Question about Ford Expedition

Open Question

Replace carpet How to I replace the passenger area carpet in my '03 Ford Expedition. Do you have to remove all the seats?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
Benimur
  • 6966 Answers

SOURCE: 1999 ford expedition with a passenger, front window stuck in the down possition

Hi,

Initially, try to determine which fuse goes to the power window. Check and replace if necessary.

In brief for a temporary remedy just to have the window closed: remove the triangular cover at the top front of the door behind the mirror, there should be a screw there; remove the trim around the door handle another screw, remove the cover of the courtesy light at the bottom of the door, there is another screw behind that; soon as all the screws are out, lift/push up on the door panel and pull off. This would grant you access to the mechanism controlling the window. You can try closing by manually turning the motor.

Thereafter, pls determine if it is the motor or the switch(es) has failed. Replacements are available here.

Incidentally, here is a nice tutorial on repairs of power windows in general.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.

Posted on May 31, 2008

Ad
mecanica03
  • 902 Answers

SOURCE: remove passenger airbag from 1997 ford expedition

1st , remove glove box , remember to disconnect negative battery terminal before

Posted on Jul 05, 2009

  • 490 Answers

SOURCE: passenger heated/cool seats not working

The seat switch or the heated seat relay is bad.Always check your fuses first.

Posted on Aug 01, 2009

  • 49 Answers

SOURCE: leaking roof under passenger seat

Have you cleaned out the drain tubes? There is a 'rain rail' underneath the rear lip, which diverts water off the top and down to tubes on each side. The tubes get clogged up with leaves and whatnot. You can use a coathanger to CAREFULLY clear the debris. Check out www.miata.net for more Miata information than you could imagine.

Happy Motoring!

chris

Posted on Aug 03, 2009

  • 1779 Answers

SOURCE: Wet carpet

Your drain tube for the air conditioning is plugged up, and instead of draining on the ground, it's leaking on the carpet. You need to go under the car and locate the tube (it's on the passenger side, in front of and below where the front passengers feet would be. You will need a long thin wire to clean out the blockage.

Posted on Aug 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My tail lights and dash lights keep flcking n and off in my 2007 pontiac g5


shorted wiring , usually found under carpet area towards rear passenger area. removal of rear seat required (battery under seat) I have found breaks usually around driver seat mounting ( driver seat removal may also be required to find break/short)

Jan 21, 2014 | Cars & Trucks

1 Answer

Seat belts are locked in 2002 ford expedition


there is a pretensioner in the seat belt buckles that go off when the air bags go off

Jun 12, 2012 | 2002 Ford Expedition

1 Answer

2003 Ford Expedition rear A/C has a knocking sound when setting fan speed or temp.


You need to replace the blend door actuator, a very common problem on the Expys. Remove the passenger side interior panel, between the middle and rear seats. You will also have to unbolt the seatbelt - overall not a hard job. Just remember to have the gears on the new actuator set in the correct position as the one you pulled out or the door will tend to overtravel. ]
There are 2 actuators in that area, just to on the rear air to find out which one is making the problem.
The gears in the actuator are plastic and strip very easily, making the sound. I found a replacement at Advance Auto, but Im sure most parts houses have them.

Feb 13, 2011 | 2003 Ford Expedition

1 Answer

Looking how to lower spare tire on toyota sienna van


Hello. Welcome to FixYa! Please allow us to assist you.

The procedure is as follows, to remove the spare tire from a 2WD Sienna:

Move the passenger seat as far forward as possible.
Move the passenger side middle seat back as far as possible.
Obtain your tire tool (the one you would use to remove the lugnuts)
Observe the carpeting behind the front passenger seat; you will see a small piece of carpet, like a small 'flap', that can be raised.
Under this flap is a small silver 'bolt'. Fit the lug wrench onto this bolt, and rotate it. This will lower the cable that raises the spare tire up under the area between the passenger front and rear seats.

Note: 4WD Siennas do not have any spare tires, as they came with 'run-flat' tires. Toyota did not fit a spare on the 4WD units.

Thanks for choosing FixYa for assistance today.

Jun 10, 2010 | 2008 Toyota Sienna

2 Answers

If I need to replace the blower motor for my 2001 Ford Expedition air conditioner, does the entire dash have to be removed to reach it?


If you are removing the main blower motor at the passenger side of the cabin then you don't have to remove the dash. It's behind the lower dash trim panel and takes about an hour and a half to two hours to do. Not to bad a job but you will need to be a bit flexible to see under there.

Jun 08, 2010 | 2001 Ford Expedition

2 Answers

1999 ford expedition


1999 Expedition

Seats — Third Row
The third row seat is:
  • a three-passenger seat.
  • engaged to the floor by a latch and striker assembly.
  • a quick release seat.
  • equipped with rollers to ease removal and installation.

Dec 17, 2009 | 2002 Ford Expedition

1 Answer

Passenger heated/cool seats not working


The seat switch or the heated seat relay is bad.Always check your fuses first.

Aug 01, 2009 | 2003 Ford Expedition

1 Answer

How do you remove the right rear panel that covers the rear A/C?


fold 2nd row seat fwd, remove rear 3rd seat if equipt.,remove carpet,access screws etc. remove window trims as required,remove panel.....GL...

Jul 04, 2009 | 2004 Ford Expedition

1 Answer

A wire poked through the front passenger seat. I


it's a black enamel coated thick WIRE or a cable/electrical lead?
If it's a strong steel wire in black enamel it is most likely a part of the seat's reinforcement. Are there overweight passengers often sitting in there? Anyways I can't really imagine what tool could cut it nice plain enough -that's not the way! you could miss that "spare" part.
look underneath your seat from the back, use a pocket torch to light it up there. Then look underneath it from the front using a mirror and lighting the spot from the back passenger's footspace with a torch. If you don't have a handy little mirror, borrow one from a woman-they always have one.
you can pull it in from underneath the seat. You might need to remove the upholstery to get proper access though. 
If you're unsure, consider a visit at a Ford shop or an upholstery apecialist.

Apr 11, 2009 | 2000 Ford Expedition

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...