Question about Ford Fusion

Open Question

When i try to start my 2007 ford fusion it makes a long loud beep until about 5 seconds after i stop holding the key to start, what is causing this issue? and how do i fix it? is it the battery? eve

How do i fix the long beep sound when i start my ford fusion it doesnt start though. is there a switch or fuse the might be hit or blown or something? anybody know?

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75822 Answers

SOURCE: shuts off while driving. no fuel pressure. pcm fuse blows/ fuel pump relay inserted.

Sounds like the fuel pump is shorted.

Posted on Nov 03, 2008

  • 1 Answer

SOURCE: my 2007 ford fusion wont start

ford has a fuel shutoff switch in the trunk
It sound like it needs reset
open the trunk and check it out on the left side

Posted on Nov 27, 2008

  • 1 Answer

SOURCE: 1996 Ford Taurus Making a beeping sound

Mine beeps like that as well if I don't put my seat belt on. The seat belt light comes on for about a minute then shuts off and a few seconds later it starts beeping without any lights coming on. This may not be what your problem is but I was wondering why mine did the same thing and I figured out if I didn't have my seatbelt on that's when it would beep like that. The seat belt light had already shut off and wasn't blinking or anything so I didn't realize that's what it was right away.

Posted on Jun 13, 2009

  • 1 Answer

SOURCE: jeep keeps blowing auto shutdown fuse

Yes I had the same problem. The wires that plug into the sensor at the catatytic converter were rubbing against the drive shaft untill they finally wore through causing the short against drive shaft. repaired wires and it fixed everything

Posted on Mar 25, 2010

  • 2309 Answers

SOURCE: Ford fusion 2007, blown blower fuse, replaced

hte blower resistor is shot, near the blower motor, have the blower motor checked my guess is that it requiring too much power to run, hence the blown fuse

Posted on May 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Had ticking sound started up this am loud pop then rough running like there was no muffler


Ford Windstar Starting/Stalling Problems - Car Forums at Edmunds.com

forums.edmunds.com > Ford > Ford Windstar

Oct 16, 2007 - 31 posts - ‎26 authors
Learn more about Ford Windstar at the Edmunds.com Car Forums! ... I tried to startmy van on a 15 degree morning - heard a loud bang and now it won't start. Battery ....The engine will crank, start run about 5 seconds then stop. ... I have a 2003 Ford Windstar, same problem,Ford is covering up the problem.

Why My Car Won't Start? - Reasons and Solutions

www.myautorepairadvice.com/car-wont-start.html
As a rough guideline, problems with the battery, alternator and starter are the most ...Before I even put the key into the ignition I hear a clicking noise on the right side ...started it and then it started making a loud clicking noise while I was driving it ..... i have a 2003 windstar ford it was clicking and wouldn't start had to get a ...

Rough Idle Engine Dies Loud Ticking!?! Please Help! - Ford Focus ...

www.focusfanatics.com/.../103146-rough-idle-engine-dies-loud-ticking-...
Nov 6, 2006 - Rough Idle Engine Dies Loud Ticking! ... down then dies and then i restart and it has no problems but the ticking continues PLEASE HELP ME ... Level Up0% Completed ... 2. my injectors are bad and the ticking sound is one of the injectors.... Another method is to turn the AM radio on to a place where there ...Missing: windstar

Jan 08, 2016 | 2003 Ford Windstar

1 Answer

Key stuck in ignition in park. Check charging system comes on. Dealership says it might be a fuse.


Key Stuck in Ford Fusion (2006 model) - YouTube

? 1:21
https://www.youtube.com/watch?v=3LVQttFOzGA
Jun 18, 2014 - Uploaded by Jessica East
#Ford #Fusion #Key #ignition #Stuck #FordFusion2006. ... i have a 2006 mercury milan and my key got stuck in there last night,... it to park with a little bit of force. will see what happens next time. good video, nice to know.

Key Stuck in Ignition While in Park

www.2carpros.com/.../2007-ford-fusion-key-stuck-ignition-while-park
Dec 16, 2012 - KEY STUCK IN IGNITION / SHIFTER BINDING CONDITION FORD:2006-2007 Fusion LINCOLN: 2006 Zephyr MERCURY: 2006-2007 Milan

Nov 06, 2015 | 2006 Mercury Milan

2 Answers

2014 ford fusion engine wont crank after wreck


Ford fusion won't start - YouTube

? 2:01
www.youtube.com/watch?v=H0BhHWT2cyY
Sep 16, 2014 - Uploaded by mlmunoz21
Ford fusion won't start ... Published on Sep 16, 2014 .... 2004-2008 F150 Died Out No Crank Theft Light ...

Ford Fusion won't start - YouTube

? 0:32
www.youtube.com/watch?v=lmH7R6Ebmyc
Jan 9, 2015 - Uploaded by Nicholas A.
Any ideas why it won't start? 2007 ford Fusion awd 6 cylinder. ... And P1260 2007 Ford Fusion - Theft ...

Nov 02, 2015 | 2014 Ford Fusion

1 Answer

My ford excape sounds the horn once loud and locks the doors like it's going to start then just beeps 3 times loud plz help


Try resetting your remote device by holding it near the front drivers side and press and hold the emergency button until the horn blows once. See if that does the trick.......

Nov 08, 2014 | Ford Escape Cars & Trucks

1 Answer

My key remote to lock the doors suddenly stopped


hi yes this can be done, here is how
make sure you have all keys ready to reprogram close all windows and doors insert key into drivers door lock within 5 seconds of putting key in door lock turn key to unlock position 3 times this puts the key into programming mode ( door led should be on ) press and hold lock button, within 5 seconds of holding lock button press unlock button 3 times ( keeping lock button pressed at same time) then release lock button that should be it...to make sure correct programming is achieved key led flashes 5 times, and door led flashes 6 time, if you have more than one key do same as above within 15 seconds of doing the first key..
phew..lol, well i hope that will work for you..please vote thanks

May 14, 2010 | 2007 Ford GT

1 Answer

My 06 Ford Fusion has trouble starting on these colder mornings. After 4 or 5 tries, it will fire and starts normally each time after.


When you put the key in, turn it to run and pause before turning it to start. Pause it until you hear a humming noise at the run position that stops. Then turn the key to start. What that does is allows the fuel pump to fill up your lines and make it a little easier to ignite. Also consider a new battery.

Dec 21, 2009 | 2006 Ford Fusion

2 Answers

Spare Key will not start the car.


I am sorry to tell you but you have to have it made
at the dealer and it isn't cheap.

Mar 20, 2009 | 2007 Ford Fusion I4 SEL Sedan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...