Question about 2000 Nissan Altima

1 Answer

Moteur sometime dont start

Erreur code scanner pooe1 and pooe5 intermitent problem thank's bruno

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Nissan Master
  • 5,815 Answers

TUNE UP,check battery and connection.

Posted on May 10, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Obd2 code p0562


Low battery charge, Battery Defective(Could have a bad cell), Loose or missing alternator drive belt, Faulty Alternator, Open or short system voltage circuit

Apr 11, 2017 | Mazda RX8 Cars & Trucks

1 Answer

OBD2 CODE READER P0562


fully charge battery and make sure everything switched off i.e rear window demist etc and take it for a run to get it up to tempature then park up rev engine at fast idle approx 2750 rpm for 180 seconds then take foot off throttle and allow to idle for 30 seconds this will clear your catalyst and get it up to the 600 degrees needed for it to operate properly this should remove the engine warning light

Apr 21, 2013 | Mazda RX8 Cars & Trucks

1 Answer

OBD2 CODE READER P0562


Make sure your 12V grounds to engine and chassis are good.

Apr 11, 2017 | Mazda RX8 Cars & Trucks

1 Answer

My S-type will sometime read restricted performance,ABS brake, engine fault,air bag and the engine light will be on dash bored-the car will not exceed over 15mph-if vehicle is park for 15 min of longer-...


its sounds like its between the oxygen sensor..and your throttle body sensor..Normally the difference between the oxygen sensor it will display all these things except the dsc mil.Make sure that you dont wash the engine caompartment near the firewall,this can lead to water getting into the TBS and cause the sensor to go bad,and also near the MAF in the air cleaner elbow.Water can short this sensor.But intermitant restricted performance can show do to a knock sensor malfunction also it will code p0327 or the oxygen sensor.Go by Antozone let them scan the car for codes and freeze frame data.The Actron obdii scanner does well with Jaguars.

Aug 05, 2011 | 2003 Jaguar S-Type

1 Answer

My Break, ABS and Trac warning lights all come on at the same time. I can shut the engine down and restart the issue goes away. I t seems to be happening more frequently. My mechanic found nothing wrong...


Nothing wrong. Doesn't that seem strange to you

The ABS & Trac came on because that system has issues

There may be stored data, if not a code present

The mechanic has to component test to find the problem

These guys spend too much time with a scan tool & I
think some of them are waiting for it to tell them something

Doesn't work that way. If everything goes as it should, the
scanner shows what the computer sees,that's all,& that can
be a lot,but you have to move on & use different skills that
not everyone has learned yet apparently

Try another shop

That really isn't a diagnostic test etc,just looking at data
stream,if they see nothing out of range they quit

That doesn't help you any,the problem is still there,intermitent
maybe, but there.

Jun 26, 2011 | 2001 Ford Windstar

1 Answer

My 2001 gmc safari brake and abs light comes on . when I stop and restart the engine sometimes it doesn't come back on for a period of time


There's an intermitant fault in the ABS system, you will need a scanner to read the codes from the system.

May 01, 2011 | 2001 GMC Safari

1 Answer

Radio will not turn on --second day of ownership..had " battery in save mode? " message this am & none of the dash/signal lights would work ..? then the dash & heater control lights and...


You need to take it an have a factory or professional scanner hooked up an have it checked for DTC'S - diagnostic trouble code's . All the electronic's on your vehicle , control module's , communication networking etc... Is the first place to start a diagnostic procedure . A factory scanner can check for DTC'S in all the modules on the vehicle , not just OBD 2 engine code's . Your vehicle has 15 to 20 different control module's . All light's are controlled by the SJB - smart junction box , ford's body control module . Do you know anything about automotive electronic's ?

Jan 05, 2018 | 2011 Lincoln MKX

2 Answers

Engine light on intermitting power loss


Take it to Advance auto or Auto zone, let them connect a scanner, (free of charge) , they can read the codes & most cases tell you what part or system is failing.

Sep 09, 2009 | 2007 Ford F-350 Super Duty XLT

Not finding what you are looking for?
2000 Nissan Altima Logo

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

80417 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...