Question about Cars & Trucks

Open Question

Mitsubishi l200 diesel. Reverse lights do not work . Replaced bulbs. And reverse switch on gearbox but still no luck is there a fuse for these?

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Alcatrazx
  • 65 Answers

SOURCE: Volvo 240 reverse lights don't work

Hi Sir

Checked the switch and plug? here's how :)

Yes it is the reverse light switch which is hooked up to your gearbox which needs to be replaced. Also it could be the plug going into this switch is a bit dirty or thorn (due to engine temperature and time wear) which in that case means that it needs to be fixed before replacing the switch.

Checking its actually the swtich so you don't buy it for nothing :)

Just to make sure that the circuitry is ok. Go to the gearbox (if it is front wheel drive transverse engine you wont need to go underneath) check where the gearbox and linkages are close to the revers there should be a switch n plug hooked up to it. Unplug it put in a piece of wire to short circuit both wires. Then turn the ignnition key on and if your circuitry is fine the lights should go on :) This means that its the switch for sure :) I hope that this helped your problem :)

CHEERS

Posted on Jan 07, 2009

ilragatzzo78
  • 241 Answers

SOURCE: mercedes a class reverse light fault

the switch has been installed incorrectly or you got a defective switch.
also look at the connector of the switch, i fixed one no long ago where they plug the switch first and then they turn it to screw it in, that cracked the wires and were touching making the lights to stay on, i had to make a new wiring for the connector to fix the problem.
i do not thing you have a problem with your transmission at all

Posted on Jan 08, 2009

  • 1986 Answers

SOURCE: 2005 Pathfinder no reverse lights

On the side of your transmission will be a switch with several wires coming out of it. This is your reverse switch that turns on your reverse lights and most likely needs to be replaced

Posted on Oct 01, 2009

  • 1986 Answers

SOURCE: Reversing lights don't work.

On the side of your transmission will be a switch with several wires coming out of it. This is your reverse switch that turns on your reverse lights and most likely needs to be replaced

Posted on Oct 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Reverse lights not working mercedes w202


check switch wire on gearbox, can fall off? or fuse, and bulbs, I have had 2 bulbs go at once? so could be as simple as changing the bulbs

Sep 02, 2014 | Cars & Trucks

Tip

Indicator fuse blow Mitsubishi L300 wagon


Fuse blowing on Mitsubishi L300 2.4l motor, manual gearbox. Fuse 15, indicators, fuel guage, tacho. Found to be short in reversing light switch in gearbox. Initial disconnect of switch stopped fuse blowing, renew switch restored reverse lights

on May 29, 2014 | Cars & Trucks

1 Answer

My reverse lights are not working in my 97 vr4 galant


Hi there, I am not a mechanic, but there should be a switch by your gearbox close to where you put it in reverse that closes the circuit for the lights to burn when you put it in reverse. Hope it helps.

Aug 07, 2012 | 1996 Mitsubishi Galant

1 Answer

Reverse light does not work, checked bulbs and fuse and they look good, any suggestions?? 2001 ford focus sedan.. thanks


If the bulb and the fuse are good, (the fuse will affect other circuits as well, not only the reverse lights), your next stop is the reverse light switch. It is located on the gearbox and is a switch with two wires coming from it. Remove the wires and touch them together and see if the reverse light comes on with the ignition on. If they do, you need to replace the switch.

Mar 29, 2011 | 2001 Ford Focus

1 Answer

My reverse lights aren't working on mitsubishi L200 why


You have the reverse switch on the gear box, thry to find it and see if it's ok, but before that first check ligtbubs, than fuse and than thry to finde the gearbox switch.

Feb 25, 2011 | 1997 Mitsubishi Eclipse

1 Answer

When i switch the gear on reverse the reverse lights are off. either when i indicate to turn the indicators lights are just off. can you assist me please


First check the bulbs, than the fuse box, if this does not help it will be the reverse light switch (sensor)on the gearbox, and with indicators, try to put hazards and see what happens, if they work, than the relay for indicators might need to be replaced, if they don't than also the relay must be replaced, if the relay is not the problem than it will be the main column switch

Jul 17, 2009 | 1995 Mazda MX-6

1 Answer

Reversing lights don't work.


On the side of your transmission will be a switch with several wires coming out of it. This is your reverse switch that turns on your reverse lights and most likely needs to be replaced

Mar 24, 2009 | 2000 Toyota Camry

1 Answer

Volvo 240 reverse lights don't work


Hi Sir

Checked the switch and plug? here's how :)

Yes it is the reverse light switch which is hooked up to your gearbox which needs to be replaced. Also it could be the plug going into this switch is a bit dirty or thorn (due to engine temperature and time wear) which in that case means that it needs to be fixed before replacing the switch.

Checking its actually the swtich so you don't buy it for nothing :)

Just to make sure that the circuitry is ok. Go to the gearbox (if it is front wheel drive transverse engine you wont need to go underneath) check where the gearbox and linkages are close to the revers there should be a switch n plug hooked up to it. Unplug it put in a piece of wire to short circuit both wires. Then turn the ignnition key on and if your circuitry is fine the lights should go on :) This means that its the switch for sure :) I hope that this helped your problem :)

CHEERS

Jan 07, 2009 | 1988 Volvo 240

1 Answer

1994 Plymouth Sundance reverse lights


first check bulbs and fuses if no success the reverse light switch is located on gearbox sometimes wires come off and other times faulty and need replacing a test lamp on the switch will help to tell you whether or not power is coming out when in reverse to make the lights work

Nov 08, 2008 | 1994 Plymouth Sundance

1 Answer

My reversing lights dont work how do I change the bulb? Its a Mitsubishi L200


Remove the screws that attach the lense to the truck. Twist the bulb hold from the backside and remove the bulb. Installation is the reverse.

Jun 11, 2008 | 1988 Mitsubishi Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

437 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...