Question about 2001 Toyota Tundra

Open Question

Tundra will not shift into park

The truck will not shift into park, it does not go past reverse but it will start in netural

Posted by Anonymous on

4 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 6826 Answers

SOURCE: toyota tundra cuts off going from neutral to

The clutch lock up converter is locked,there is a solenoid that may be bad,or you need a new converter.torque converter.

Posted on Nov 12, 2009

  • 6826 Answers

SOURCE: I have a 2001 tundra. It has 59,000 miles. I am

Sounds like the linkage might be worn out. Had this problem with a 1980 Chevrolet Suburban with 100,000 mi. in 1999 or so, and the fix was about $100 at a local transmission shop. In our situation, the 1980 Suburban's linkage wasn't allowing it to go into Park very well, and the car would roll even though the indicator said 'P' on the dashboard.

In the case of our Suburban, the linkage components which consisted of rods and pivots inside of the transmission oil pan had to be replaced.

I hope this story helps you out on your 2001 Tundra that is now approaching 10 years old.

Posted on Jan 25, 2011

  • 313 Answers

SOURCE: Some times can't start my 1992 toyota camry.I have to wiggle the gear shift between park & reverse

sounds like a faulty micro swich or linkage out of adjustment

Posted on Jul 04, 2012

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 2009 mazda3, there is a problem in the gear display on the gauage panel. it doesnt show that the car is in Park,reverse and netural. Other than that it shows when it is on D and M

Check the lamps/lights. of the shifter/console gear assembly. If your car engages the park shift, it may be something as simple as a $3.00 mini light bulb found at a local auto parts... Good luck!

Oct 20, 2015 | 2009 Mazda 3 2.0

1 Answer

2000 Toyota Tundra Shifter Problem

This will hopefully be the shift cable or related linkage. Disconnect the shift cable from the transmission and inspect both the cable the linkage on the transmission, for damage. There should be zero play on both. Please let me know what you find and if you have any other questions, good luck.

Mar 24, 2014 | Toyota Tundra Cars & Trucks

1 Answer

2000 tundra runs in park but stalls in drive

cel light on running?
scan it.
no engine power. (low fuel pressure, filthy maf? )

Feb 15, 2014 | Toyota Tundra Cars & Trucks

1 Answer

I just had a tranny put in my 94 4x4 ranger 4.0 auto but now I don't have reverse 1st or 2nd only park netural and drive is this a shift prb or tranny

Check all wire connections on this transmission. It should be an electronic shift transmission. If this is the case, then the wire connector is probably not connected.

Aug 20, 2013 | Cars & Trucks

1 Answer

Shift into park

Could be the park lock solenoid. Thats the part that locks the shifter in park and requires you to press on the brake pedal to release.

May 07, 2013 | Toyota Cars & Trucks

1 Answer

2002 gmc jimmy wont go into park

Remove the battery negative for 30 minutes to reset any ECMs and retry.

Nov 11, 2012 | 2002 GMC Envoy

1 Answer

New 1969 c4 auto transmission has park but no reverse or netural

Is it possible the transmission was not made for a Mustang ?
With the shifter on the floor, the linkage would be different than a car with the shifter on the column.
Have you contacted the company ?

Aug 25, 2012 | Ford Cars & Trucks

1 Answer

My 1998 Buick Park Avenue that won't shift from Reverse to Park

My friends car started doing the same thing tonight won't go from reverse to park he has a 97 mercury grand marquis

Nov 12, 2009 | 1995 Buick Park Avenue

2 Answers

My 2001 F150 Ford Harley Truck won't go into will go in neutral, reverse and drive and I can drive it...just won't go into park. Someone told me it was a linkage problem but I have no clue what...

under the vehicle there is a shift rod with a nut on it loosen the nut and move selector on tranny to park then line lever in truck up with it and tighten nut.

Aug 26, 2009 | 2001 Ford F150 Styleside SuperCrew

Not finding what you are looking for?
2001 Toyota Tundra Logo

Related Topics:

70 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides