Question about Cars & Trucks

Open Question

Daf truck truck not starting n showing coolant level sensor problems

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Papa Chan
  • 56 Answers

SOURCE: how to replace a coolant level sensor, 2000 buick century

The coolant level sensor is located on the radiator. If you are looking at the engine from the front of the car it will be on the left side. There will some kind of clip holding it in the radiator. Removed the clip and pull the sensor out. You will lose coolant so try to swap it out quick or drain some of the coolant out. Once new sensor is installed, install clip to keep the sensor in place and reconnect the wires to the sensor. Crank the engine and make sure the coolant level is full. This should correct your problem.

Posted on Jan 04, 2009

Ad
  • 1 Answer

SOURCE: coolant level sensor bad warning comes on console

I have the same problem with my 97 Jeep. I found a fix on www.jeepforum.com posted by phild328, goodluck

Posted on May 07, 2009

polarcycle
  • 1392 Answers

SOURCE: coolant level sensor bad warning comes on console

Coolant sensor wiring would be the next place to look. Make sure connector is good, and look for broken wires.

Posted on May 31, 2009

emissionwiz
  • 76846 Answers

SOURCE: replace coolant level sensor

THESE SENSORS ARE A KNOWN PROBLEM REPLACE IT, IT IS HELD IN BY A WIRE RETAINER CLIP, IT IS LOCATED IN THE PLASTIC SIDE TANK OF THE RADIATOR NEAR THE TOP OF THE TANK, ENGINE SIDE. THE PART IS ABOUT $60.00

Posted on Jul 17, 2009

lscf150
  • 443 Answers

SOURCE: where is the coolant level sensor in 2000

Usually mounted to the radiator into one of the coolant tanks,about 1/3 of the way down the radiator with a wire harness a weathertite connector. Good luck !

Posted on Nov 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi i a daf cf85 and it showing a coolant level low please help


then add antifreeze or water to the reservoir.

Jul 31, 2016 | DAF Cars & Trucks

1 Answer

What is the problem when onbard computer of daf 85 460 indicates exhaust warning


emissions are outside set parameters
check oil level in the tank for the exhaust
go to a service center and have it properly diagnosed

May 28, 2016 | DAF Cars & Trucks

1 Answer

How do i find the problem with an electrical fault on the daf cf75 series. Truck wont start, it is cranking.


run the fault codes read
non starting can be related to the following components :-
ignition (engine) immobilizer
cam shaft position sensor
crankshaft position sensor
oil pressure sensor

Sep 12, 2015 | DAF Cars & Trucks

1 Answer

I've got a DAF 95XF480 2007model. It keeps giving me the engine warning light. What could be the problem?


Check your fluids, paying attention to the coolant and oil levels. It is also possible that you have a bad sensor somewhere - finding it is pretty much impossible with out a scan. Your local shop should have a scanner to check what codes your computer threw - I suggest calling around to find a shop that will do it cheap - or free!!
Many shops will do it free if you have them replace or repair the problem.

Feb 21, 2015 | DAF Cars & Trucks

1 Answer

Daf truck not start but it make on,what is the problem?


If you turn the key, what happens? If you hear a clicking noise then it might be the starter other wise it the battery.

Oct 22, 2014 | Cars & Trucks

1 Answer

2000 vw beetle 2.0 L, low level coolant light...engine mil code 1256


not the pump but air in the system or a broken wire to the coolant level sensor
that sensor at the top of the radiator tank has to be completely immersed in coolant or the circuit is broken and the light comes on
same effect id the wire to that sensor is broken in the insulation

Jun 16, 2017 | Cars & Trucks

3 Answers

I get an intermittent "Coolant Sensor Bad" The FSM is clear, Bad mean the line to the coolant bottle switch is open.


The coolant sensor and the coolant level sensor are two different sensors. Your message center is showing (coolant sensor bad),not level sensor bad.
The level sensor only monitors the amount of coolant in the container
The coolant sensor senses the degrees of the coolant, which turns on the electric cooling fans. Change the coolant sensor, and the problem should go away.

Nov 16, 2009 | 1998 Jeep Grand Cherokee

1 Answer

I have A 1997 Jeep Grand Cherokee and the Coolant Sensor is Bad msg showed up on my panel. The coolant levels are fine but when I started my car today it idled for less than 30 seconds and died. It...


This problem is frecuently in this models, check the levels and reset your ECU.

If the problem stay there, just change your coolant sensor.

Good luck, and remember rated this help.

Aug 18, 2009 | 1997 Jeep Grand Cherokee

1 Answer

Coolant level


The sensor that measures the water level is rusted if you take it out and clean it. The problem should be solved.

Aug 04, 2008 | 1997 BMW 328

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...