Question about 1991 Toyota Camry

1 Answer

Where is the fuel pump relay or sensor located

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Toyota Master
  • 3,961 Answers

It is called the Circuit Opening Relay, and should be behing the glove compartment, which you have to remove from the dash.

Posted on May 08, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 7 Answers

SOURCE: fuel pump relay

It is located above the glove box. It is the second relay from the left. If you pick up the chilton manual at your local auto parts store you will see the location and have the testing procedures for it. 

Posted on Aug 18, 2008

blueextc3221
  • 15935 Answers

SOURCE: fuel pump relay location

the relay is located behind the glove box. You'll have to remove it, inside and all. Then you should see a pack of three relays just above the glove box opening. It will be the middle one. If not, please inquire to ToyotaED im sure he knows!

Posted on Jan 14, 2009

  • 82 Answers

SOURCE: fuel pump relay location

if not under the bonnet in the fuse box,, try under the steering wheel side of the dash,,,

Posted on Apr 21, 2009

  • 225 Answers

SOURCE: Fuel pump relay location 1997 celica

The relay and fuse is located under the hood in the relay box. It will be labeled on the lid. If fuse is good, then test the relay. Pull it out and with a test light see if there is power. If there is then remember that one. Have some one turn the key on and find another power wire. There should be 2 powers.If there is only one power then there maybe a problem in the ignition switch. If there is 2 powers then you need to get to the top of the fuel tank and see if power is getting to the pump. The power at the pump will be there for only a few seconds once the key is turned on and then will drop off. Let us know how it goes.

Posted on Aug 30, 2009

SOURCE: location of fuel pump relay 1994 toyota corolla

need to locate the fuel pump fuse for a toyota corolla

Posted on Apr 03, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuel pump relay located in a bmw e34 520i


ECU (Engine Control Unit) relay, fuel pump relay and oxygen sensor heater relay are located in the under-hood E-Box. The E-box is under the large black plastic cover at the passenger side rear of the engine compartment.

For Its Location Diagram Click the link below:

http://carrepairworld.blogspot.com/2016/06/where-is-fuel-pump-relay-located-on-bmw.html
This will help.
Thanks.

Jun 02, 2016 | BMW Cars & Trucks

1 Answer

Where is the knock sensor on a Kia Sedona 2.9 diesel, 2004 LA


Hi,
Here is the location of the "Knock Sensor" you requested, I hope it helps you. It is Number 17. for future reference here is the list of the others
1 = Camshaft position sensor (CMP)
2 = Crankshaft position sensor (CKP)
3 = Engine Control relay (EC) -engine bay fusebox/relay plate 1
4 = Engine Coolant temperature sensor (ECT)
5 = Exhaust gas recirculation valve actuator (EGR)
6 = Fuel Filter
7 = Fuel Filter Heater - in fuel filter housing
8 = Fuel Flow control valve - on high pressure fuel pump
9 = Fuel Rail pressure sensor(FRP)
10 = Fuel Temperature sensor - on high pressure fuel pump
11 = Glow Plugs
12 = Glow Plug Relay 1 - engine bay fuse box/relay plate 2
13 = Glow Plug relay 2 - engine bay fuse box/relay plate 2
14 = High Pressure fuel pump
15 = Injectors
16 = Intake air temperature sensor (IAT) - in MAF sensor
17 = Knock Sensor (KS)
18 = Mass Air Flow sensor (MAF)

25399765-f5d0u4e2gjrctbiof2rrhyew-2-0.jpg

Feb 04, 2015 | 2004 Kia Sedona

1 Answer

Fuel pump relay diagrams


auto shutoff relay controls both fuel and fire..the parts store can tell you for sure..

Jan 05, 2014 | Cars & Trucks

2 Answers

Where located fuel sensor Suzuki Ario 2003


Component location diagrams for most 2003 Suzuki Aerio cars and light trucks sold in the U.S. from 1990+.
clsk2003aeri003.gifIgnition System Components Location Diagram for 2003 Suzuki Aerio 2.0 L4 GAS
Components on diagram:
  • TP Sensor
  • Ignition Coil
  • ECM
  • MAF Sensor
  • CMP Sensor
  • clsk2003aeri007.gifElectronic Shift Control System Components Location Diagram for 2003 Suzuki Aerio 2.0 L4 GAS
    Components on diagram:
  • Data Link Connector
  • Transmission Range Sensor
  • Throttle Position Sensor
  • Pressure Control Solenoid Valve
  • Battery
  • clsk2003aeri010.gifInstrument Panel For Connector Layout Diagram Diagram for 2003 Suzuki Aerio SX 2.0 L4 GAS
    Components on diagram:
  • Clutch Switch
  • Thermistor
  • Brake Light Switch
  • Blower Motor Relay
  • Heater Fan Motor
  • clsk2003aeri011.gifInstrument Panel Harness Diagram for 2003 Suzuki Aerio SX 2.0 L4 GAS
    Components on diagram:
  • Wiper Switch
  • Washer Switch
  • Data Link Connector
  • Turn Signal Relay
  • Radio
  • clsk2003aeri015.gifHeadlight System Location Diagram for 2003 Suzuki Aerio SX 2.0 L4 GAS
    Components on diagram:
  • Headlight Relay
  • Headlight
  • Clearance Light
  • Headlight Diode
  • Clearance Light Relay
  • clsk2003aeri022.gifFuel System Components Diagram for 2003 Suzuki Aerio SX 2.0 L4 GAS
    Components on diagram:
  • Fuel Pump Relay
  • Fuel Tank Pressure Sensor
  • EVAP Canister
  • Fuel Tank Pressure Control Valve
  • Fuel Filler Cap
  • clsk2003aeri027.gifFloor For Single Unit Parts Diagram for 2003 Suzuki Aerio 2.0 L4 GAS
    Components on diagram:
  • Wheel Speed Sensor
  • ABS Control Module
  • G Sensor
  • Air Bag Control Module
  • EVAP Canister Vent Valve
  • clsk2003aeri030.gifInstrument Panel For Ground Point Diagram for 2003 Suzuki Aerio SX 2.0 L4 GAS
    Components on diagram:
  • Instrument Panel Ground Points
  • clsk2003aeri036.gifEngine Compartment For Single Unit Parts Diagram for 2003 Suzuki Aerio 2.0 L4 GAS
    Components on diagram:
  • Throttle Position Sensor
  • Horn Relay
  • Radiator Fan Control Relay
  • Cruise Control Module
  • Condenser Fan Relay
  • clsk2003aeri037.gifEngine Compartment Components Diagram for 2003 Suzuki Aerio SX 2.0 L4 GAS
    Components on diagram:
  • MAP Sensor
  • Knock Sensor
  • Noise Suppressor
  • Heated Oxygen Sensor
  • Sep 18, 2011 | 2003 Suzuki Aerio

    1 Answer

    Engine not getting fuel. Can not hear fuel pump come on when ignition turned on. Should the fuel relay be checked before replacing fuel pump? where is the relay located?


    Great question............You are right and the sensor is located jost downstreem of the fuel pump and make sure all fuses are servicable......................Hope this helps.

    Oct 16, 2010 | 1990 Plymouth Voyager

    2 Answers

    My 92 vw cabriolet is blowing the fuel pump fuse after about 5 seconds. reckon why? replaced fuel pump - no luck. cant find the proper location of the fuel pump relay. manual says (12) lower right hand...


    FUSES AND RELAYS LOCATED LEFT OF THE STEERING COLUMN.YOUR FUEL PUMP WIRES IS SHORTING TO GROUND.CHECK WIRES LOOK FOR SIGNS OF RUBBING AGAINST SOMETHING.

    Feb 22, 2010 | 1992 Volkswagen Cabriolet

    1 Answer

    98-Mitsubhi Eclipse - 2.4 SOHC fuel pump issues


    You could desrupt pump if try to configure relay module is located inside the fuel reservoir.

    Oct 23, 2009 | 1998 Mitsubishi Eclipse

    1 Answer

    Where is the fuel pump cut off switch located exactly and how could I reset it.


    The fuel pump relay is located in the Power Distribution Center (PDC) under the hood. The inside top of the PDC cover has a label showing relay and fuse location. The relay supplies battery voltage to the fuel pump. A buss bar in the Power Distribution Center (PDC) supplies voltage to the solenoid side and contact side of the relay. The PCM controls the fuel pump relay by switching the ground path for the solenoid side of the relay on and off. The PCM turns the ground path off when the ignition switch is in the Off position. When the ignition switch is in the On position, the PCM energizes the fuel pump. If the crankshaft position sensor does not detect engine rotation, the PCM de-energizes the relay after approximately one second.

    Sep 19, 2009 | 2006 Chrysler PT Cruiser

    1 Answer

    Looking for the fuel pump relay or sensor


    The Fuel pump relay is part of the EFI main relay and can not be replaced separately. The EFI main relay is located behind the dash, left of the steering wheel.

    gl G

    May 10, 2009 | 1991 Honda Accord

    2 Answers

    Fuel pump location and replacement


    You are looking for the constant control relay module- ( CCRM ) see below. The pump will be located inside the fuel tank.Most of the time , its the pump and not the relay but, it wouldn't hurt to check the relay out. Teh relay is housed in the CCRM. Its located behind the engine coolant reservoir.


    3dc24e5.jpg

    Mar 20, 2009 | 2000 Ford Mustang

    Not finding what you are looking for?
    1991 Toyota Camry Logo

    38 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Toyota Experts

    yadayada
    yadayada

    Level 3 Expert

    75822 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22156 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    8210 Answers

    Are you a Toyota Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...