Question about 2006 Kia Sorento

Open Question

Seat belts buckle srs b1511 - 2006 Kia Sorento

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Heated and cooled seat on 2004 expedition stopped working how to reset them


Heating and the cooling both don't work ? Just one seat or all seats ?
Your best bet have it checked for DTC'S - diagnostic trouble codes to start .
Climate Controlled Seat Module (CCSM) Diagnostic Trouble Code (DTC) Index DTC Description Source Action B1342 ECU Is Faulted CCSM INSTALL a new CCSM and CARRY OUT programmable module installation (PMI). REFER to Climate Controlled Seat Module . B1358 Ignition Switch or Blower Electronics Circuit Short to Ground CCSM Go To Pinpoint Test Q . B2477 Module Configuration Error CCSM This DTC indicates programmable module installation (PMI) has not been done to a newly installed module. CARRY OUT PMI. REFER to Section 418-01 . CLEAR the DTC. CARRY OUT the self-test. B2486 Climate Controlled Seat Module Voltage Out of Range CCSM DEPOWER the supplemental restraint system (SRS). REFER to Section 501-20B . DISCONNECT driver safety belt buckle pretensioner electrical connector or passenger safety belt buckle pretensioner electrical connector of the affected seat and CONNECT restraint system diagnostic tool 418-F395 to the safety belt buckle pretensioner harness connector. CONNECT the battery ground cable. CHECK circuit 294 (WH/LB) for a fault. REPAIR as needed. If okay, REFER to Section 414-01 . Once the repair is complete, DISCONNECT the restraint system diagnostic tool from the safety belt buckle pretensioner harness connector and CONNECT the safety belt buckle pretensioner connector of the affected seat. REPOWER the SRS. REFER to Section 501-20B . B2488 Thumbwheel Switch Voltage Out of Range High CCSM Go To Pinpoint Test R . B2521 Tach Circuit Failure CCSM Go To Pinpoint Test Q . B2729 Cushion Over-Temp Detected CCSM Go To Pinpoint Test S . B2730 Back Over-Temp Detected CCSM Go To Pinpoint Test S . B2731 Differential Temperature Fault CCSM Go To Pinpoint Test S . B2792 Heat Switch Short to Ground CCSM NOTE: If HEAT is pressed for greater than 20 seconds on the climate controlled seat switch, DTC B2792 will set in the CCSM.
CLEAR the DTC. If the DTC does not clear, DEPOWER the supplemental restraint system (SRS). REFER to Section 501-20B . DISCONNECT driver safety belt buckle pretensioner electrical connector or passenger safety belt buckle pretensioner electrical connector of the affected seat and CONNECT restraint system diagnostic tool 418-F395 to the safety belt buckle pretensioner harness connector. CONNECT the battery ground cable. CHECK circuit 1551 (VT/WH) for a short to ground. REPAIR as needed. If okay, INSTALL a new climate controlled seat switch. Once the repair is complete, DISCONNECT the restraint system diagnostic tool from the safety belt buckle pretensioner harness connector and CONNECT the safety belt buckle pretensioner connector of the affected seat. REPOWER the SRS. REFER to Section 501-20B . B2793 Cool Switch Short to Ground CCSM NOTE: If COOL is pressed for greater than 20 seconds on the climate controlled seat switch, DTC B2793 will set in the CCSM.
CLEAR the DTC. If the DTC does not clear, DEPOWER the supplemental restraint system (SRS). REFER to Section 501-20B . DISCONNECT driver safety belt buckle pretensioner electrical connector or passenger safety belt buckle pretensioner electrical connector of the affected seat and CONNECT restraint system diagnostic tool 418-F395 to the safety belt buckle pretensioner harness connector. CONNECT the battery ground cable. CHECK circuit 1550 (WH/OG) for a short to ground. REPAIR as needed. If okay, INSTALL a new climate controlled seat switch. Once the repair is complete, DISCONNECT the restraint system diagnostic tool from the safety belt buckle pretensioner harness connector and CONNECT the safety belt buckle pretensioner connector of the affected seat. REPOWER the SRS. REFER to Section 501-20B . U2362 UBP Invalid Data Node ID CCSM NOTE: DTC U2362 indicates a network concern, the CCSM is not the source of the fault.
CLEAR the DTC. If the DTC does not clear, REFER Section 418-01 .

Nov 26, 2016 | 2004 Ford Expedition

1 Answer

Srs light is on but everything is working..


Known problem for SRS light might be cause by bad seat belt buckle. Honda seat belt buckle and belts are lifetime warranty(not cover if broken because of abuse). Have your honda dealer scan it for code. They might charge you $55 to scan for the code(ex:09-3 driver seat buckle failure), but if it is a for buckle or belt code then everything is free including the scan(labor and part).
good luck

Dec 15, 2010 | 2002 Honda Accord

1 Answer

SRS LIGHT STAYING ON 2002 HONDA ACCORD


you need a scanner to pull the code. its prob a seat belt buckle. seat belts and all buckles are under a lifetime warr at all honda dealers. take it to a honda dealer to have the code checked out. if its a 9-3 or 9-4 or any seat belt, or seat belt buckle, the repair will be free.

Jan 02, 2010 | 2002 Honda Civic

2 Answers

SRS light came on shortly after new battery


Here's a quick check list for most common cost of SRS / Air bag problem.

Dirty contacts on driver and passenger seat belt buckles

Dirty contacts on seat belt connectors (under seats)

Dirty contacts on driver and passenger sides weight sensors (under seat)

Seat covers

Weight on passenger seat
(Example: grocery package trigger SRS / Air Bag light on the way home.)

I recommend you to pass an vacuum over the contacts and use CRC electronic parts cleaner to rule out connectivity problem.

I DO NOT recommend disconnecting the negative battery connector to clean the code(s).

Without the code(s) the dealer will takes "BILLABLE" time to reproduce the problem.

======

Please rate my answer if it is useful to you.

Cheers,

Mustgo

Jun 13, 2009 | 1997 Acura RL

1 Answer

Srs airbag light is on on my 99 pontiac grand prix


If the seat belt light comes on intermittently with the belt buckled, it may have a bad switch in the buckle or a loose connection @ the switch. This may also set a diagnostic trouble code in the srs control module & keep the srs airbag light on.

Mar 27, 2009 | 1999 Pontiac Grand Prix

1 Answer

Airbag light is on - 2003 Tiburon


section_closed.gif 2003 HYUNDAI TIBURON Recall ID from NHTSA: 02V290000 Auto Recall Date: NOV 05, 2002 Vehicle Component: SEAT BELTS:FRONT:BUCKLE ASSEMBLY Model Affected TIBURON Estimated Vehicles Affected: 7382 Recall Details Auto Recall Date: NOV 05, 2002

Vehicle Component: SEAT BELTS:FRONT:BUCKLE ASSEMBLY Estimated Vehicles Affected: 7382 Model Affected2003 HYUNDAI TIBURON

2003 Hyundai Tiburon Defect Summary:ON CERTAIN PASSENGER VEHICLES, THE DRIVER SEAT BELT BUCKLE WIRING COULD BE DAMAGED BY INTERFERENCE WITH THE DRIVER SEAT CUSHION HEIGHT ADJUSTER MECHANISM.

Defect Consequence:DAMAGED DRIVER SEAT BELT BUCKLE WIRING COULD CAUSE THE SEAT BELT WARNING LAMP OR THE SUPPLEMENTAL RESTRAINT SYSTEM (SRS) AIR BAG WIRING LAMP TO ILLUMINATE. IT COULD ALSO CAUSE THE AIR BAG FUSE (CAVITY NUMBER 5) TO OPEN, PREVENTING AIR BAG DEPLOYMENT. NONDEPLOYMENT OF AN SRS AIR BAG IN A CRASH WHERE AIR BAG DEPLOYMENT IS WARRANTED COULD INCREASE THE RISK OR SEVERITY OF INJURY IN A CRASH.

Remedy:DEALERS WILL INSTALL A NEW DRIVER SEAT BELT BUCKLE, IF NECESSARY, AND WILL PLACE A PROTECTIVE COVER OVER THE DRIVER SEAT BELT BUCKLE WIRING TO PREVENT DAMAGE FROM OCCURRING. OWNER NOTIFICATION BEGAN ON MARCH 24, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT HYUNDAI AT 1-800-633-5151.

Estimated Vehicles Affected: 7382

Notes: HYUNDAI MOTOR COMPANY 056

Dec 07, 2008 | 2003 Hyundai Tiburon

4 Answers

2003 HYUNDAI TIBURON TROUBLE CODE B1511 (SRS SYSTEM) ANY SUGGESTIONS ON WHAT IT MIGHT BE


Hi....

2003 Hyundai Tiburon.

The CODE B1511. Driver SEAT BELT BUCKLE Open circuit or short to battery.
Inspect the Seat belt Receiver Connection Under the Driver SEAT.
Inspect the Seat belt receiver at the Side of the Seat.
If everything look good you will need to replace...

Ok I hope this help on your question.
Thank you for use fixya...

Oct 01, 2008 | Hyundai Tiburon Cars & Trucks

1 Answer

The SRS light stay on


SRS stands for supplemental restraint system. You have a problem with the airbag system. The seat belts have sensors to let air bag module know if they are buckled. Could be a bad buckle seat belt will work fine .This may be a common problem is why they said seatbelt problem

Sep 05, 2008 | 2002 Honda CR-V

1 Answer

2005 Acura RSX


The buckle and belt need to be replaced.  They are only good for one time during a collision.  The buckle has an explosive charge in it that causes the buckle to pull back toward the seat.  The belt does the the same.  It locks up during an accident, also so body shops can't try to reuse it.  The SRS light will stay on until they are replaced.

Aug 29, 2008 | 2006 Acura RSX

Not finding what you are looking for?
2006 Kia Sorento Logo

Related Topics:

127 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

yadayada
yadayada

Level 3 Expert

75797 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...