Question about Cars & Trucks

Open Question

1991 mazda miata manual window regulator

I need step by step instructions on how to replace the passenger side manual window regulator on a 1991 mazda Miata mx5

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 109 Answers

SOURCE: 1990-Mazda miata

you have to reset your computer..it is kind of tricky..you have to pump the gas pedal three times on the third time hold it to the floor turn the ignition to on position then off then start the car it should reset it..

Posted on Dec 04, 2008

Ad
  • 1 Answer

SOURCE: Miata has 61000 miles want replace timing belt to be on safe side

California has a law that Mazda guarantees the timing belt will last 105,000. I drove my 1999 Miata that long before I replaced it. Mazda ia a non interactive motor which means that if the belt breaks the car stalls and won't go anywhere. No damage to engine if it breaks.

Posted on Apr 01, 2009

  • 1 Answer

SOURCE: 99 Mazda Miata Alternator Belt Replacement

there is one large bolt 13mm i think near the top and the tensioner on the side. just loosen that baby and push the alternator and take off the blet

Posted on Apr 17, 2009

Healeyman
  • 1198 Answers

SOURCE: 2002 mazda miata mx5 has strong gasoline smell in

The fill pipe is right back there. Check to see if a hose has been damaged. Check the spout area, is there a overflow pipe or a seam that could be leaking into the trunk?

Posted on May 10, 2009

  • 1986 Answers

SOURCE: Can't find the adjustment knob for the headlights on a 2008 Mazda

The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.

You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

Posted on Sep 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Electric windows on 1997 mazda miata not working, already checked fuse


Have to remove the inner door panel,
to see if the window regulator is broken

Jul 09, 2012 | 1997 Mazda MX-5 Miata

1 Answer

1995 mazda miata no electrical power, nothing works


Most often the main 80 amp fuse is blown - happens when someone slips with a socket extension when trying to remove the battery terminals. Fuse is under the hood, passenger side and here's a diagram: http://www.mellens.net/mazda/Mazda-Miata-1997/fuses.pdf

Jan 04, 2012 | 1995 Mazda MX-5

1 Answer

Alright, I have a 1991 Mazda MX-5 Miata. I've recently had a lot of difficult shifting into gears while driving. I have to pump the clutch a few times before being able to get into gear. It's definitely...


You bleed the brakes afterward. If you but a Hayne's Manual for your specific car, it will give you detailed instructions on how to change them. It will show step by step procedures. Also, if you ask an expert, they can give you step by step procedures until the job is done properly. Sorry I couldn't help more.

Feb 05, 2011 | 1991 Mazda MX-5

2 Answers

Battery replacement for a 2001 mazda miata


HI, you will find the battery under a panel behind the seats. changing it is done like any other vech. remove the negative cable first then the positive, remove the hold down and carefully lift it out.

Aug 26, 2010 | 2001 Mazda MX-5 Miata

1 Answer

The window on the front passenger side will not go up by either the door switch from the driver or passenger side?


SOUND LIKE POWER WINDOW MOTOR GONE.YOU NEED TO REMOVE DOOR PANEL AND USE A TEST LIGHT TO HOOK TO POWER WINDOW MOTOR WIRE CIRCUIT TEST LIGHT SHOULD LIGHT UP TO SEE IF ITS GETTING POWER TO WINDOW MOTOR.IF NOT GETTING POWER YOU HAVE A SHORT IN MOTOR WIRES.IF YOU SEE OR HEAR THE WINDOW MOTOR TRYING TO MOVE WINDOW.THE WINDOW GLASS REGULATOR COULD BE BAD CAUSING THE WINDOW IN A BIND NOT MOVE.

Jun 12, 2010 | 1991 Mazda 929

1 Answer

I need to know the firing order for a 1991 Mazda Miata and a diagram for free


For 1991 Mazda MX-5 Miata 1.6 liter DOHC L4 B6 check...

c8c93ab.gif

Hope helped (remember comment and rated this).

Apr 10, 2010 | 1991 Mazda MX-5

1 Answer

Manual window winder just spinning and not opening window. My car is a Mazda MX5 Mark 1 1.8 1996 model.


You either need a new window crank itself, the inside of the crank could be stripped, you move the crank and out at it to see if the splines are wore away. Or your window regulator, inside the door, has gone bad and would need replaced.

Mar 15, 2010 | 1996 Mazda MX-5 Miata

1 Answer

Power windows wont work


All things Capri are at //www.techcapri.com/
The manuals are there - check them out ...
Wiring diagrams are there. Probably fixed by now anyway.

Regards
Richrobi

Nov 16, 2008 | 1991 Mercury Capri

2 Answers

1991 Chevy Blazer S10 window motor installation


http://www.a1electric.com/s10motor.htm. This link has pictures and step-by-step instructions. I found it and have both sides to replace. Hope this helps.

Aug 08, 2008 | 1991 Chevrolet S-10 Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...