Question about Cars & Trucks

Open Question

Evinrude etec problems

2004 evenrude e-tec 75hp. no spark. Batt. conections cleaned full full, spark plug won't spark. ran 1 min. yesterday. . died wont start. Checked all fuses.

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 74914 Answers

SOURCE: Replced the cap & dist coil pac has fire no spark to spark plug

install the new rotor, if that isn't it check the crankshaft position sensor.

Posted on Mar 18, 2009

roniecon
  • 6826 Answers

SOURCE: check guages light came on

The main problem is the alternator has went out,and the battery voltage dropped to low for it to run.Most likely the computer has lost memory sense the battery was dead,or close to it.I don`t know the year,but this is most likely what happened.The computer would have to be reflashed at the dealership.But be sure to look for a main fuse to be blown,check all fuses,this might have happened,and not the computer.

Posted on Nov 03, 2009

BCAS1298
  • 3092 Answers

SOURCE: 93 honda accord ex died while driving,ran again

Check for fuel, sound's like not getting fuel.

Posted on May 12, 2010

  • 117 Answers

SOURCE: ford 2004 e250 after cleaning/removed

If you indeed installed the positive battery cable last and the neg first you blew the computer possible, you will need a complete diagnosis.

Posted on Jul 01, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2013 evinrude etec 25 hp. It has only had less than 2 tanks of fuel ran through it. I took it out today and it would start but wouldn't stay running.


This is a 2 stroke engine - an outboard motor?

Two strokes are quite robust. The usual mistake people make with these engines (think of chainsaws, lawn mowers and hedge strimmers..) is to use car engine oil instead of the correct two stroke oil. Motor oil is completely incorrect and fouls the spark plug.

The other fault is to mix fuel and two stroke oil in the wrong ratio. Most chainsaws etc .. use a mix of 25:1 Too much oil causes oiling and misfiring of the plug. Too little oil causes excessive and fast wear.

Your engine starts up. That tends to suggest that everything is working ok up to a point.

However, look on the following link which deals with an overheating problem for that engine:

http://www.etecownersgroup.com/post/25hp-etec-problem-6107593

May 21, 2016 | Cars & Trucks

1 Answer

Murray m2500 won't start after one day of having it


bad coil in it, i had bought a m2500 murray weedeater from walmart .did same thing i replaced the coil. bad when you buy something from wal mart and have to get it fixxed before you can use it. now it works fine

Apr 23, 2013 | Cars & Trucks

1 Answer

My 2004 Dodge Neon won't start. I can barely get it started to very rough idle.


how low was oil,I heard one car do not start no oil.spark plugs,air filter,fuel filter,coils module.

Feb 26, 2013 | 2004 Dodge Neon

1 Answer

Won't start after sitting yesterday and lastnight in cold


remove a spark plug and reconnect its cable, sit it on engine and crank. do you see a spark on the plug?

Dec 20, 2012 | 2004 Ford Explorer Sport Trac

1 Answer

My 2004 would cut off at idle,but start again after a min or so. But time it ran and cut off after a mile. Now it won't start at all. Won't turn over. It will move somewhat when I turned it by


No.
The crank sensor tells the computer when number one cylinder is at top dead center to find the timing for the spark plugs.
If the engine will not crank with the starter, the starter, key switch, battery or cables could be faulty.
Some of these items could also cause it not to start.
If the engine is stuck you won't be able to turn it at all.

Jun 28, 2012 | 2004 Jeep Grand Cherokee

1 Answer

She ran out of gas and now she won't start. what is the fix


First check fuel pressure if its not within specs replace pump.If fuel pressure is good then check for spark at the spark plug this should tell you if your problem is in the ignition system or fuel system.

Jul 14, 2011 | 2004 Honda CR-V

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...