loosen nut on tie rod..22mm wrench,remove nut from tie rod end..18mm socket,hit side of knuckle with hammer to seperate tie rod end..unscrew tie rod end from tie rod..reverse procedure to install..you will to hold down on tie rod end to keep stud from spinning
you will need to jack up the front of car and put on jack stands for saftey. remove the tire , at the end of the tie rod you will have to loosen the lock nut. then remove the cottor pin and nut from the bottom of the tie rod where it connects to the knuckle using a tie rod fork seperte the tie rod . count the revolution to un screw it .install new one in the reverse way. have toe set at service center.
I have a misfire in cylinder 4. I replaced the following: plugs, wires, coil pack, injectors, ran...
(More)
I have a misfire in cylinder 4. I replaced the following: plugs, wires, coil pack, injectors, ran fuel line cleaner. Still have a misfire in cylinder 4, all I can think that it might be the Fuel Rail Wiring harness (electric wires that plug into the injectors). It looks lightly burnt from heat in sections. I purchased a code reader and it says Pending code cylinder 4. When I replaced the injectors which was the last thing I replaced the van had no codes and then 2 days later I had the check engine light again. Im think maybe I shorted the old wire out when I installed the NEW injectors (the witre is almost 10 years old). It almost feels as if the wire has a short (if the wire is even the problem) because it feels like I have fuel power at one minute and loss of power the next. Sometimes the check engine light comes on solid and sometimes it blinks and goes away. Does anyone agree or have any other suggestions? I order a new wire harness just waiting to receive it. Im strapped for cash and this was my fathers vehicle (he passed away in june) so Im trying to do the repairs myself to cut cost but to also keep the van up and running as long as possible. Thanks in advance to everyone.
one workes on dem and the other on bright bulds are good put new swech in steering colem all fuses...
(More)
one workes on dem and the other on bright bulds are good put new swech in steering colem all fuses is good