Question about 1994 Ford Ranger Supercab

Open Question

1994 ford ranger oil dipstick

Checking my engine oil and the dip stick came right out of the block , where is the hole located at ?????

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 12 Answers

SOURCE: 93 ford probe

your oil pump may be going out,as for the tapping try lucas oil treatment with your next oil change

Posted on Jul 07, 2009

  • 63 Answers

SOURCE: 1994 ford ranger 2.8 v6 engine automatic 4 wheel

That could Be caused by the TFI module Located on the side of the distributor its grey module that requires a special tool to remove the two screws

Posted on Aug 13, 2009

  • 2002 Answers

SOURCE: my ford zx2 2003 has the dip stick broke off

Replace the dipstick probably at a scrap yard,they needthe year and engine size. The broken off tip will usually come out with your next oil change.Hope this helps.

Posted on Aug 15, 2009

  • 1114 Answers

SOURCE: engine oil capacity

Looks like it takes 6 quarts w/ filter. Check out the info;

Posted on Aug 16, 2009

  • 359 Answers

SOURCE: 83 Ford F350 Diesel Dually Smoking from oil

I have an old IDI 6.9 diesel. They tend to burn oil, and that would be normal. Just keep a check on your fluids, and unless the smoke is excessive it should not be a problem. I must say though, I personally think the IDI's were the best diesels ever built. They last forever. If you really want to treat your truck to a nice treat, after you fill your tank, dump a quart of auto trans fluid in the fuel. The additives, cleaners,and lubricants in the trans fluid really help to clean all the carbon and build up out of the injection pump, and clean the gunk from the valves and cyllinders. I usually do it every other month or so.

Posted on Jan 21, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Where is the oil dipstick on a 4 cylinder 1999 ford contour

It took me and 4 ppl to find it, but when you lift the hood of vehicle, it's right in the middle in front of the engine, but behind the radiator. If you still don't see the 'OIL' dipstick top it's probably because it broke off and is just a little rubber nub. I've replaced 3 dipsticks in the 2 years I've had mine. They are horribly flimsy and right smack in the middle of the car where it is always being leaned on, etc. The original dipstick from the Ford Co. is all black also which makes it very hard to see. It's nothing but a teeny hole with a teeny stick with 'OIL' in black written on it. Good luck. I know it's ridiculous.

Jun 03, 2014 | 1999 Ford Contour

1 Answer

Where do i locate my whole for my oild dipstick tube?


Apr 14, 2011 | 1994 Chevrolet S-10 Blazer

1 Answer

Want to learn how to check transmission fluid on my ford mustang 1994

At the rear of the engine locate the dip stick going into the transmission case, it look like an oil dip stick. Pull it out and wipe clean. Re-insert pull out and read the fluid level at the bottom of the dip stick. Do this with engine off and on a level surface.

Dec 12, 2010 | 1994 Ford Mustang

4 Answers

How do I check the transmission fluid in my 2001 cadillac catera

There is no dipstick on the 01 Catera or any Catera for that matter (97 to 01) also same transmission used on 3 series BMWs.

I have 2 - 2001

It's a sealed transmission. There are fluid drain plugs, one at side of the tranny and one at the bottom. Jack the car up from the front on a level surface. Place a hose to a funnel and remove the top filler access plug (the side one). Insert the hose here and fill the funnel until fluid leaks out the side hole (make sure you have a catch pan). Then drop the car and let the excess fluid level out from the fill hole. Raise the car again and wipe away the excess fluid and re-install the filler plug.

Jun 19, 2010 | 2001 Cadillac Catera

1 Answer


you have to locate the tranny dip stick and pull it out- then get a funnel that will fit down the hole- and slowly pour in tranny fliud. check level by putting dip stick back in (allow time for fuild to drip down out of the tube) make sure engine is running and is warmed up while reading fluid level on dipstick. Make sure it is the tranny dip stick and not the oil dipstick. oil is usually yellow and says oil on it- Trans is usually red.

Dec 02, 2009 | 1994 Eagle Talon

2 Answers

Engine oil capacity for 1994 e350 460 engine. I put in 5 quarts with new filter and the dip stick reads right where it should. Somebody told me to use 6 quarts and the dip stick will read a little over...

I actually was just speaking about this with a Jiffy Lube rep. He claims that some of the larger(yours being the largest) 8 cyl. engines can take up to 7 quarts US. Best to call Ford service and get the exact amount. When you do take a hacksaw, while the truck is on level ground and scribe the dipstick lightly right where the level is.

Aug 16, 2009 | Ford E-350 Cars & Trucks

1 Answer

Wheres the tranny dip stick

If it is an automatic, the end of the dipstick should have a yellow plastic handle which should be located to the right rear of the engine compartment (facing car). If it is a straight drive, there is no dipstick. You will have to find the fill plug and take it out. The gear oil should come up to the fill hole.

Feb 23, 2009 | 1997 Chevrolet Cavalier

1 Answer

Location of auto trans dip stick on 91 Ford Tempo 4 cyl.

It's right next to the air filter and behind the radiator fan and to the right of the oil dipstick. The transmissions is black and the oils is yellow. If it's a manual, there's no dipstick there. If not check close to the forewall towards the back of the engine.

Feb 02, 2009 | 1991 Ford Tempo 4 Door

1 Answer

The oil dip stick tube was out of the block

will be on driver side rear location you will need to get under car and feel around you will find the hole in that area then you can replace the dipstick housing

Dec 15, 2008 | 1995 Ford Mustang

2 Answers

Oil pressure sensing switch location

The oil switch is located on the passenger side of the truck in the back of the engine. Look for the transmission dipstick, then feel for it between the transmission dipstick and the engine block. It is hidden pretty well, but a socket wrench will fit to take it off. The new part uses a 1-1/16 socket, the old part for some reason was smaller, I think 13/16 inch. Hope that helps.

Oct 26, 2008 | 2000 Ford Ranger SuperCab

Not finding what you are looking for?
1994 Ford Ranger Supercab Logo

Related Topics:

93 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

77194 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers


Level 3 Expert

5579 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides