Question about 1999 Dodge Caravan

2 Answers

Drain valve for coolant - 1999 Dodge Caravan

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 8 Answers

Its on the bottom of the rad Please be careful antifreeze is very very toxic to everyone mainly animals bbest bet is to have someone who is good with cars ask someone from church

Posted on Aug 04, 2013

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 5,629 Answers

Should be at bottom on right or left side radiator.

Posted on May 08, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you drain coolant from 1995 olds cutlas 3100.


There should be a petcock(drain valve) on the bottom corner of the radiator. Turn it counterclockwise till coolant starts draining. Have a drain pan under the valve.

Dec 06, 2016 | 1995 Oldsmobile Cutlass Supreme

2 Answers

Where is the coolant drain plug


On the bottom of the radiator. There will be a little plastic valve that looks like a butterfly. Spin this to loosen it, and it will let coolant flow out.

Apr 08, 2015 | 2006 Pontiac G6

1 Answer

Y dose the john dear 6330 run hot all the time even after it blowen out



Engine or hydraulic system overheating clearpix.gif clearpix.gif clearpix.gif clearpix.gif clearpix.gif clearpix.gif Coolant system low on coolant in 6020, 6030, 6030 Premium, 7020, 7030 and
7030 Premium Series Tractors.

]clearpix.gif//-->
Symptoms
After several hours of work, warning system indicates hot engine coolant or hot hydraulic oil.
Situation or Problem
Coolant level in reservoir is between the "MIN" and "MAX" range but engine or hydraulic system is overheating.
Summary
Air is entering cooling system, hindering coolant flow. Check coolant level. Fill to the "MAX" line on the coolant reservoir.
Bleeding Cooling System:
The bleed valve (see Operator's Manual for location) on the radiator must be closed when the tractor is operating. Open the valve when coolant is drained or filled. If the bleed valve is left open, coolant will internally bypass between the low temperature circuit and engine high temperature circuit causing overheating. When bleeding the system, open the bleed valve and run the engine with no load for 5 minutes at 1700 rpm. Then shut engine off for 5 to 10 minutes before closing the drain valve. Check the coolant level. If level is below the "MAX" fill line, repeat this procedure until coolant level stays at the "MAX" line.

May 21, 2014 | Cars & Trucks

1 Answer

How to drain radiator coolant


Radiators usually have a valve/petcock located on the engine side of the radiator down at the bottom. Valve turns like a bolt and antifreeze coolant will drain out into your drainpan. Use care as coolant is poison and needs to be disposed of properly. After radiator has drained, retighten petcock and fill to the appropriate level.

Nov 05, 2013 | 1993 Oldsmobile Cutlass Ciera

1 Answer

I want to change coolant of mt car how to do it


Remove the radiator cap, open the drain valve at the bottom tank of the radiator, Drain the content into a container. Close the valve fill in the new coolant to the radiator up to about 20 mm below the rim of the filler. Run the engine to bleed out trapped air. Close the radiator and fill the coolant reservoir with the new coolant.

Oct 29, 2012 | Cars & Trucks

2 Answers

How do I drain the coolant from my 2007 Silverado LT, 4.8 liter, so I can replace the coolant with the required coolant?


There should be a shut off valve on back of radiator on lower drivers side of the radiator. Get a drain pan and put it below shut off valve and turn shut off valve so coolant pours out . when empty turn shut off valve back and refill with required coolant.

Dec 15, 2010 | 2007 Chevrolet Silverado 1500HD

1 Answer

Where is the engine coolant drain valve located? and what is the best procedure to change the coolant and flush the radiator? thanks


1.) the drain valve is a bolt type device under the radiator..

2.) different flush has different methods usually buy the flush and follow the instructions.. usually
empty radiator by loosening valve underneath
tighten back valve when drained
pour in flush and top up with water
start car and allow to run for 15 minutes (with cap off)
cut off
let cool and then drain..

add coolant .. your done..

Oct 29, 2010 | 1996 Oldsmobile Cutlass Supreme Coupe

3 Answers

How to flush and change the antifreeze on a 2001 mercury grand marquis


loosen pressure cap slowly at coolant tank to relieve pressure,when pressure is relieved remove cap,place a suitable container under drain valve at bottom of radiator open drain valve.when coolant has stopped draining,close valve.then remove thermostat,[this is a good time to replace t.stat since it must be removed to refill cooling system],disconnect heater core coolant supply hose at rear of intake manifold.add coolant thru t.stat opening until coolant comes out of coolant supply hose fitting,reinstall hose and tighten[not to tight] reinstall thermostat o ring and thermostat.add coolant to tank until the coolant level is between the COOLANT FILL LEVEL marks.select the maximum heater temperature and blower speed settings run engine until it reaches operating temp.add coolant until the coolant level is between the COOLANT FILL LEVEL marks.turn off engine allow it to cool, recheck coolant level,add as needed .ford requires this procedure to avoid engine damage due to trapped air.

Jan 15, 2010 | 2001 Mercury Grand Marquis

1 Answer

I replaced the alternator on my 2003 Range Rover


I Suspect that you have AIR in your COOLING SYSTEM Fallow Procedures BELOW to Insure there is NO AIR IN COOLING SYSTEM


Draining and Filling Cooling System

Draining Procedure

Important: Do NOT add any engine coolant supplement sealant pellets to the cooling system. Drain and refill the engine cooling system every 5 years or 240,000 km, (150,000 mi) , whichever occurs first.

  1. Park the vehicle on a level surface.
  2. Remove and clean the coolant recovery reservoir.
Caution: Refer to Radiator Cap Removal Caution in Service Precautions.

  1. Remove the radiator cap when the engine is cool:
3.1. Slowly rotate the cap counterclockwise to the detention tab. Do not press down while rotating pressure cap. 3.2. Wait until any residual pressure, indicated by a hissing sound, is relieved. 3.3. After all hissing stops, press down on the radiator cap and rotate the cap counterclockwise in order to remove the cap.
Important: Recover and store used coolant in a used coolant holding tank and submit the used coolant for recycling on a regular basis. Do NOT pour used coolant down the drain. Ethylene glycol antifreeze is very toxic. Disposing of ethylene glycol into the sewer system or ground water is both illegal and ecologically unsound.

  1. Place a drain pan under the radiator drain valve in order to collect all of the used coolant.
  2. Open the radiator drain valve located at the bottom of the radiator tank. If only partial cooling system draining is required, drain enough coolant to perform the procedure.
  3. Open the air bleed valve on the thermostat housing 2 full turns
    1. Open the air bleed valve above coolant pump 2 full turns.
    2. Place a drain pan under the engine block drains in order to collect the used coolant.Important: Allow the coolant to drain completely.

      1. Remove both of the engine block drains.
        • The front left engine block drain is located between the starter motor and the engine oil filter.
        • The rear right engine block drain is located near the crankshaft position sensor.
      Filling Procedure
      Reinstall the engine block drains
    3. Close the radiator drain valve,
      1. Install the coolant recovery reservoir. Notice: When adding coolant, it is important that you use GM Goodwrench DEX-COOL or HAVOLINE DEX-COOL coolant. If Coolant other than DEX-COOL or HAVOLINE DEX-COOL is added to the system the engine coolant will require change sooner; at 50,000 km (30,000 mi) or 24 months.
      2. Slowly add a 50/50 mixture of GM Goodwrench DEX-COOL or HAVOLINE DEX-COOL and clean, drinkable water to the radiator until the coolant level is at the base of the radiator fill neck.
      3. Wait for 2 minutes and reinspect the level of the coolant in the radiator. If necessary, add coolant to the radiator until the coolant level is at the base of the radiator fill neck.
      4. Install the radiator cap.Ensure that the radiator cap arrow points toward the radiator overflow tubeImportant: The air bleed valves are brass. Do NOT over-tighten the air bleed valves.

        1. Close the air bleed valve above the coolant pump.
          1. Close the air bleed valve on the thermostat housing.
          2. Fill the coolant reservoir with a 50/50 mixture of GM Goodwrench DEX-COOL or HAVOLINE DEX-COOL and clean, drinkable water. Caution: Refer to Radiator Cap Removal Caution in Service Precautions. Important: If the coolant temperature indicator turns ON, turn the engine OFF immediately and allow the engine to cool. Do NOT remove the radiator cap.
          3. Start the engine and allow the engine cooling fan to cycle on and off 3 times. If the low coolant indicator does not turn OFF and the coolant level is above the Full Cold mark on the coolant recovery reservoir, refer to Engine Coolant Temperature Gage Inaccurate or Inoperative.
          4. Turn off the ignition.
          5. Allow the engine to cool.
          6. Ensure that the engine coolant concentration is sufficient.

Feb 21, 2009 | 2001 Pontiac Aztek

1 Answer

Locating coolant drain on 2001 vw cabrio


On the driver side of the radiator bottom where the hose is located there is a valve that you turn to drain the coolant, just like a faucet valve.

Aug 10, 2008 | 2001 Volkswagen Cabrio

Not finding what you are looking for?
1999 Dodge Caravan Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...