Question about Cars & Trucks

1 Answer

Installing an elec. fuel pump

What is the best way to install an electrical inline fuel pump on a 1987 Isuzu Trooper. I am having the most problems with electrical hookup.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 21,873 Answers

Normally you would use a relay, and have something that is controlled by the key switch signal the relay to turn on.

Posted on May 09, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

losflip
  • 94 Answers

SOURCE: fuel pump

On all Trooper II models the fuel pump is located in the fuel tank, fuel tank must be removed to access.

Posted on Nov 26, 2008

  • 5 Answers

SOURCE: I have 1987 Mazda B2200 2.2 ltre, turns, fires, no fuel psi.

I had something like this before. There is a fuel saftey switch near the gas tank right by the rear end. Its a roll over sensor and mine fell off the mount and I guess the truck thought it was upside down :)

Posted on Jan 01, 2009

  • 2 Answers

SOURCE: fuel filter change out in 2002 isuzu trooper

easy under the driver side need fuel tool from auto store. 30 min or srew driver push the clips in and pull. carefull lots of gas...

Posted on Jan 09, 2009

  • 1 Answer

SOURCE: isuzu 2001 diesel engine won't start

cant start deisel 3.0 lilter sounds like there is no fuel getting to the engine

Posted on Feb 15, 2009

simontricket
  • 235 Answers

SOURCE: 02 isuzu trooper

Need a bit more information to go on as there is no injector pump on a 4JX1 its a rail type engine .
You can get flash codes to come up on the engine check light from the OBDII socket by connecting pin 4 to pin 6 and turning the key to ign on . the light will flash - count the flashes gonna be something like 4 then 3 and maybe some other depends on how many faults you got.

If you get none then try my tips .

Posted on Dec 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My isuzu trooper won't start after running out ov diesel changed filter still won't start what else can I do


You need to fill the fuel filter before installing it then you need to bleed the entire fuel system of air. There should be bleed screws and a hand pump to do this.

Dec 07, 2015 | Isuzu Trooper Cars & Trucks

1 Answer

My 1994 Isuzu Pickup wont start when its below 32 degrees. Ive changed the gas filter, fuel pump, it just doesnt want to start when cold.


Below 32 degrees ( Fahrenheit , I presume) can cover a wide interval of temperatures. It could be the battery. You should consider installing a battery with a higher cranking power. In the colder parts of Canada, people install an engine warmer contraption. The device is kept connect to an electrical outlet overnight. In some places, it gets so cold that electrical outlets are available at some parking spots.

Dec 12, 2013 | 1990 Isuzu Trooper

1 Answer

1988 Isuzu Trooper II LS 4dr/4wd I changed fuel pump and inline filter about month ago, it will run but only if i keep it runinning with gas peddle at high rpms, will not idle as soon as I stop with...


Hi,
That looks like air in the fuel system. Bleed the fuel system by loosening the bleeder nipple, pump the bleeder( top of the fuel filter cartridge ) remove any bubbles that comes out from the bleeder, if there are no more bubbles tighten the bleeder and start the engine.

Hope that helps you out!

Aug 07, 2011 | Isuzu Trooper Cars & Trucks

1 Answer

It will only run when u squirt gas in the carb it runs good then but once the gas is gone is shuts off


You need to replace fuel pump, which is electric and located in fuel tank. You need to drop the tank to replace.

Feb 18, 2011 | 1987 Isuzu Trooper

1 Answer

My 1990 isuzu troopers fuel pump is constantly running and making the battery go dead even though the key and engine is off. What can be the problem?


Bad switch or someone has bypassed the switch, should shut off when you turn ignition switch off, my 94 does. HUNT

May 14, 2010 | 1987 Isuzu Trooper

1 Answer

My 1990 isuzu troopers fuel pump is constantly running and making the battery go dead even though the key and engine is off. what can be the problem?


start with pulling the fuel pump relay!!
this should kill the power to the pump and save your battery,
so well pulling the fuse but pull and test the relay,, it may have got to hot. if it checks good and clicks when you plug it back in!![key off]
then there is a short in the ignition to relay circuit

Mar 25, 2010 | 1987 Isuzu Trooper

1 Answer

How to instal a fuel pump of a isuzu trooper 92?


I have a isuzu rodeo, i dropped tail gate removed carpet, i then located fuel pump from under truck, i took a jig saw and cut an opening through deck fuel pump is located on top of tank, it sounds messy but you can save a lot of money and time, after replacing pump silicone piece back in

Sep 16, 2009 | 1992 Isuzu Trooper

1 Answer

Need help replacing wires on dist cap 1987 4 cyl Trooper


Firing order is stamped on the block intake manifold or label. 4 cyl are typically 1324

From the web:
The firing order for four cylinder engines where the cylinders are in-line is 1243 or 1342.
Those are the only two possibilities I've ever found for inline four cylinder engines. In practice, it's almost always 1342, except for Ford engines which are 1243.


Take one off at a time and replace it

Do not run the wires parallel (side-by-side) for more than 6". Cross them over each other wavy-like if needed. This will prevent crossfire.

Replace Points, Plugs, Condenser, Rotor and Cap too.

Good luck!

Mar 27, 2009 | 1987 Isuzu Trooper

1 Answer

1991 Iuzu trooper no gas


Check your fuel pump relay.

Mar 17, 2009 | 1991 Isuzu Trooper

1 Answer

1987 Isuzu Trooper fuel, alternator, brake warning lights stay on


Hi Guys,

Have you finally sorted your problems. I think it might be a faulty alternator on its way out.

Could you please be kind to let me know. I have the same problem and just need to be sure of what to do.

Cheers guys

Mar 07, 2009 | 1983 Pontiac Grand Prix

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...