Question about Volkswagen Touareg

Open Question

How do I reset the oil level sensor when fault is rectify .

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: fault code 0562.oil level sensor

You have two sensors that could cause the light to go on. The oil pressure sensor and oil level sensor. Both are easily replaced by someone relatively OK with cars (DIY). You would want to spend the $100 or so and have the dealership do a full diognostic to verify if its truly the sensor and which one. In my case, same problem, and it has been verified that it was the oil level sensor.

Posted on Aug 30, 2008

  • 4 Answers

SOURCE: My 1999 VW Polo oil pressure warning light

The oil pump is relatively easy to change with the engine in situ if it is (commonly) at fault,
Get an oil pressure gauge with a pipe and brass fitting ready on, (borrow or buy cheap from boy racer shop), unscrew the sensor (or ask the garage to for a £5) and plug it directly into the sensor hole after you've been for a run.. When warm, mine sits about 40 at motorway speeds, ten at tickover.

Posted on Jan 04, 2010

  • 128 Answers

SOURCE: oil min. warning comes on,

this is just a thought , but i would first replace oil pressure switch as this is cheap start to solving your problem , i wonder if you have caused air leak when chnageing oil sensor in sump by not sealing sump correctly ,? the other thing may be you oil pump is worn causing incorrect oil pressure , which may be reason for your oil problems in the beginning , hope this helps , i know what its like when you run out of idea's good luck .

Posted on Oct 08, 2010

frednewsome
  • 149 Answers

SOURCE: My 2001 VW Polo oil pressure warning light comes

Have you checked your thermostat. Some cars do not have gauges for all componants of the car located on the dash board. A bad thermostat could drive the oil pressure gauge up, if there is not a coolant level gauge on the dash board.

Posted on Nov 27, 2010

  • 3 Answers

SOURCE: my 1995 olds aurora reads oil level system fault

left front bottom of engine....

Posted on Dec 27, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Oil light is on and engine in limp mode


check the oil level in the sump, coolant level, coolant temperature (overheating), transmission oil level if auto. The limp mode is energised by any number of sensors that register a fault that is detrimental to the engine/ gear box. Run the fault codes and repair any faulty units . Reset the CPU with a scanner .

Jul 02, 2014 | 2005 Holden Rodeo

1 Answer

Check oil light stays on


Your vehicle may have an "oil level" sensor built into the oil pan. If so, and the sensor is bad, the dash will constantly tell you that the engine needs more oil even if it does not. Checking the oil with the dipstick, a minute after the engine has been turned off on level ground is always the best way to check your oil. Try scanning the vehicles computer systems to see if there are any fault codes. The warning light may also be on a timer that just needs to be reset. The "Check Oil" light should be separate from the engine oil pressure warning light. As long as the engine oil pressure light stays off, you should be ok. Checking the oil pressure with a manual gauge would be a good idea as well.

Apr 23, 2014 | 1999 Toyota Corolla

1 Answer

How to reset oil level indicator for Audi A4 2.0 TDi 143 SE


sensor fail is common fault. can be a build up of dirty oil blocking the sensor. should of just kept the the old type that just tells the ecu there is oil. you may be lucky and it could be the sensor plug at fault check that first.

Feb 05, 2014 | Cars & Trucks

1 Answer

1996 oldsmobile v6 model 88 engine light staying on and flashing all the time


check oil and coolant levels. run fault codes to determine if engine or transmission faults. rectify faults and reset using a code reader.

Jan 12, 2014 | Cars & Trucks

1 Answer

My code that came up when the engine light came on was PO521


P0521 Jeep - Engine Oil Pressure Sensor/Switch Circuit Range/Performancexicon.jpghttp://engine-codes.com/p0521_dodge.htmlForum CodePossible causes- Low oil level or motor mechanical fault
- Open or short oil level sensor circuit condition
- Poor oil level sensor electrical connection
- Faulty oil pressure sensor

Jul 02, 2012 | 2006 Jeep Commander Limited

1 Answer

Code 0521 is the read out. What does it mean? I cannot find it in the catalog.


P0521 error indicates a problem with the oil pressure and/or sensing system Possible causes: Low oil level or motor mechanical fault
Open or short oil level sensor circuit condition
Poor oil level sensor electrical connection
Faulty oil pressure sensor The most likely cause is a faulty oil pressure sensor/switch Locate the sensor/switch and insure the wiring to the switch is in good condition ( CLEAN nad a solid connection) Replace the sensor

Feb 04, 2011 | Chevrolet Impala Cars & Trucks

1 Answer

The oil pressure on my jeep grand cherokee 99 is zero I look for the diagnostic trouble code and is P0523 what that means? it is the oil pressure sending unit or the oil pump?


Possible causes - Low oil level or motor mechanical fault
- Open or short oil level sensor circuit condition
- Poor oil level sensor electrical connection
- Faulty oil pressure sensor

Jan 11, 2011 | Jeep Grand Cherokee Cars & Trucks

1 Answer

My 2001 VW Polo oil pressure warning light comes on regularly after driving for approx 8 miles - oil level & pressure both appear to be ok and water level too. Oil sensors replaced but to no avail....


Have you checked your thermostat. Some cars do not have gauges for all componants of the car located on the dash board. A bad thermostat could drive the oil pressure gauge up, if there is not a coolant level gauge on the dash board.

Nov 27, 2010 | 1999 Volkswagen Golf

1 Answer

My 1999 VW Polo oil pressure warning light and buzzer comes on regularly after driving for approx 8 miles - oil level & pressure both appear to be ok and water level too. Both sensors replaced and new...


The oil pump is relatively easy to change with the engine in situ if it is (commonly) at fault,
Get an oil pressure gauge with a pipe and brass fitting ready on, (borrow or buy cheap from boy racer shop), unscrew the sensor (or ask the garage to for a £5) and plug it directly into the sensor hole after you've been for a run.. When warm, mine sits about 40 at motorway speeds, ten at tickover.

Nov 16, 2009 | 1999 Volkswagen Golf

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

74945 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...