Question about Cars & Trucks

1 Answer

Tail lights left turn signal

Left tail lights staying on and left turn signal staying a solid green and not working but I can hear a faint clicking whn activated

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 36 Answers

Need a new flasher they fail a lot

Posted on May 09, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 509 Answers

SOURCE: Turn signal not blinking . Stays lit bit no

It could be your flasher relay going out. Should be under the dash.

Posted on Jan 06, 2010

reichweinj
  • 71 Answers

SOURCE: 2006 Chevy Trailblazer Tail Lights

There was a recall on this, take to the dealer and they will replace the whole socket on this.

Posted on Nov 10, 2008

dgjtex
  • 405 Answers

SOURCE: left blinker light stays on solid when headlights are on

I have had this happen and it is rare, but I have had a filiment burn out in a two filment buld and short to the other filiment. It does happen and I think this might be your problem, the only way to find it is a visual inspection of each bulb. I am sure many people will think this is crazy, but I have had the exact same problem, I had the schematics, tested the circuits,etc. and them by accident found a stop/blinker 1157 bulb that had done this exact thing. I hope this helps you, check the bulbs in your headlights also.

Posted on Dec 27, 2008

  • 1779 Answers

SOURCE: 1998 ford taurus left turn signal blinking fast

Replace the bulb that stays on and doesn't blink, if that doesn't solve the problem, let me know.

Posted on Apr 13, 2009

joecoolvette
  • 5660 Answers

SOURCE: my turn signal lights wont work on my 95 firebird formula

Go under the dash on the drivers side, and locate the two flasher stat units. These are small round aluminum 'cans'. They plug in, and have flat blades on the bottom. (You of course won't see these flat terminal blades until you unplug them)

One is for the turn signals. One is for the four way flashers. I can't tell you which one is which.

Past this point, check all the grounds for the turn signals. The wiring harness at the front will have one, or two leads, (Wires), coming out that bolt directly to metal. Either sheet metal for the car, or to the frame. These leads have flat, round terminal ends on them, with a hole in the middle of the terminal.

The lead's terminal end bolts can work loose causing a bad ground, and/or, there could be corrosion in-between the terminal end, and the area of metal it bolts to. If so, use sandpaper, and clean the terminal end, plus the area of metal it bolts to.

There are ground leads, (Or lead), that come out of the rear wiring harness also. Check these.

Still no?
Then your turn signal bulb sockets have corrosion in them. This causes a bad ground.

You may be able to use a rolled up piece of sandpaper, and clean the socket.
(Also touch up the lead, {LED. As in the metal lead}, contact point in the middle of the socket. This is for the Positive connection, but it doesn't hurt to clean it while you're there.

After this is the turn signal switch in the steering column.
(My money is on a bad flasher unit)

Posted on Jul 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Turn signal not working


TAIL LIGHT NOT WORKING

It can be faulty tail light bulb or its issue with tail light control switch or its wiring's are short.

Check the voltage at fuse slot of tail light.Do you receive 12 volt there.If not,then it says tail light switch is not receiving power supply.


---------

There are few help links related to your problem.I suggest you refer the list and check the help links.Click the link below:-----




Turn Signal Not working

http://technoanswers.blogspot.com/2012/11/turn-signal-not-working.html

----------

Right turn signal not working on Pontiac Car?

http://schematicsdiagram.blogspot.com/2011/12/right-turn-signal-not-working-on.html

--------

Only one side indicator light working on car?

http://schematicsdiagram.blogspot.com/2011/12/only-one-side-indicator-light-working.html

-----------

Turn signals not working on 1987 Jeep Wagoneer?

http://schematicsdiagram.blogspot.com/2011/12/turn-signals-not-working-on-1987-jeep.html

-----------

SOLVE YOUR 4 WAY FLASHER RELATED PROBLEMS HERE

http://repairhelpcenter.blogspot.com/2012/11/4-way-flasherturn-signal-flashersignal.html

----------

1994 Toyota Camry: Bypass Tail light Relay Circuit?

http://whatisbyme.blogspot.in/2012/04/1994-toyota-camry-bypass-tail-light.html

-----------

2008 Toyota RAV4: Replace Tail light Lens Cover?


http://technoanswers.blogspot.in/2012/04/2008-toyota-rav4-replace-tail-light.html

--------

2003 Chevrolet S10 Tail light Fuse

http://schematicsdiagram.blogspot.com/2012/11/2003-chevrolet-s10-tail-light-fuse.html

---------

Chevrolet Parking light and Tail lamp light Wiring diagram

http://schematicsdiagram.blogspot.com/2012/11/chevrolet-parking-light-and-tail-lamp.html

----------

Car Tail Lights Not Working?

http://schematicsdiagram.blogspot.com/2011/12/car-tail-lights-not-working.html

----------

These details will help.

Thanks.

Feb 15, 2013 | 2004 Pontiac Grand Am

1 Answer

Right front side turn signal does not work replaced all bulbs and checked fuses headlight flashers work when hazards are on front to back except driverside turn signal ,in dash right stays solid left


I don't believe it would be a bad ground for just one light. It could be a wire, a socket connector, or the bulb socket itself. See if the wire has power at the socket when signaling left, with key on. If there is power, probably a bad socket or connector. If no power, check for power coming from flasher-the wire going to front left, or driver's side. If you have power from the flasher, but nothing at the socket, the wire has probably broken.
Good luck.

Feb 06, 2013 | Cars & Trucks

1 Answer

My right turn signal isn't working correctly. When I'm driving down the road my dashboard indicator for my right turn signal will turn solid green but wont flash, But when i turn my...


I had the same problem on a 92 & 95 Dakota years ago, replaced the turn signal switch in the column & found a loose ground wire in the harness back by the tail lights. Never had a problem again. If you're gonna try to replace the switch you will need tamper proof torques bits just FYI. Good luck. Let us know how it turns out.

Nov 07, 2012 | 1995 Dodge Dakota

1 Answer

How do i remove the sensor for the rear tailgate?


1) Locate and remove sensor.
The sensor is located under the drivers tail light. Unclip it from the body and then unplug it.

2) Bypass the tail light circuit.
Connect the tail light signal wire (Green) to the tail light wire (Green w/ Red Stripe). I recommend using wire tap in squeeze connectors that way you dont have to cut any wires.

3) Bypass the brake light circuit.
Connect the brakelight signal wire (Green w/ White Stripe) to the brake light wire (Red w/ Blue stripe) and the the 3rd brake light wire (Red w/ White Stripe). Again all three of these wires are to be connected together.

4) Throw away your broken Tail Lamp Failure Sensor
Do not plug your sensor back in. Doing so will cause the annoying orange lamp failure warning light on your dash to stay on. Leave it unplugged ant the light will stay off.

5) Test your work
Turn on your lights and make sure your tail lights work properly. Have a friend step on the brake pedal, and make sure your brake lights work properly as well. Dont forget to check the Third brake light.

Sep 20, 2012 | 2002 Chrysler Voyager

1 Answer

1993 Buick Century Turn signals don't work.


sihelp megnals do not work car will not start with key i jumped starter with screwdriver started right up

Feb 25, 2011 | 1993 Buick Century

1 Answer

No trailer turn signals tail lights work . you


If it is a factory trailer package then there are fuses for the left turn signal and the right turn signal for the trailer connector. Check your owners manual for the location of these two fuses.

Bob

Apr 21, 2010 | 2002 Ford Explorer

1 Answer

Right Turn Signal not flashing.


quick fix,try to run jumper wire from solid lime green wire to tail light green/orange wire Your problem is no power

Apr 21, 2009 | Plymouth Acclaim Cars & Trucks

2 Answers

2001 Explorer Sport ,Rear Driver Brake Light and Turn Sig. Broke


Rear lights are double filament bulbs one side for the lights other side for the brake/turn signals so it still may be a bulb. Do u have a test light or volt meter you can check to make sure u have power there when brakes or turn signals are activated. Or just try another bulb.

Feb 12, 2009 | 2001 Ford Explorer Sport

1 Answer

Possible short?


Check the ground connections, front an back. A short will pop a fuse. A bad ground will only handle so much power, then it becomes an open curcuit. Frankster016

Oct 24, 2008 | 2000 Dodge Durango

1 Answer

Turn signal/hazard light inoperable---left front only


I recommend replacing the pig tail that holds the burnt signal bulb.  These tails are available at most auto parts stores for about $10.  Coat the contacts for the bulb in dielectric grease to prevent reccurance.  I have done this several times, cheap, quick and easy.  This is a very common problem on F-bodies, just take note as you see them driving at you on the highway with one DRL on and one off.  Good luck.

Jul 14, 2008 | 1999 Chevrolet Camaro

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...