Question about Cars & Trucks
I'm young- VERY YOUNG - and well, i guess, two UGLY boys ( in my opinion ) like me. A LOT. My friends have drama too and won't stop bugging me about it!! I want those two boys to back off - but I'm SHY! I don't want to go up to them and say, Nuh Uh ! What Do I do !?!?! D:
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: My left and right and
The flasher should be under the dash with the fuses it is either round or rectangle and silver, sometimes they are also behind the glove box! The flasher is a cheap part you just have to buy a new one and try it out! Hope this helps! If you have any more questions just ask!
Posted on Jan 24, 2011
SOURCE: My back automatic window went
it may need to be reset.
SECTION 501-11: Glass, Frames and Mechanisms 2001 Explorer Sport/Sport-Trac Workshop Manual
GENERAL PROCEDURES Rear Window Motor Initialization CAUTION: Make sure that no obstructions are present in the power rear window system when carrying out this procedure.
NOTE: This procedure must be carried out when repairs are performed on any part of the power rear window system including when: the power rear window motor is removed from the window regulator drum housing, a new power rear motor is installed, a new power rear window regulator is installed, a new power rear window module is installed, and any operation in which grease or lubricants are applied to the power rear window system.
NOTE: All power rear window components (window glass module, window regulator, window motor, and glass runs) must be installed and torqued to specification before carrying out this procedure.
NOTE: Steps 1-6 must be completed within 30 seconds. The entire procedure must be completed within five minutes.
NOTE: Once the ignition key is turned to the ON position in Step 6, it must remain on until the entire procedure is completed.
NOTE: Steps 7 and 9 require that the power rear window control switch be held in the closed position until the power rear window motor stalls the window in the upper header seal. Step 8 requires that the window control switch be momentarily turned to the open position.
Posted on Sep 15, 2011
Testimonial: "Thank you for your feed back. Will try what you suggested."
Tips for a great answer:
Jan 07, 2017 | Cars & Trucks
Jan 18, 2015 | Cars & Trucks
May 14, 2014 | Mitsubishi Cars & Trucks
Jun 21, 2011 | 1992 Honda Accord
Jan 24, 2011 | Geo Tracker Cars & Trucks
Jul 19, 2010 | 1994 Volvo 960
Jul 29, 2008 | Pontiac Bonneville Cars & Trucks
16 people viewed this question
Usually answered in minutes!