Question about Cars & Trucks

1 Answer

2005 GMC Savana. Rail lights don't work properly.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers

Check any ground wire you can find. They may have gotten corroded and no longer grounding properly.

also I would check both fuse boxes and make sure there aren't any blown fuses.

Posted on May 10, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

pippall
  • 1486 Answers

SOURCE: 2006 Ford Ranger. Rear passenger side tail light

Bad earth connection.Clean or replce wire.

Posted on Jun 18, 2009

  • 52 Answers

SOURCE: Both my back up lights on my 2004 Jeep Grand

If you are sure it is not corrosion at the bulb sockets then it could be the back-up switch at the transmission.

Posted on Jul 08, 2009

  • 108 Answers

SOURCE: windo motors wont work

You need to check the fuse, as well as the switch. Your going to need a wiring diagram of the window switch in the driver door, and a multi meter capable of checking voltage and ohms (resistance). You need to verify power to the switch, as well as off the switch, and to the motors. Make sure the switch is grounding. Many window motors are run off the driver switch where the other switches piggy back the driver switch and only working if the driver switch is sitting in a neutral position. You can always try changing the switch straight out. They can rust and corrode rather easily being located in the door being rained on, having drinks spilt on them, even if the driver gets in wet or sweaty.

Posted on Jul 17, 2009

  • 561 Answers

SOURCE: 2005 Jeep Liberty Sport. Headlights. Passenger Side is dim

TEST
remove both bulbs from the lamps but leave them on their wires switch on and see if the bulbs are still different brightness if not they the passenger side lamp housing has damaged mirror is dirty or missalined and needs adjustment. if they are different brightness then this may be a earthing problem.


Posted on Nov 13, 2009

SOURCE: on a 2005 Jeep Liberty, the passenger headlight

there is a ground wire for both sides. follow the wire from the connector to body and clean, Test the 12 volt wire to make sure it has 12 volts. If not bad switch or bad wire or contact in the connector. Wiggle the connector first with the lights on to see if it changes.

Posted on Nov 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The reverse wire for back up camera 2005 savana


Lite green wire at the back-up lights . Were are you trying access this circuit from ? At the back up lights them selfs or inside the vehicle ? The power comes from the BCM -body control module . connector 5 pin F ! The camera i'm guessing mounts where ? inside in the back or on the bumper ? And the part that shows the picture , screen up on the dash or near ? What needs power and where ? Again , i'm guessing the screen up near the dash ! The BCM is located Lower right side of the I/P . Connector 5 is black and has 6 pin cavitys ! And the wire color is L-green

Dec 17, 2016 | 2005 GMC Savana

1 Answer

2005 GMC Savana 1500 electrical problems,acceleration


sounds like the BCM is going out on your vehicle .

Mar 03, 2017 | GMC Cars & Trucks

1 Answer

2003 gmc savana rough idle then shuts off


Does it have any power when you start moving? I've seen a lot of plugged catalytic converters. You may want to have an exhaust back-pressure test done.

Jan 28, 2013 | 2003 GMC Savana

1 Answer

How to change brakes on a 2001 gmc savana 3500


Any brake work on your vehicle, is not any different
or more difficult than most other vehicles

There is more to brake service or work, than just changing
out brake pads

If you plan on working on your own vehicles, in any area
& have never done so before,I don't see how that would be
possible

I think you know a repair shop has the experience & equip
to do that sort of work.

Sep 11, 2012 | 2001 GMC Savana

1 Answer

Head lights won't turn off 2002 GMC savana 3500


short on the switch it has gone closed circuit so cant turn off

Aug 17, 2012 | GMC Savana Cars & Trucks

1 Answer

Locating fuel filter


The fuel filter is located underneath the truck on the drivers side frame rail. You will need to raise the truck safely to get under. You will need a 21mm and a 16mm wrench. The 16mm wrench should be a line wrench so you don't ruin the hex head of the fitting.

Feb 06, 2012 | GMC Savana Cars & Trucks

1 Answer

GMC 2005 Savanna, running lights will not shut off even when the van is turned off. Switch was replaced but the lights are still on.


Interesting that this same problem has started with my 2005 GMC Savana.....they turn on by themselves and won't turn off.

Dec 05, 2010 | 2005 GMC Savana

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

110 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...