Question about 1992 Opel Frontera 2.3

1 Answer

Wiring Diagrams

Fuel gauge bad earth

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Opel Master
  • 3,261 Answers

Run a new earth wire to the body shell.

Posted on Dec 14, 2013


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Fuel Gauge shows empty after I filled the tank.4 year old Ford Fiesta what can I do and approx cost

It could be anything from the wiring to the gauge, or the sender itself. A common problem is rust causing a bad earth. Check the connections on the tank unit, especially the earth wire, clean and make rust free.

Dec 30, 2016 | Ford Cars & Trucks

1 Answer

I just replaced my fuel pump via bed removal i put it all back together now no sound from fuel pump also noticed gas gauge and oil pressure gauge quit working what can i do to fix this

Go to you tube check out a few videos on automotive electrical testing an trouble shooting , how to read wiring diagrams , voltage drop testing .Then go to free wiring diagrams . Then you test the electrical circuit for fuel system ! You don't say what make , model an year . Fuel Pump Electrical Circuits Description and Operation

Feb 23, 2016 | Cars & Trucks

1 Answer

Needing color coded wiring schematic for junction of fuel pump and fuel level float inside gas tank

They are 2 ways to get this. An internet search using your year make and model car with the term fuel pump wiring or wiring diagram usually pulls up a collage of good diagrams. Or the autozone site has a help site at the bottom of its help page, There is a free part and a pay part, but free info will supply diagrams.

Aug 18, 2015 | 2000 Ford Escort

1 Answer

Need wiring diagram with breakdown of colored wiring on fuel pump motor on 1999 mitsubishi galant ES, 4 cyl

the two thick wires are for the pump and the other two for the fuel gauge ,check for voltage at the pump if no voltage then follow the wires back to see if their is a connection somewhere ,also check the earth connection if no power in the two wires ,ie one probe onto the earth and the other to a suitable ground on the bodywork ,then continuety

Jan 17, 2015 | 1999 Mitsubishi Galant

1 Answer

Free nissan wiring diagrams

You may have to get a manual to find the color codes. But only one cable goes to the fuel gauge sender it travels in the wiring loom to one side of the fuel gauge, and from the other side to the ignition switch.

Aug 16, 2014 | Cars & Trucks

1 Answer

Gas Gauge stuck at full not working

Unplug the wiring to the sender in the tank, if the gauge drops to zero, then the sender is faulty, if it says on full it's the gauge or the wiring to the gauge is shorting to earth.

Jan 21, 2014 | 1997 Chevrolet Tahoe

1 Answer

Citroen xsara fuel gauge

Your most likely fault / problem, is with the fuel gauge sender unit being faulty - which is in the tank..

Its rare that gauges fail - but its worth checking... Access the fuel tank where the fuel pump fits in under the rear seats (i think) and remove the wire for the gauge, this is the smallest wire on the unit.

Earth that wire (ground), with the ignition on... make sure its a good earth - and the gauge should be seen to rise right to the top... if that happens - it proves the wiring and gauge are ok.. if not - then there is a problem with the wiring or gauge - most likely the latter which would need investigating.

Its usually the sender unit though as I say - 99.9 % of the time.

Hope this helps; also keep in mind that your feedback is important and I'll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using Fixya, and have a nice day.

Nov 04, 2011 | Cars & Trucks

1 Answer

I need help with wiring the fuel gauge on the speedometer assembly for my 1975 jeep CJ7

feed from ballast resistor to gauge then on to tank sensor and it earths back through the tank ,its metal on these real good old motors ,make sure the earth is good to the tank though

Mar 18, 2010 | Jeep Comanche Cars & Trucks

1 Answer

Fuel gauge stays above the full mark when the

its not a short in the wireing its a very bad earth check for bad earths

Oct 30, 2009 | Chevrolet Impala Cars & Trucks

1 Answer

Wiring diagrams

Jul 11, 2009 | 1986 Toyota Pickup 4WD

Not finding what you are looking for?
1992 Opel Frontera 2.3 Logo

Related Topics:

112 people viewed this question

Ask a Question

Usually answered in minutes!

Top Opel Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Brad Brown

Level 3 Expert

16147 Answers

george parkes

Level 3 Expert

975 Answers

Are you an Opel Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides