. If the fuel pressure is good, bad spark plug wires are the next guess. Lift the hood and run the engine in the dark (take the light bulb under the hood out if it still works to do this) If you see little lightening bolts traveling over the engine you need new plug wires. If the fuel pressure is good, the wires are good, change the spark plugs. Good Luck!

Posted on Jun 08, 2009

  • 55 Answers

SOURCE: 99 jeep wrangler 4.0L 6 cylinder auto it started

You need to check the fuel pressure, if not enough it will run rough.

Posted on Jun 27, 2009

  • 1564 Answers

SOURCE: rough running

Computers aren't ALWAYS correct. If a code wasn't cleared after the original problem, it will read the same codes off to the diagnostic. I would remove the wire connector to each injector while it's running. If one of them makes no difference THAT is your culprit. Let me know please!

Posted on Jun 27, 2009

  • 408 Answers

SOURCE: car stalls after sitting a day or two

hello,good day,maybe your fuel pump or fuel pump relay is not working properly,,also fuel filter and fuel nozzle should be check (fuel side) in electrical you have transistor box,spare plug.distributor cap ,rotor also tobe check,ty

Posted on Aug 15, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Fuel system running rich and stalling

Sounds like it is slightly out of time.

Apr 14, 2014 | Ford Cars & Trucks

1 Answer

Runs rough dies

change the fuel filter and check the fuel pressure

May 25, 2013 | Ford Expedition Cars & Trucks

1 Answer

Car wont start untill i press on the gas?

Check your cam and crank position sensors. Check the fuel pressure regulator and then the Fuel pump itself. This sounds stupid, but go check the gas cap too and make sure it is on tight. Sometimes it's the little things..haha. The two sensors tell where the crank and cam are in relation to each other and TDC of Piston 1. If one of the sensors is out of whack...the whole timing process will be thrown off. Most of the time if the cam sensor is bad, the car won't start, if the crank, it will start but run like ****. They don't cost much usually and your car is old enough that they should be replaced anyway. The MAF sensor would just cause the car to run rough most of the time if it were faulty or dirty. But being how generalized those codes are, it's never fun to figure out. Hope this helps you :)

Sep 01, 2012 | 2004 Chevrolet Impala

1 Answer

I have a 2003 Jeep Grand Cherokee that won't start. Can't read codes - claims we need to check connections. Cranks fine. Notice that fuel gauge and battery voltage does not register anythin

Hi Roger, Sounds to me as if you may have a problem with the anti theft unit in your vehicle. A diagnostic scan would help greatly to pin point the problem. Regards John

Jun 24, 2012 | 2003 Jeep Grand Cherokee

1 Answer

2001 ford taurus car starts fine drive it for awhile then shut it off and it wont start let it sit and it will start battery is fine

Does it crank?If you shut it off and you restart after a few minutes and it cranks but won't start or starts and runs rough the injectors are leaking and flooding the engine. Need better description

Dec 07, 2011 | 2001 Ford Taurus

1 Answer

1998 GMC Savana conversion van - It starts right up and immediately dies, repeatedly and randomly. Sometimes it won't start for days. Then poof, starts right up. It turns over fine, it starts fine. The...

It won't die when pulling the relay because it has another power path to the fuel pump through the oil pressure switch . Fuel Pump Electrical Circuits Description and Operation watch this video on fuel pump control , shows chrysler first , ford ,then gm . wait for gm an he explains the oil pressure switch . Plus when it won't start ,don't guess or theorize ! Test what's missing ? check for spark , no spark check ignition system , coil's , ignition module , crank sensor etc... has spark ,do a fuel pressure test etc... don't think computer , when it won't start does the check engine light come on with the key on run not start . If light is lit ,nothing wrong with the cumputer . If want to fix cars you really should take some automotive classes . Test don't guess .Watch some other videos crank no start videos etc...

Mar 02, 2017 | 1998 GMC Savana

1 Answer

2002 s-10 have to hold gas pedal all way down to start when it does start sounds like old modle a john deer let of gas moter dies

sounds lie your pressure is ok, but I am curious about the Volume. When was the last time you changed your Fuel Filter? If it is a flex fuel vehicle, and you use a standard gauge on fuel pressure, it will read a bit high.
Second, How old is your battery? Mine did the same thing over the winter, and I found out that my 2000 S-10 only had one replacement battery 4 years ago. It didnt have the Cranking Amps it needed , resulting in hard starts, and low voltage to the Spark Plugs, which made it run rough.

Jul 21, 2009 | 2002 Chevrolet S-10

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

77194 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides