Question about Cars & Trucks

Open Question

Where are the fuses located on a dixon ram 50 mower

Posted by Anonymous on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I put a new battery in my 1986 Dodge ram 50 that has been sitting for a long time. I have no power, is there a master fuse somewhere I need to check?

Check ur balast resistor on the coil located next to the batery if this is bad it can cause either no electricity or too much electricity going through ur vehicle could blow fuses all the time or not give any power to them if u have a ohm meter. Disconnect wires going to balast and read across terminals if it reads more the 1.7 ohms the replace it u should not see k ohms or M ohms just 1.7 or lower. Hope this helps

May 24, 2012 | 1986 Dodge Ram 50

1 Answer

Where is the fuel pump on a 87 dodge ram 50 Need to know where the fuel pump is located on my 87 dodge ram 50 2.6 so it can be replaced

For 1987 Dodge Truck RAM 50 4WD 2.6L 2BL 4cyl...

The mechanical fuel pump is mounted on the side of the head, centered between the runners of the intake manifold. The intake manifold does not require removal, but access can be tricky. A selection of socket extensions, swivels and open end wrenches can be helpful.


Fig. Fig. 3: Mark the fuel lines and pump mating points


Fig. 4: Unbolt the fuel pump assembly from the engine then

Hope helps.

Sep 09, 2010 | 1987 Dodge Ram 50

2 Answers

86 Dodge ram D - 50 - Fuel Pump

A carburetor type engine has the pump on the engine near the front on the side--trace the fuel line down. Fuel injected engines have the pump located in the fuel tank.

Aug 24, 2009 | 1986 Dodge Ram 50

1 Answer

1987 dodge ram 50 pick/up rear lights not working but headlights work fine.also dash lights and radio lights are not working.

It could be a fuse? Have a look in the fuse box, your owners manual will detail where it is. Take a look at the top of each fuse to see if the thin piece of metal is burned out.

Aug 04, 2009 | 1987 Dodge Ram 50

1 Answer

Connecting a 50 amp current guage

to the main fuse box under the hood between the fused side of the main junction across from batt. connection ( caution ---- make sure you fuse that line in case of a short) in fire wall and use no less then 6ga wire if this is not a shunted amp meter if it is shunted use proper fuse and wire for the shunt

Jun 27, 2009 | 2001 Dodge Ram 1500 Truck 2WD

1 Answer

Were is the ignition fuse or circuit in a 89 dodge ram with a 318

The main fuses are located in the engine compartment near the rear of the driver side fender.

Cheers, Jay

Mar 16, 2009 | 1989 Dodge Ram 50

1 Answer

1989 dodge ram 50 2.6l won't start after jumping other day, fuse?


When the battery terminals were replaced, be sure to check that all the wiring was correctly installed. (Pos+ to Pos+ and Neg- to Neg-, etc.)

Sounds like something got missed and the ignition system is not working... be sure to check the main fuses and replace any that are blown.

Cheers, Jay

Dec 11, 2008 | 1989 Dodge Ram 50

2 Answers

Where is the Fuel Filter located on 1988 Dodge Ram 50

Under hood, center, lower engine area, between fuel pump and carburetor, mounted in fuel line

Nov 08, 2008 | 1988 Dodge Ram 50

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides