Question about Cars & Trucks

1 Answer

Fuse in GE Microwave model

How to replace the fuse>

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 80,608 Answers

You are in the car and truck category, please select correct product category and re-post.

Posted on May 09, 2013


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is exact location of low beam driver side fuse 2007 Sentra ?

Revision: December 2006
2007 Sentra
1. Turn ignition switch OFF.
2. Disconnect IPDM E/R connector.
3. Check continuity between IPDM E/R harness connector (A) and
headlamp harness connector (B).
OK or NG
OK >> Replace IPDM E/R. Refer to
PG-30, "
Removal and
Installation of IPDM E/R
NG >> Repair harness or connector.
Headlamp Low Beam Does Not Illuminate (One Side)
Inspect 15A fuse [No. 40 (LH) and No. 41 (RH) located in IPDM E/R].
OK or NG
OK >> GO TO 2.
NG >> Repair harness

Jan 27, 2016 | Cars & Trucks

1 Answer

Dtc codes

Anti-Lock ControlPinpoint TestsPinpoint Test F: DTC C1266Refer to Wiring Diagram Set 42, Vehicle Dynamic Systems for schematic and connector information. See: Electronic Brake Control Module > Removal and Replacement > Anti-Lock Brake System (ABS) Module. TEST the system for normal operation.NoVERIFY BJB fuse 109 (20A) is OK. If OK, REPAIR circuit 483 (RD). If the fuse is not OK, REFER to the Wiring Diagrams to identify the possible causes of the circuit short. CLEAR the DTCs. TEST the system for normal operation. See: Vehicle > Electrical > Diagrams By Number------------------------------------------------- 7e31ae16-fdd7-4a46-aeb5-da4950e51178.jpg - - Disconnect: ABS Module C135. Measure the voltage between ABS module C135-25, circuit 483 (RD), harness side and ground.
if voltage is greater than 10 volts replace abs module if not
check fuse described in upper section if fuse is bad replace if it blows again you need to check wiring

Apr 21, 2014 | 2010 Ford Crown Victoria

1 Answer

Toyota land cruiser 2001 fuse box EMI fuse issue.

the issue is definitely power feed short disconnect all accesory fuses to rule any accesories out and try listed fuse again if fuse pops with all accesory fuses out >>>>>>>>>>reccomend a good autoelectricain rather take a look>guessing or taking a chance of blowing or burning a component could be costly

Jan 13, 2014 | 2001 Toyota Land Cruiser

1 Answer

Where is the fuse on a goldstar mv1502b 01 microwave?

I found the fuse on my microwave under the cover. look for inline fuse I think mine was a 15 amp fuse yours should be marked.

Oct 04, 2013 | Cars & Trucks

2 Answers

I dont have the fuse diagram of my Ford Windstar and need one to fix a electric problem.The plate lights does not turn on, and need to know if the fuse is good, and first wich one is it.

I think you would have other problems if the fuse was gone. the fuse you need to find also control the Left turn lamp, right park lamp & the right stop lamp. It also controls both sides of the plate. The fuse if you want to check it is in the # 7 position in your fuse box. It would be in the second row of fuses under the relays and it will be the fartest one on the left side (The first one in that row). It's a 15 amp fuse. I'm not saying your stupid but just want to be sure that you know that the fuse panel is on the left side of the steering wheel by the brake pedal. Just wanted to be sure. I hope this helps and good luck

Feb 12, 2011 | 1999 Ford Windstar

1 Answer

Fan blows fuse

i am sure the fan is burned up is there any writing on the fan saying how many vdc or vac

May 10, 2010 | 2007 GMC Yukon

1 Answer

What size fuse goes in position #4? What are

From the Jeep TJ Wrangler 2004 - Owners Manual (Section 7, Page 255):
Fuse 4 -->> 10 Amp Red -->> Door Switch Defeat
Fuse 16 -->> 10 Amp Red -->> Headlamp Aim (Export only)
Fuse 20 -->> 20 Amp Yellow -->> Transmission: Manual - Clutch Interlock switch by-pass Automatic - Ignition Starter Circuit

I really hope helps with this (remember rated this help). Good luck.

Dec 16, 2009 | 2003 Jeep Wrangler

1 Answer

Need fuse diagram from 1998 Jeep Grand Cherokee. Don't have owner's manual. The fuse box under hood has words on it, but not the one inside on passenger's side near floorboard

Check several documents about this:

1. 1998 | JEEP | GRAND CHEROKEE Go to
- User: greatfalls / Pass: publiclibrary
- Select Auto Repair Reference Center>> 1998>> Jeep>> Grand Cherokee>> Model
- Repair Procedures
- Chassis Electrical>> Circuit Protection

2. Engine Fuses

3. ZJ-Secc-8W-Wiring-Diagrams

Good luck!!!

Jul 19, 2009 | 1998 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

80608 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

15387 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides