Question about Cars & Trucks

Open Question

Ldv maxus gear lever stiff into gears

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 3 Answers

SOURCE: changing gears very stiff

try 1 0f these solutions giving the cars age and not much discription.
1 check the level of your gear box oil

2 change the gear box oil or if automatic change the fluid for the transmision.( since you say changeing gears i take it that it's manual gear box.

3 if manual the gears need over hauled giving the age of your car.

4 your clutch cable needs adjusted due ware on the clutch or if hydraulic the clutch system needs bleed with new fluid.

Posted on Oct 18, 2008

Ad
smartr10U
  • 1305 Answers

SOURCE: 1999 F350 crew cab 4x4 ford, gear shift lever

Ok ready to stand on your head under the dash?
It's doable... there is a flange connected to the gearshift lever under the steering column. If you remove the lower dash cover where the fuses are, you should be able to see it when you move the gear shift lever... look around on the floor of the truck to see if you dropped a star-headed bolt or two... these bolts worked loose on my superduty and made shifting very difficult..it was an easy fix... let me know how you do on it.

Posted on May 10, 2009

dezwez
  • 135 Answers

SOURCE: stuck in gear.hard to change gear ford mondeo 2001

sounds like your duel mass fly wheel has given up common on these
cost a lot to do

Posted on Sep 01, 2009

ghost45
  • 1280 Answers

SOURCE: 2001 Hyundai - reverse gear is inoperative. The

If I understand you correctly, you have ALL forward gears working, but reverse doesn't?... then the problem is in the transmission itself or the linkage on the trans linkage into reverse.

Posted on Oct 18, 2009

  • 1 Answer

SOURCE: Gear lever stiff and does not return to the centre

Hi, Permanant fix, take to garage and get them to replace link shaft on gear change mechanism. Or temp fix, get a tin of WD 40 with the plastic pipe that can be pushed onto the spray nozzle. Get a chopstick or simillar. Put chopstick down side of gear rubber gater. Do this by pulling blue rubber gater away from gear knob and gently inserting chopstick down into gater. Put the WD 40 plastic pipe down gater alongside the chopstick and spray a good amount. then roll the chopstick around to another possition and spray more WD 40. repeat until you have done it four or five possitions covering all round. Job done.

Posted on Aug 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Help needed have a Ldv Maxus, put a new plastic grommet into clutch pedal today as the old one broke, now having trouble getting it into gear unless I pump the pedal Any Idears please.


Sounds like there is now air in the system. If there is a bleed nipple on the slave cylinder, bleed the clutch with new fluid. If not, it is a sealed system and both the master and slave must be replaced as a pair and ensure you follow the instructions otherwise you will get air in the system again.

Jun 01, 2017 | Cars & Trucks

1 Answer

Grand vitara 5 speed manual stiff to change when warm


what is stiff (add a noun here)
blush.....
clutch pedal stiff
shifter lever stiff.
grinds , a bad clutch will make the lever seem stiff or will grind, if forced.
gears balk? same as stiff.
false neutrals. (slips , gear not engaging)

Nov 07, 2016 | Suzuki Grand Vitara Cars & Trucks

1 Answer

Today i bought ldv maxus van 3.5 2005 keeps jumping out 4th gear


will assume a used van
any warranty ? go back to place of purchase

if a manual ..worn syncros or adjustment to shifter cables

if an automatic a shift soleniod or worn drive clutches

26308726-vt3chhdyttrsn1qpus3sq421-4-0.jpg

Oct 12, 2016 | Cars & Trucks

1 Answer

Today i bought a ldv maxus van 3.5 2005 it jumps out 4th gear. I was told it's linkage cables by man I had it off


could be linkages
would need to track the shift cables to the gearbox

if no better worn syncros or automatic shift solenoids

looks like you are going to need a repair manual
ebay has a few



26308725-vt3chhdyttrsn1qpus3sq421-4-0.jpg

Oct 12, 2016 | Cars & Trucks

1 Answer

How to fix 5th gear on my ldv maxus


Its likely you have a problem with the clutchnot completly disengageing or problems with disk or pressure plate

Jun 13, 2013 | 1997 Chevrolet Cargo Van

1 Answer

Error code 0734,at my car LDV MAXUS 2,5! The motor no power


P0734 - Gear 4 Incorrect ratio
Possible causes- Low transmission fluid level
- Dirty transmission fluid
- Shift solenoids
- Transmission mechanical problems
- Transmission hydraulic control circuit problems

Oct 25, 2012 | Cars & Trucks

2 Answers

Help!!! how to reset a LDV Maxus key fob?


Hi
I know from experience that you cannot really re synch these fobs on the LDV Maxus vans.
What actually is the fault is an onboard component on the pcb has failed and we normally just replace that with a new one..the fob will be tested for operation and sent back. OR its the Relay in the ESA unit - under the left hand front glovebox on the bulkhead - black with cables going into it. We have those relays (soldered to the pcb) we can supply those or do the work for you. The fob connects to that ESA and the unit then fires the relays to open/close the doors. Sometimes that unit is installed upside down which causes water (condensation) to enter the box and have fun with your electrics.
The fob is SYNCHED to this unit via coding we can use your old fob to clone to a new fob and that will work with the ESA and the vehicle.
We have the parts on this link Items for sale from remobilise ltd

Here is a link to how to program the fob to the vehicle via the programmer - NOTE how you MUST have a working fob to program another (text at the start of the video... LDV Maxus flv

We can fix most problems on the LDV Maxus that occur with faults to do with the Central locking/fobs/ESA/ETACS - three relays are in the ESA and they control ONLY the central locking - two more relays are in the ETACS unit (behind the ashtray) and they control the fogs and intermittant wipers.

Any help or info needed please contact info@remobilise.co.uk
or tel 01792 896404.

We are based in Swansea UK.

Aug 30, 2012 | Cars & Trucks

1 Answer

Stiff gear lever


sounds like your shift cable is starting to seize to the casing around it..

Feb 02, 2009 | 2007 Honda Accord Sedan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

872 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14398 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...