Question about Cars & Trucks
Posted by Anonymous on
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: dodge neon shifting problems
Sean Pried it could be your A604 4 Speed Automatic Transmission Shift Solenoid which is located just in front of your transmission dip stick.
Posted on Nov 17, 2008
11= Timing belt skipped 1 tooth or more from initial learned value, Intermittent loss of either camshaft or crankshaft position sensor, No crank reference signal detected during engine cranking for dodge odb readout. Hope this helps.
Posted on Dec 08, 2008
SOURCE: Block heater for 98 dodge neon
Well the block heater itself is usually way under the engine where you can't see it, so I'm thinking you want the plug & cord that makes it work so you can plug it in. My 95 neon had it coiled up laying near the top of the fender under the hood on drivers side, if i remember correctly. It had a black cap over the plug which made it hard to find sometimes, even though I thought I knew where it was. Sometimes it would fall down behind or beside the engine controller.(gray looking computer box) I was always looking for a shiny plug-in type end but it was covered with a hard to see black little cap over it. I used a flashlight, and went along the top of the fenders until I spotted what looked similar to a black extension cord, then followed it to the end, and that's how I found it most times. Try going along drivers side top of fender first, then passenger fender, and then along the front, and maybe even attached in behind grille at front of car sometimes.
Posted on Dec 15, 2008
SOURCE: NO OVERDRIVE
I had a similar problem with my 98 mystique when i bought it used. I had no overdrive and was lucky to find a honest transmission shop that found the problem. In my case the overdrive was unplugged. They plugged it back in,cleared the computer and changed my tranny fluid and i was good to go. You should be revving about 2400rpm at 65mph. The other thing you can check is to make sure that the wires that go from the overdrive button are not broken off or coroded.
Posted on Jan 02, 2009
Tips for a great answer:
Jan 25, 2016 | Cars & Trucks
Dec 02, 2015 | Cars & Trucks
May 05, 2013 | 2004 Dodge Neon
Jan 24, 2013 | Cars & Trucks
Oct 23, 2012 | Cars & Trucks
Feb 14, 2012 | 1999 Dodge Neon
Feb 28, 2017 | 2005 Dodge Neon
Sep 13, 2011 | Dodge Ram 1500 Cars & Trucks
Mar 16, 2010 | 1998 Dodge Neon
Feb 23, 2018 | Cars & Trucks
26 people viewed this question
Usually answered in minutes!