Question about Cars & Trucks

1 Answer

How do I acess the in tank fule filter in my 2003 Honda element. I read there is an acess panel under the rear passenger side floor? Is that true or will I need to pull fule tank?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 5,645 Answers

Take back sit out and look could be.

Posted on May 08, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: fuel pump - 2003 Pontiac Grand Am

2003 Grand Am GT,You have to drop the fuel tank,remove heat shield,remove all lines,electrical plug ins,then you are ready to do straps,be sure to go get extra nut and bolts for straps (2) of them had to cut off old ones,once straps are off depending on how much gas is in the tank used jack to lower tank,fuel pump was a twist off with locking mechanisms on top of tank,used a rubber malet and screw driver to loosen,pull out after diconnecting plug ins etc,replace blue plug in for harness to fit new pump,was recommended since it could corrode,lifted tank back up connected wires,lines etc,put key in on position 3-4 times for pump to pump,car started 1st time,my first fuel pump took my son and I 2 1/2 hours,new pump $250.00 wire harness $15.00 and two new nuts and bolts $3.25

Posted on Mar 13, 2009

dr_greg
  • 192 Answers

SOURCE: Passenger side rear power window is not opening

the rear side window vent motor is bad, u need to replaced it...common on these vans...i hope its the left rear and not the right....right is a little more difficult re installing due to the rear a/c ducts

Posted on Apr 13, 2009

  • 73 Answers

SOURCE: 96 chevy tahoe, passenger side and rear cargo carpet is wet

sounds like the air conditioning drain for condensation is plugged

Posted on Apr 24, 2009

  • 1986 Answers

SOURCE: need to remove inner rear passenger side door

On the inside trim, you can remove screws (these screws may be covered by filler pieces or may be visible, or they may require you pry a plastic piece off that covers the screws) that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you need to pull back the weather seal and then you can access the bolts securing the outer handle

Posted on Nov 05, 2009

  • 1 Answer

SOURCE: where is the instrument panel fuse block located?

under the glove box, you'll set a panel with 2 plastic pressure pins. using a pair of pliers, just pull from the center and remove both of them. the entire panel will be free, and the fuse block is on the far right side, (closest to the passenger door) you'll need a good light and small hands....the engineers did NOT give you a lot of room in there!

Posted on Apr 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where to locate fuel filter on 2003 honda civic 1.7


Fuel Filter Removal & Installation To Remove:
  1. Remove fuel tank unit beneath floor access panel.
  2. Remove fuel filter from fuel pump/fuel gauge sending unit.
To Install:
  1. Install fuel filter to fuel pump/fuel gauge sending unit.
  2. Install fuel tank unit and floor access panel.

Nov 06, 2010 | 2004 Honda Civic

1 Answer

Fule pump how to install


look under rear seats or in boot floor for round inspection cover. remove screws lift cover off and disconnect wiring and fuel pipes then remove unit from top of fuel tank. fuel pump should be located at bottom of unit. MUCH EASIER WITH NEARLY EMPTY TANK OF FUEL

Jul 17, 2010 | 1997 Honda Accord

1 Answer

The engine cranks but will not start also where is the fule filter and the fule pump on my 1996 mercury sable?


The fuel filter is on the passenger side of the car back close to the rear wheel, the fuel pump is inside the fuel tank.

Apr 03, 2010 | 1996 Mercury Sable

3 Answers

Looking for 2001 grand am fuel filter location


rear of car behind fuel tank it's an inline filter in front of floor of trunk spare tire underneath car

Sep 03, 2009 | 2001 Pontiac Grand Am SE

1 Answer

Clicking coming from rear right panel in 2003 Lincoln Navigator.


it sounds like you have a door ajar switch issue if it says "door open" when it's not. Is it clicking in the passenger rear door or in the storage area behind the rear seat behind the right trim panel?
The liftgate wiring may be back there.
Your door lock & unlock relays are in the vehicle security module which is under the center area of instrument panel.
I looked at the wirng diagram and don't see too much back there.
Let me know what you find on where the clicking is coming from.
We'll go from there

May 25, 2009 | 2003 Lincoln Navigator

1 Answer

Fule pump and fule filter,s


The fuel pump is located in the fuel tank and is accessible once the rear seat cushion is removed and, the filter is located Under vehicle, driver side, below seating area, driver side of fuel tank, mounted on frame in fuel line.

Please rate and have a great day:)

May 16, 2009 | 1992 BMW 3 Series

1 Answer

Can't locate fule filter on 2003 hyundai accent 1.5


Fuel filter is under back seat. Remove back seat and there is an access panel in the floor. The fuel pump is also visable.

Apr 02, 2009 | 2003 Hyundai Accent

1 Answer

Car just shuts off, then restarts no problem


Run a fule system cleaner through ur car it goe into the gas tanks lol make sure u do it one a full tank if u are able to drive it that much

then when the tank is empty replace your fule filter its on the passenger side of the car mounted on the fram under neith the car..

im thinkin this will solve the problem for sure

the reason u wanna run he cleaner through it first is cause the old fule filter will catch all the nasty **** that hasnt already cloged your fule filter in the first place then u can take it off and pop on a new one.. remember to change your fule filter every 12,000 miles most ppl have never changed the one that was on the car when they bought it.

Jan 04, 2009 | 1996 Lincoln Continental

4 Answers

Where is fuel filter located on 2006 corolla


The fuel filter is part of the fuel pump/sender unit assembly inside the fuel tank, accessed by removing the rear seat cushion then the rear floor service hole cover.

Jul 26, 2008 | Toyota Corolla Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...