Question about 2007 Honda Accord Sedan

1 Answer

Excessive road noise coming front

Noise in the cabin when driving the car and noise increases on highway

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Honda Master
  • 21,873 Answers

Tire noise, or outside noise like a door is not closed ?

Posted on May 07, 2013

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
venexcsd
  • 1185 Answers

SOURCE: GRINDING NOISE IN FRONT END

Sounds like wheel bearing or CV joint is shot at the best your brake pads are down to the metal

The car should be off the road as both sets of bearings can seize with dire consequenses and if it is your brakes !! need I say more

Posted on May 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Excessive road noise


You have a tire delaminating! Stop driving it until it is repaired! Extreme roll-over possibilities!

Feb 15, 2014 | 2005 Ford Escape XLT

1 Answer

Excessive road noise


New cars have rubber sunspension bushes that absorbe a lot of road noise. Check to see if someone hasn't replaced the suspension points with neoprene bushing. This is a hard plastic that will not absorb the road noise. The other part of your problem will be the tread pattern of the tyres as they are designed for off road use but will howl on sealed surfaces. Experiment with tyre pressures as a few pound up or down may make a difference. Talk to a tyre dealer for advice on this

Feb 01, 2013 | 2008 Honda CR-V 2.4

1 Answer

2000 Ford Mustang GT has very loud cabin noise while driving, but not while idling or revving the engine at idle.


At that mileage your wheel bearings probably need changing, especially if you haven't been lubricating them whenever you did a brake job! Usually the front wheel bearings, the ones taking the weight from the engine and turning weight transfer to the outside wheels on curves burn out first...do it!!!

Jan 01, 2013 | Cars & Trucks

1 Answer

78 mark V 460 : humming noise at acceleration and between a range of rpm


Exhaust touching under somewhere when engine torque increased, Egr tube, or anti-backfire valve at rear of engine etc. Other possibilities, Motor mount (especially opposite side) , transmission mount. Have you tried brake torque to see how much engine shifts? Once your up to higher speeds, less torque required to push that Big thing down the road. ha ha.
What type of noise is it, if you can describe? Have U-joints been checked?

Apr 05, 2012 | Lincoln Cars & Trucks

1 Answer

Driving at highway speeds noise like rubbing coming from front end and when I turn corners to the right the sound disappears. At low speed there seems to be a lot more road noise coming from front end than...


Flush the Power Steering Fluid

Should be done with the trans every
30,000 miles

May not be the issue ,but you have to
do the following anyway :

Power Steering Fluid --30,000
Trans Fluid --- 30,000
Brake Fluid --- every 2 years
Clean MAF sensor --every year
Fuel Filter,Air Filter,Cabin Filter --every 3 years
Spark Plugs -every 3 years ,not over 60,000

Jun 12, 2011 | 2008 Ford Focus SE Sedan

1 Answer

Air flow out of A/C (HVAC) seems to be partially blocked. Noise increases with increased fan speed settings, but flow barely changes. Even on maximum setting the flow is not enough to reach driver or...


One of the Actuators for the doors inside your dash that controls and diverts air might not be working correctly. You may have to either replace the Actuator or Replace the A/C Heater Control. Your vehicle does not come with a Cabin Air Filter.

Jun 26, 2010 | 2004 Dodge Ram 2500

1 Answer

"Humming" or "bearing" type noise in left front at highway speeds


That's a hub bearing. Replace the one that's doing it. I'm assuming this 'roar' is coming from the front, NOT the rear.

Jun 10, 2009 | 2001 Hyundai Elantra

1 Answer

2001 Sebring LXI convertable. Loud rumbling noise that increases as accelerating increases. Sounds like a rumble strip on the highway. I changed the tires with no change in the noise.


Bad hub bearing. Drive the car on a straght EMPTY road .@30 mph or when noise is audible, **** the wheel left than right (similar to a race car warming. tires) and listen if there is a change in the sound if so its a front bearing if not it should be a rear bearing .Jack the rear of the vehicle up and spin the tire holding onto the strut. Feel and listen for a vibration or noise. This should pinpoint that elusive noise.Let me know Good hunting

Apr 11, 2009 | 1998 Buick Park Avenue

3 Answers

I have front end vibration that is not caused by alignment. New tires on all four wheels but still have alot of front end vibration. Car is a 2004 Hyundai Tiburon.


just checked this out a while ago:



Wheel Hub Assemblies: Systems and Diagnosis of Worn Hub Assemblies & Bearings
Front wheel hub assemblies and bearings control the position of, and reduce the resistance of, vehicle wheels in contact with the pavement. When they fail, front wheels may not be kept in position and vibration and noise usually develop. Symptoms that normally develop as a result of these worn parts include:
  • A humming, rumbling or growling noise which increases with acceleration or as the vehicles turns
  • Vibration felt in the steering wheel, which changes with vehicle speed or as the vehicle turns
  • Looseness or excessive play in the steering wheel (especially while driving over rough road surfaces)
  • A loud, constant grinding noise when driving the vehicle (heard in the most severe cases of a wheel bearing failure)
  • Pulling to one side when braking.
  • Roughness - with the vehicle of the ground, roughness or vibration when rotating the wheel
  • Looseness - with the vehicle off the ground, looseness when wiggling the wheel back and forth (Looseness may also indicate a worn ball joint)
  • Excessive brake pedal play can also indicate sloppy or excessively loose wheel bearings
  • ABS failure in the system may be related to failure of the ABS sensor in the hub assembly or the internal sensor in the wheel bearing

Dec 22, 2008 | Hyundai Tiburon Cars & Trucks

Not finding what you are looking for?
2007 Honda Accord Sedan Logo

Related Topics:

138 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...