Question about Mercury Cars & Trucks

Open Question

Cooling fan relay switch located

Where is the fan motor on a 1998 mercury topaz 2.0

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 76 Answers

SOURCE: cooling fan relay 1998 neon

on the left(driver's) side of the lower rad support. It's a small flat relay with a plug on the bottom and usually has a blue colored front. held on by two screws. Also, there may be more rad fan relays in the underhood fuse/relay box.
Good luck.
R

Posted on Feb 27, 2009

Ad
  • 28 Answers

SOURCE: Radiator fan will not run but motor is good

On the drivers side in front of the battery there's a black box i think it says fuse turn counter clockwise the black star looking thing on top of the box when it is loose remove cover there should be two relays one is for the fan and other for ac the inside of cover should identify everything fuses etc. You could try turning on AC that should turn on radiator fan.

Posted on Apr 03, 2009

mcgyver468
  • 710 Answers

SOURCE: Trying to locate cooling fan relay switch?

Driver's side in the fuse/relay box under the hood.

Posted on Apr 25, 2009

canbruce75
  • 1776 Answers

SOURCE: Where are the cooling fan relays for a 1998

Are you sure that you don't mean the cooling fan control module? It should be located up front next to the cooling fan. It is square shaped and has a long square shaped plug going into it. 00114_cooling_fan_control.jpgReads the temperature of the coolant and passes the information to the engine control computer (ECC). The ECC receives analog information and signals the cooling fan switch to cycle the cooling fan on or off, as required.








Posted on Jul 08, 2009

  • 1 Answer

SOURCE: need to find circuit/relay location for cooling fan. fuse is good, fan motor tested fine. need wiring schematic

where is the cooling fan relay located on a 92 taurus

Posted on Dec 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Cooling fan relay location


should be right on the fan,fan schroud, or in that area.check u r owners manuel if u hav 1.

Apr 21, 2013 | 1988 Mercury Topaz 2 Door

2 Answers

Where is the fuel pump relay switch located on a 1993 mercury topaz 4 cylinder


Your vehicle has one fuel pump,here's how to replace.The fuel pump relay is intergrated into the CCRM .The Constant Control Relay Module (CCRM) is located in the LH side of the engine compartment, near the strut tower. Here's what it look looks like

Feb 17, 2013 | 1993 Mercury Topaz

1 Answer

Where is the fusible link for the cooling fan on a 93 Mercury Topaz?


I can supply only general information. There are actually three fusible links: a 20GA DK BLU (YEL wire), a 20GA BLU (RED/LT GRN wire), and a 14GA DK GRN (YEL wire). All three wires connect to the constant control relay module which has a RED output wire connected to the powertrain control module (PCM), a BLK/LT GRN wire connected to ground, two DK BLU wires connected to the electric cooling fan, a TAN/ORG wire connected to the PCM, a LT GRN/PPL wire connected to the fan, and a LT BLU wire connected to the PCM. Sorry for the roundabout description but it's all the information I have

Oct 07, 2012 | Mercury Topaz Cars & Trucks

1 Answer

Why doesnt the cooling fan come on on my 1993 mercury topaz


You just asked about the one circuit that gives this backyard mechanic nightmares(lol).There is a relay to turn fan on, but whether it is controlled by a simple temperature sensor/switch on the engine, or by your ecu (engine's computer) I don't know.
Until you get a definitive answer from one of our experts here, there is a simple test you can do to make sure fan motor is good. Unplug the connector for motor and check for corrosion in the terminals of the connector. Plug it back in. Look on the thermostat housing or just adjacent to it, for a single wire connector. This is the fan sensor/switch. Unplug it and turn key to on. Fan should start. Be careful of fan blades when key is on: It MAY come on any time key is on. If it doen't come on it may be a bad sensor in the switch-supposed to build resistance as coolant temp. increases, then at certain temp. will turn fan on.
So, fan on? Replace that switch you disconnected. Or, still no fan? Plug sensor back in. Turn key off. Unplug the fan motor again, and use jumper wires from battery to fan terminal connector, just long enough to verify if fan works or not. If fan motor is good, there is a problem with the temp. sensor, or the relay (probably located in fuse box by battery), or the associated wiring, or the computer (IF your fan is controlled by the computer). Then you have just inherited my nightmare. But if fan does not work, you have found the problem. Good luck.

Nov 11, 2011 | 1993 Mercury Topaz

2 Answers

Overheats raditor cleaned and flushed no power to fan 94 mercury


try the fan tempature sending unit. it tells the fan to come on at certain tempature if it went bad it wont tell the fan to come on

Jul 11, 2010 | 1994 Mercury Topaz

1 Answer

Where do you find the relay for the cooling fan on a 1990 mercury topaz


HI. This relay is very hard to locate. It is located just to the left of the battery ,as you are looking face down at it. It will be tucked up against the left radiator support, near the headlight. look in between the battery and the radiator and you should see it there.



Jul 04, 2010 | 1990 Mercury Topaz

2 Answers

198 mercury sable cooling fans motor


Cooling fans ( on radiator ) only come on when the engine reaches a certain (hot) temprature. There is a temp sensor threaded into the radiator end reservoir that switches a relay off and on that runs the fans. Either the temp sensor or the relay is probably bad. Normally , those fans will not be on if the car is moving , the air flow from just driving is sufficient to cool the rad. If you stopped and idled for a while , eventually the rad would heat up enough for the fans to come on.

Mar 31, 2010 | 1998 Mercury Sable

1 Answer

FUZE BOX DIAGRAM FOR 1990 MERCURY TOPAZ


Replacement
  1. Access the fuse panel from the left of the steering column.
  2. Locate the blown fuse and pull out. DO NOT TWIST.
  3. Take note of the ampre number written on the top of the fuse. To install:
  4. Push a new fuse of the same ampre into the receptacle, making sure the contact is being made on both sides of the fuse.
LOCATIONS Headlights and Highbeam Indicator
  • One 18 amp circuit breaker (22 amp in 1987 vehicles) incorporated in the lighting switch.
Front and Rear Marker, Side Parking, Rear and License Lamps
  • One 15 amp circuit breaker incorporated in the lighting switch.
Windshield Wiper
  • One 4 1⁄2 amp circuit breaker located in the windshield wiper switch.
Power Windows
  • Two 20 amp circuit breakers located in the starter relay and the fuse block.
Power Seats and Power Door Locks
  • One 20 amp circuit breaker located in the fuse block.
Hazard Flasher REMOVAL & INSTALLATION NOTE: The hazard warning flasher is located on the rear side of the fuse panel.
  1. Locate the hazard flasher in the fuse panel.
  2. Pull the flasher out. DO NOT TWIST. To install:
  3. Push new flasher into place making sure a good contact is made with both terminals.
  4. Test flasher to make sure they function properly.
Various Relays LOCATION Cooling Fan Controller
  • Located behind the left side of the instrument panel.
Cooling Fan Controller Module
  • Located behind the right side of the instrument panel.
Cooling Fan Relay
  • Located in the air conditioning cooling fan control module.
Electronic Control Assembly
  • Located under the left side of the instrument panel.
Electronic Engine Control Power Relay
  • Located behind the glove box on the right side of the instrument panel.
Fuel Pump Relay
  • Located behind the glove box.
Horn Relay
  • Located in the fuse block.
Fig. 1: Main fuse box located on driver's side to the left of the steering wheel, above the brake pedal

e55ee77.jpg
This is the best info I could find....I hope this helps ya!

Jul 23, 2009 | Mercury Topaz Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

76051 Answers

fordexpert

Level 3 Expert

5516 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...