Question about 2008 Ford Focus 1.6

Open Question

Tps code p2176 - 2008 Ford Focus 1.6

Posted by Anonymous on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

2008 cadillac cts 3.6 codes showing are p2176 and p0420 what does this mean

P2176 is the Throttle Actuator Control System
See the hyperlink below for info on this code:

P0420 is Catalyst System Below Efficiency (i.e. catalytic converter on the exhaust system.)
To check your catalytic converter, get a very light, small finishing nail hammer and tap the catalytic converter lightly, if you hear rattling inside it then it's shot. If your exhaust pipes are rusted through anywhere, get it all done at the same time. You can DIY using parts from Walker Muffler... schematics are available on line, get new hangers too!

Mar 21, 2015 | Cadillac Cars & Trucks

1 Answer

Two trouble codes p0128 and p2176

Po128 is that the engine has not reach operating temperature in a calculated time frame. Most likely cause is bad thermostat or low on coolant. P2176 is the throttle position sensor has lost its learned value. Throttle bodies with electric motor controls need to know closed position to maintain proper idle speed test sensor for proper voltage signals to power control module . This code is only tested once per ignition cycle.

Oct 31, 2013 | 2006 Chevrolet HHR

1 Answer

Code P1683 & P2176

P1683 is : Powertrain control module fault
P2176 is: Minimum Throttle Position Not Learned

Sep 21, 2013 | 2004 GMC Envoy

1 Answer

Solution for code p 2175

make sure it is a p2175, I do not see a DTC for p2175 on a 2006 chevy impala but i do for p2176 which isDTC P2176: Minimum Throttle Position Not Learned

Feb 02, 2012 | 2006 Chevrolet Impala

2 Answers

I got code p2176 I changed out the tps still got same problem did not have this problem with other engine just changed engine out now cant seem to get this code off causing the car to rough idle and low...

P2176=Throttle Actuator Control System - Idle Position Not Learned
Did you use all you old sensors,or is some of them from the new engine,I would swap out the IAC sensor or check for wires not hooked up.
If it can't relearn to idle the Idle air control might be different then your old one,but its not registering with the computer

Dec 17, 2009 | 2006 Chevrolet Impala

1 Answer

P2176 code

NO , gas cap not the issue here . the P2176 refers to throttle actuator control system - idle position not learned .... the test for this is a mile long , i would try clearing the code , and see if it returns , or it will reset itself if it see's 3 drive cycles without a failure . cheers.

Jan 09, 2009 | 2004 GMC Envoy

Not finding what you are looking for?
2008 Ford Focus 1.6 Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers


Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides