Question about Cars & Trucks

Open Question

1994 oldsmobile cutlass supreme surges/hesitates at acceleration does not stall. no check engine light. evens out at 40 mph and at 70 mph

Posted by on

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

samtoler
  • 666 Answers

SOURCE: 1994 3.1 cutlass supreme surges/hesitates at

This sounds like fuel pump failure

Posted on Jun 09, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

This engine has a surge; AT 35-45mph,it's a bit more prounounced, not as bad, but still there at 60mph. As the tach goes up some, then down, so does the motor, up then back down, etc.Any ideas?


About 73,200 results (0.82 seconds) Search Results

    Surging While Driving Between 40 and 50 MPH : Chrysler ...

    repairpal.com > Problems > Chrysler > Town & Country
    Around 35 mph (common street speeds) the engine will sometimes surge with noticeable tach fluctuations. ... I have a surge when coasting around 40-45 mph.

    Enginge surges RPMS drop while driving [Archive] - Chevy ...

    forums.trailvoy.com > ... > OEM Issues

    Mar 17, 2012 - 19 posts - ‎7 authors
    [Archive] Enginge surges RPMS drop while driving OEM Issues. ... I so hope somebody has a clue as to what is causing my '02 Envoy's (182k) engine to ... I'll be driving and when I get up to around 35 - 45 MPH sometimes my ...

    Hesitation and bucking on acceleration - F150online Forums

    www.f150online.com/...engines/476391-hesitation-bucking-acceleration....

Feb 09, 2016 | Cars & Trucks

1 Answer

My 1993 olds cutlass supreme idles fine until you step on the gas or when your going down the road at higher speeds than idle it has a hesitation what's the problem?


A flat spot on acceleration could be low fuel pressure or a faulty throttle position sensor. Could also be a vac leak such as a faulty EGR valve.
Is the check engine light on ?

Mar 06, 2014 | 1993 Oldsmobile Cutlass Supreme

1 Answer

1992 olds cutlass supreme wont accelerate when pushing the gas pedal


Check oil first, Low oil sensor will shut down if more than a quart low. Change fuel filter, could be fuel starvation, change the air filter. stopped up air filter will put MAF sensor out of range. PERFORM OBDII SCAN SOON.

May 19, 2017 | 1992 Oldsmobile Cutlass Supreme

1 Answer

1988 cutlass ciera boggs down when i accelerate


Hello! You have symptoms that point to incorrect fuel pressure.
First have the fuel pressure tested as follows; #1...engine running at idle: 13- 20 psi. #2...key on engine off: 23-30 psi. If pressure is incorrect change the fuel pump.

Does the engine "surge" at idle? If so, check the "fuel injection pressure regulator idle air control valve". Apply a vacuum to it; If fuel flows it is not the problem.


Guru.............saailer


Dec 13, 2009 | 1988 Oldsmobile Cutlass Ciera

1 Answer

When I start the car, it will sputter. It runs OK and that sputter stops when the speed gets up to 35-40 but when you stop, it is there again. Going up a hill, there was no hesitation. This is a 1994...


check sparkplug wires, may be time for a tune-up. also those engines have injector problems, the problem is they need cleaning, with a motor vac machine, may have to go to a garge,good luck, start there.

Oct 23, 2009 | 1991 Oldsmobile Cutlass Supreme

1 Answer

1993 oldsmobile cutlass supreme engine stalls choking


soundl like idle air control valve sensor
try a clean .............if no better replace

Apr 30, 2017 | 1993 Oldsmobile Cutlass Supreme

1 Answer

Car forces me to slow down


I doubt it is a speed sensor. It is in the transmission near the passenger side cv axle. Have you scanned it for codes? You can do it with a paperclip.

Mar 11, 2009 | 1993 Oldsmobile Cutlass Ciera

1 Answer

1997 oldsmobile cutlass supreme knocking noise & problems acceler


That could be only two things one a bad pistion or a bad rod. I would take the engine apart and find one or both maybe broken or in bad repair fixing. I would not drive it far it will throw the pistion or rod right through the engine costing ya more money or a new car.

Dec 14, 2008 | 1997 Oldsmobile Cutlass Supreme

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...